Gebruiksaanwijzing /service van het product 3340 van de fabrikant Dell
Ga naar pagina of 51
Dell Latitude 3340 Owner's Manual Regulatory Model: P47G Regulatory Type: P47G001.
Notes, Cautions, and Warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
Contents 1 Working on Your Computer................................................................................ 5 Before Working Inside Your Computer ................................................................................................ 5 Turning Off Your Computer .
Removing the Display Assembly ........................................................................................................26 Installing the Display Assembly ..................................................................................
1 Working on Your Computer Before Working Inside Your Computer Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your personal safety.
CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device. 4. Disconnect all network cables from the computer. 5. Disconnect your computer and all attached devices from their electrical outlets.
1. Click Start . 2. Click Shut Down. or 1. Click Start . 2. Click the arrow in the lower-right corner of the Start menu as shown below, and then click Shut Down .
2 Removing and Installing Components This section provides detailed information on how to remove or install the components from your computer. Recommended Tools The procedures in this document may req.
Figure 2. Features 1. microphones 2. camera 3. camera-status light 4. security cable slot 5. power button 6. USB 3.0 connector 7. status lights 8. audio connector 9.
14. mini DisplayPort connector 15. HDMI connector 16. air vents 17. network connector 18. power connector Figure 3. Inside view — Back 1. power connector 2. system fan 3. heatsink 4. speaker 5. memory module 6. hard drive 7. audio-connector board 8.
Removing the Battery 1. Follow the procedures in Before Working On Your Computer . 2. Slide the release latches to unlock position and pull the battery to remove from the computer. Installing the Battery 1. Insert the battery into its slot until the battery clicks into place.
Installing the SIM Card 1. Insert the SIM card into its slot on the computer and press until it clicks in place. 2. Install the battery. 3. Follow the procedures in After Working Inside Your Computer . Removing the Base Cover 1. Follow the procedures in Before Working On Your Computer .
Installing the Base Cover 1. Align the edges of the base cover on the computer and press it on the computer until it snaps in place. 2. Tighten the screws to secure the base cover to the computer. 3. Install the battery. 4. Follow the procedures in After Working Inside Your Computer .
Installing the Memory 1. Insert the memory module into the memory socket and press until the memory module click in to place. 2. Install the: a. base cover b. battery 3. Follow the procedures in After Working Inside Your Computer . Removing the Keyboard Trim 1.
Installing the Keyboard Trim 1. Align the keyboard trim to its place. 2. Press along the sides of the keyboard trim until it snaps in place. 3. Follow the procedures in After Working Inside Your Computer . NOTE: You may also need to press the center of the keyboard trim to secure the keyboard trim in its place.
4. Slide down [1] and lift up [2] the keyboard from the computer to access the keyboard cable. 5. Flip the keyboard, disconnect the keyboard cable from its connector, and remove the keyboard from the computer.
Installing the Keyboard 1. Connect the keyboard cable to its connector on the computer. 2. Flip the keyboard and install the keyboard in its place. 3. Tighten the screws to secure the keyboard to the computer. 4. Install the: a. keyboard trim b. battery 5.
Installing the Coin-Cell Battery 1. Connect the coin-cell battery cable to the system board. 2. Attach the coin-cell battery to the adhesive on the system board. 3. Install the: a. base cover b. battery 4. Follow the procedures in After Working Inside Your Computer .
Installing the Audio-Connector Board 1. Place the audio-connector board in its slot on the computer. 2. Tighten the screw to secure the audio-connector board to the computer. 3. Connect the audio-connector board cable to the system board. 4. Install the: a.
b. battery 5. Follow the procedures in After Working Inside Your Computer . Removing the Speakers 1. Follow the procedures in Before Working on Your Computer . 2. Remove the: a. battery b. base cover 3. Disconnect the speaker cable from the system board [1].
Installing the Speakers 1. Replace the speakers in its place and route the cable through the channels. 2. Press down on the speakers until the tabs on the speakers snap onto the holders on the computer. 3. Connect the speaker cable to the system board.
4. Perform the following steps to remove the WLAN card: a. Disconnect the antenna cables from the WLAN card. b. Remove the screw that secures the WLAN card to the computer. c. Remove the WLAN card from the computer. Installing the WLAN Card 1. Insert the WLAN card into its connector on the computer.
4. Perform the following steps to remove the WWAN card: a. Disconnect the antenna cables from the WWAN card. b. Remove the screw that secures the WWAN card to the computer. c. Remove the WWAN card from the computer. Installing the WWAN Card 1. Insert the WWAN card into its connector on the computer.
c. Remove the screws that secure the system fan to the computer. Lift the system fan away from the computer. Installing the System Fan 1. Perform the following steps to install the system fan: a. Place the system fan in its slot on the computer. b. Connect the system-fan cable and power cable to the system board.
b. base cover 3. Follow the procedures in After Working Inside Your Computer . Removing the Heatsink 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove the: a. battery b. base cover c. system fan 3. Un-route the WLAN antenna cables from their channels on the system board.
Installing the Heatsink 1. Place the heatsink on the computer. 2. Tighten the captive screws to secure the heatsink to the system board. 3. Route the WLAN antenna cables along their channels on the system board. 4. Install the: a. system fan b. base cover c.
4. Perform the following steps: a. Disconnect the touch panel, network connector, and display cables. b. Remove the screws that secure the display hinges to the palmrest assembly. c. Lift the palmrest assembly away from the display assembly. CAUTION: Lift the palmrest assembly slowly to avoid damaging the display assembly.
Installing the Display Assembly 1. Align the palmrest assembly on the display assembly. 2. Tighten the screws to secure the display hinges to the palmrest assembly. 3. Connect the following cables: a. touch panel b. network connector c. display 4. Align the bracket over the display cable and tighten the screw to secure the bracket to the computer.
i. audio-connector board j. hard drive k. WLAN card l. WWAN card m. system fan n. heatsink 3. Disconnect the following cables from the system board: a. touchpad b. audio connector c. speaker d. touch panel e. network connector f. display-cable bracket and display g.
5. Lift and remove the system board from the chassis. Installing the System Board 1. Replace the system board on the chassis. 2. Tighten the screws to secure the system board to the chassis. 3. Connect the following cables to their connectors on the system board: a.
f. audio connector g. touchpad 4. Install the: a. heatsink b. system fan c. WWAN card d. WLAN card e. hard drive f. audio-connector board g. coin-cell battery h. keyboard i. keyboard trim j. memory modules k. base cover l. SIM card m. battery n. SD card 5.
3 System Setup System Setup enables you to manage your computer hardware and specify BIOS ‐ level options. From the System Setup, you can: • Change the NVRAM settings after you add or remove hardw.
Table 1. Navigation Keys Keys Navigation Up arrow Moves to the previous field. Down arrow Moves to the next field. <Enter> Allows you to select a value in the selected field (if applicable) or follow the link in the field. Spacebar Expands or collapses a drop ‐ down list, if applicable.
Option Description Date/Time Allows you to set the date and time. Table 3. System Configuration Option Description Integrated NIC Allows you to configure the integrated network controller. The options are: • Disabled • Enabled • Enabled w/PXE (Default Setting) • Enabled UEFI Network Stack NOTE: This option is disabled by default.
Option Description Default Setting: All the options are enabled. USB PowerShare Allows you to configure the behavior of the USB PowerShare feature. The option is disabled by default. • Enable USB PowerShare Audio Allows you to enable or disable the integrated audio controller.
Option Description Default Setting: Not set System Password Allows you to set, change or delete the system password. NOTE: Successful password changes take effect immediately. Default Setting: Not set Internal HDD-0 Password Allows you to set, change, or delete the administrator (admin) password.
Table 6. Secure Boot Option Description Secure Boot Enable Allows you to enable or disable the secure boot. The options are: • Disabled • Enabled (Default Setting) Expert Key Management Allows you to manipulate the security key databases only if the system is in Custom Mode.
Option Description • 2 Intel SpeedStep Allows you to enable or disable the Intel SpeedStep feature. Default Setting: Enable Intel SpeedStep C States Control Allows you to enable or disable the additional processor sleep states. Default Setting: Enable C states .
Option Description Wireless Radio Control Allows you to control the WLAN and WWAN radio. The options are: • Control WLAN radio • Control WWAN radio Default Setting: both the options are disabled. Wake on LAN/WLAN This option allows the computer to power up from the off state when triggered by a special LAN signal.
Option Description • Fn Key Only (Default Setting) • By Numlock Numlock Enable Allows you to enable the Numlock when system boots. The option is enabled by default. Fn Key Emulation Allows you to match the <Scroll Lock> key feature of PS-2 keyboard with the <Fn> key feature in an internal keyboard.
Option Description NOTE: For Windows 8.1 Operating System, the Wireless Switch option is directly controlled by the OS driver. So, this setting here does not affect the Wireless Switch Behavior . Wireless Device Enable Allows you to enable or disable the internal wireless devices.
NOTE: If you cannot find your Service Tag, click Detect My Product . Proceed with the instructions on screen. 4. If you are unable to locate or find the Service Tag, click the Product Category of your computer. 5. Choose the Product Type from the list.
Use the following guidelines to assign the system password: • A password can have up to 32 characters. • The password can contain the numbers 0 through 9. • Only lower case letters are valid, upper case letters are not allowed. • Only the following special characters are allowed: space, (”), (+), (,), (-), (.
4 Diagnostics If you experience a problem with your computer, run the ePSA diagnostics before contacting Dell for technical assistance. The purpose of running diagnostics is to test your computer's hardware without requiring additional equipment or risking data loss.
Device Status Lights Icon Description Turns on when you turn on the computer and blinks when the computer is in a power management mode. Turns on when the computer reads or writes data. Turns on steadily or blinks to indicate battery charge status. Turns on when wireless networking is enabled.
5 Technical Specifications NOTE: Offerings may vary by region. The following specifications are only those required by law to ship with your computer. For more information about the configuration of your computer, go to Help and Support in your Windows operating system and select the option to view information about your computer.
Audio External Microphone-in/stereo headphones combo connector Speakers Two (2W per channel) Internal speaker amplifier Two (2W per channel) Volume controls Software program menus, media controls, and.
Display Size 13.30 inches Active area (X/Y) • Non-Touch – 330.90 mm x 243.20 mm (13.03 inches x 9.57 inches) • Touch – 330.90 mm x 243.47 (13.03 inches x 9.58 inches) Dimensions: Height • Non-Touch – 243.20 mm (9.57 inches) • Touch – 243.
Battery • 6-cell lithium ion (3.0 AHr) (65Whr) Dimensions: Depth: 4-cell and 6-cell 228.30 mm (8.99 inches) Height: 4-cell 22.70 mm (0.89 inch) 6-cell 33.95 mm (1.34 inches) Width: 4-cell and 6-cell 49.15 mm (1.94 inches) Weight: 4-cell 259.00 g (0.
AC Adapter Type 65W 65W BFR/PVC free 90W (India only) Operating 0 °C to 40 °C (32 °F to 104 °F) Non Operating –40 °C to 70 °C (–40 °F to 158 °F) Physical Height (with a WLED panel) 22.70 mm to 35.90 mm (0.89 inch to 1.41 inches) Width 330.
6 Contacting Dell NOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill, or Dell product catalog. Dell provides several online and telephone-based support and service options.
Een belangrijk punt na aankoop van elk apparaat Dell 3340 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Dell 3340 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Dell 3340 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Dell 3340 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Dell 3340 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Dell 3340 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Dell 3340 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Dell 3340 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
