Gebruiksaanwijzing /service van het product CSDPBN van de fabrikant Desa
Ga naar pagina of 42
NA TURAL GAS BURNER SYSTEM MODEL SDVBNC WITH PROP ANE/LP GAS BURNER SYSTEM CONVERSION KIT REMOTE READY FOR YOUR SAFETY WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch • Do not use any phone in your building.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 2 SAFETY INFORMA TION IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, operate, or service this stove and burner system.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 3 3 SAFETY INFORMA TION Continued PRODUCT IDENTIFICA TION Figure 1 - Comfort Glow Direct-Vent Burner System Shown Installed in Approved Comfort Glow Cast Iron Stove Body (Models CSDBN and CSDPBN) 6.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 4 LOCATION AND SPACE REQUIREMENTS Determine the safest and most efficient location for your cast iron stove. Make sure that rafters and wall studs are not in the way of the venting system.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 5 5 6 " (15.24 cm) 4 " (10.16 c m Front 4" (10.16 cm) from Front Ceiling Floor from Back Wall 29" (73.66 cm) 42" (106.68 cm) 36" (91.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 6 STOVE AND BURNER SYSTEM ASSEMBL Y Continued STOVE AND BURNER SYSTEM ASSEMBLY Removing/Replacing G.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 7 7 STOVE AND BURNER SYSTEM ASSEMBL Y Continued 4. Thermostat Blower Onl y: Attach thermal switch and bracket to inside rear cover wall with two hex head screws provided as shown in Figure 10.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 8 7. Remove original pilot orifice using needlenose pliers or fin- gertip s. Replace with the pilot orifice supplied with conversion kit. Note: The new pilo t o rifice has 014 LP stamped on it f or identification purposes (see Figur e 15) .
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 9 9 STOVE AND BURNER SYSTEM ASSEMBL Y Continued Thermocouple Thermopile Pilot Target Figure 16 - Pilot Target Alignment Gas Control Valve Conversion If your burner system is natural gas, do not install conversion kit.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 10 TPTH TPTH TP TP TH TH LOCATION OF VENT TERMINATION When locating vent termination, it is important to observe the minimum clearances shown in Figure 23, page 11.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 11 11 Fixed Closed Openable Fixed Closed Openable V V V V V V V V X X V X G G J F B B K N H I A N E.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 12 WARNING: Read all instructions completely and thoroughly before attempting installation. Failure to do so could result in serious injury, property damage or loss of life.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 13 13 INSTALLATION FOR HORIZONTAL TERMINATION Snorkel terminations are available for terminations requiring a vertical rise on the exterior of the building (see Figures 24 and 25).
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 14 VENTING INST ALLA TION Continued Figure 28 - Installing Horizontal Vent Cap (Noncombustible Exterior) WARNING: Do not recess vent termination in to any wall.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 15 15 Figure 33 - Horizontal Termination Configuration for Venting Using Two 90 ° Elbows with Term.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 16 1. Determine the route your vertical venting will take. If ceiling joists, roof rafters, or other framing will obstruct the venting system, consider an offset (see Figure 34) to avoid cutting load bearing members.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 17 17 Vertical Termination Configurations Figure 38 through 41 show four different configurations for vertical termination.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 18 Figure 40 - Vertical Venting Configuration Using Two 90 ° Elbows VENTING INST ALLA TION Continued Figure 39 - Vertical Venting Configuration Using Two 90 ° Elbows with Two Horizontal Runs Note: Install restrictor into 4" (10.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 19 19 VENTING INST ALLA TION Continued HIGH ALTITUDE INSTALLATION Your cast iron stove and direct-vent burner system has been CSA tested and approved for operation at altitudes in the USA from 0- 2000 ft.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 20 CAUTION: Use only new, black iron or steel pipe. Internally-tinned copper tubing may be used in cer- tain areas. Check your local codes. Use pipe of 1/2" (12.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 21 21 WARNING: Use pipe joint sealant that is resistant to liquid petroleum (LP) gas. We recommend that you install a sediment trap/drip leg in supply line as shown in Figure 43, page 20.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 22 TPTH TPTH TP TP TH TH Figure 48 - Control Valve Terminals To Control Switch or Optional Accessory INSTALLING OPTIONAL WALL MOUNT SWITCH - GWMS2 1. Connect one terminal of 25 ft.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 23 23 STOVE AND BURNER SYSTEM INST ALLA TION Continued INSTALLING OPTIONAL WALL MOUNTED THERMOSTAT - GWMT1 WARNING: Installation must be done by a qualified installer familiar with low voltage wiring procedures.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 24 It is very important to install these logs exactly as instructed in Figures 55 through 58. Do not modify logs. Only use logs supplied with freestanding burner system.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 25 25 STOVE AND BURNER SYSTEM INST ALLA TION Continued 3 4 Figure 57 - Installing Log No. 3 Figure 58 - Installing Log No. 4 WARNING: The glass door must be securely in place before running this burner system.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 26 OPTIONAL HAND-HELD REMOTE OPERATION Figure 61 - Setting the Selector Switch, Gas Control Knob, a.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 27 27 OPERA TING STOVE WITH BURNER SYSTEM Continued OPERATING STOVE AND BURNER SYSTEM Optional Hand-Held Remote Operation (Cont.) ON/OFF SERIES (MODEL GHRCB) Hold the control button on the hand-held remote until burner turns on.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 28 INSPECTING BURNERS Check pilot flame pattern and burner flame patterns often. PILOT ASSEMBLY The pilot assembly is factory preset for the proper flame height.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 29 29 CLEANING AND MAINTENANCE WARNING: Turn off burner system and let cool before cleaning. CAUTION: You must keep control areas, burners, and circulating air passageways of burner system and stove clean.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 30 TROUBLESHOOTING Note: All troubleshooting items are listed in order of operation. WARNING: Turn off burner system and let cool before servicing. Only a qualified service person should ser- vice and repair burner system or stove.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 31 31 OBSERVED PROBLEM Burner does not light after pilot is lit Delayed ignition burner Burner back.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 32 TROUBLESHOOTING Continued WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 33 33 WIRING DIAGRAM CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 34 TPTH TPTH TP TP TH TH 24 4 19 20 21 23 26-1 26-4 26-2 26-3 18 24 4 25 4 1 28 28 4 7 8 9 10 11 13.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 35 35 P ARTS LIST MODEL SDVBNC This list contains replaceable parts used in your burner system. When ordering parts, follow the instructions listed under Replace- ment Parts on page 33 of this manual.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 36 ILLUSTRA TED P AR TS BREAKDOWN STOVE CHASSIS MODELS CSDBN AND CSDPBN ILLUSTRATED PARTS BREAKDOWN.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 37 37 P ARTS LIST STOVE CHASSIS This list contains replaceable parts used in your stove. When ordering parts, follow the instructions listed under Replacement Parts on page 33 of this manual.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 38 ACCESSORIES Purchase these stove and burner system accessories from your local dealer. If they can not supply these accessories, call DESA's Sales Department at 1-866-672-6040 for information.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 39 39 1. Where will the product be used? ❍ Living/F amily Room ❍ Office/W arehouse ❍ Utility Shed/Outbuilding ❍ Garage ❍ Bedroom ❍ Bathroom ❍ Other 2.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 40 2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004 Postage Required T APE T APE.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 41 41 NOTES _______________________________________________________________________________________.
111739-01A For more information, visit www.desatech.com For more information, visit www.desatech.com 42 W ARRANTY INFORMA TION DESA LIMITED WARRANTY DIRECT-VENT BURNER SYSTEM AND STOVE CHASSIS DESA wa.
Een belangrijk punt na aankoop van elk apparaat Desa CSDPBN (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Desa CSDPBN heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Desa CSDPBN vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Desa CSDPBN leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Desa CSDPBN krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Desa CSDPBN bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Desa CSDPBN kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Desa CSDPBN . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
