Gebruiksaanwijzing /service van het product CS150U48V3 van de fabrikant CyberPower
Ga naar pagina of 18
CS150U48V3 Installation & Operation Manual K01-1504801-00.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 1 of 17 TABLE OF CONTENTS 1 Product introduction .............................................................................................................. 3 1.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 2 of 17 TABLE OF TABLES Table 1: Battery Heater Specifications .............................................................................................. 11 Table 2: Block Diagram Descriptions .
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 3 of 17 1 PRODUCT INTRODUCTION 1.1 General Description The CS150U48V3 battery backup unit is designed to serve up to two MDU ONTs (Optical Network Terminal for Multi-Dwelling Use) and can be installed indoors or outdoors.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 4 of 17 2.2 Battery Warnings • Danger of explosion if battery is incorrectly connected or replaced. • Worn-out or damaged batteries are considered environmentally unsafe.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 5 of 17 2.4 FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 6 of 17 Figure 1: Dimensions (Front View) Figure 2: Dimensions (Side View) 3 DIMENSIONS 17.14 inch (435.4 mm) 7.09 inch (180.1 mm) 5.79 inch (147.1 mm) 15.75 inch (400.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 7 of 17 Figure 3: Unit Overview (Front) Figure 4: Unit Overview (Rear) Figure 5: Unit Overview (Side) Figure 6: Unit Overview (Bottom) 4 INSTALLATION 4.1 Overview 1.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 8 of 17 4.2 Unpacking Inspect the Battery Backup Unit upon receipt.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 9 of 17 4.4 Installation 4.4.1 Wall Mounting the UPS 1. Remove the UPS from the carton.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 10 of 17 Figure 10: Battery Wiring Secure harness with cable ties Battery Type The battery is a standard sealed lead acid battery rated at 12Vdc / 7.2 (7) Ah. When required, the battery may be replaced with an approved 12Vdc / 7.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 11 of 17 4.7 Connecting to Power Source 4.7.1 Installing the Power Cord 1. Remove the 4 terminal strip cover screws (upper left hand corner) 2. Remove any convenient 3/4” knock-out of the UPS enclosure.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 12 of 17 Wire Gauge (AWG) Wire Type Tightening Torque (lb-in) Minimum temperature rating of conductors Copper conductors 7 75°C 10-18 AWG Copper Conductors Table 3: AC Line Cord Table 4: Conduit Wires 4.
4.8 ONT Alarm Connections 1. Route the 7-wire cable back from the ONT enclosure to the UPS. 2. Remove any convenient 3/4” knock-out of the UPS enclosure. 3. Install a strain relief in the knock-out hole. 4. Route the power cable up through the strain relief.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 14 of 17 Table 5: Controls and LED Indicators Indicator Alarm Silence Button Cold Start Button AC/DC Mode LED .
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 15 of 17 Table 6: Alarms 5.3 Alarms There are audible and visual alarm signals to alert the customer to abnormal and/or service affecting conditions present in the UPS.
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 16 of 17 Table 7: Specifications 6 SPECIFICATIONS Model Number CS150U48V3 Input: Rating V oltage/Frequency 100 - 240V / 50 - 60Hz Input V oltage Range 90 - 264V ac Frequency Range 47 - 63Hz P .
© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners. Page: 17 of 17 APPENDIX I - Wall Mount Chart Recommended Screw Dimensions M8 x 25L or 3/8” x 1”L 7.
Een belangrijk punt na aankoop van elk apparaat CyberPower CS150U48V3 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen CyberPower CS150U48V3 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens CyberPower CS150U48V3 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding CyberPower CS150U48V3 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over CyberPower CS150U48V3 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van CyberPower CS150U48V3 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de CyberPower CS150U48V3 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met CyberPower CS150U48V3 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
