Gebruiksaanwijzing /service van het product 1200T van de fabrikant Directed Audio
Ga naar pagina of 18
model 1200 t.
2 2 © 2004 Directed Electronics, Inc Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Limited T wo-year Consumer W arranty . . . . . . . . . . . . . . . . . . . . . . . . . .3 W arning . . . . . . . .
LIMITED TWO-YEAR CONSUMER W ARRANTY 3 3 © 2004 Directed Electronics, Inc Directed Electronics, Inc. promises to the original purchaser , to replace this product should it prove to be defective in wor.
4 4 © 2004 Directed Electronics, Inc FEA TURES High-speed MOSFET switching power supply and dual N-channel MOSFET outputs Stereo, mono, or simultaneous stereo/mono operation Thermal, DC o.
5 5 © 2004 Directed Electronics, Inc INST ALLA TION GUIDELINES 1. Please read this owner's manual care- fully before installing this amplifier . 2.
6 6 © 2004 Directed Electronics, Inc cable of the vehicle, and if neces- sary , upgrade it by adding an addi- tional ground wire that is the same gauge as the amplifier's power wire. Remember , the amplifier can only deliver its rated output when it is not current limited by the power and ground supply wires.
7 7 © 2004 Directed Electronics, Inc 1. R R C C A A O O u u t t p p u u t t J J a a c c k k s s - These pass through RCA jacks can be used to send a signal to a second amplifier . 2. R R C C A A I I n n p p u u t t J J a a c c k k s s - Accepts line level outputs from head units or signal processors at voltages between 250 mV and 8 volts.
8 8 © 2004 Directed Electronics, Inc 1. S S p p e e a a k k e e r r O O u u t t T T e e r r m m i i n n a a l l s s - Connect the speakers to these terminals. (Refer to the Speaker Connection section of this guide.) 2. P P o o w w e e r r L L E E D D - - This LED will illuminate Green to indicate the amplifier is on and operating normally .
9 9 © 2004 Directed Electronics, Inc + BA TT REM GND FUSE 30A x 3 POWER ONE OHM 1 MIN L R 2 MIN BRIDGED FIGURE 2—AMPLIFIER CONNECTIONS 1200T REAR 1 6 4 7 5 2, 3 Control Panel Cover The gain and filter controls are located under a control panel cover on top of the amplifier .
1 1 0 0 © 2004 Directed Electronics, Inc AMPLIFIER CONTROLS TOP 1. E E S S P P P P o o r r t t - - Allows programming of the amplifier using the Bitwriter ® . 2. S S u u b b s s o o n n i i c c F F r r e e q q u u e e n n c c y y H H z z - - This control adjusts the subsonic filter cutoff (between 15-50 Hz).
1 1 1 1 © 2004 Directed Electronics, Inc ESP PORT XOVER FREQ Hz SUBSONIC FREQ Hz 55 550 15 50 SUBSONIC FIL TER XOVER SLOPE 12 24 dB IN OUT BASS BOOST GAIN MIN MAX 0 15 dB AMP MODE MONO STEREO LOW FULL HIGH 1 3 2 7 9 4 5 6 8 FIGURE 3—AMPLIFIER CONTROLS TOP N N O O T T E E : : The adjustment for Gain is a digital control (potentiometer).
1 1 2 2 © 2004 Directed Electronics, Inc ESP FEA TURES AND CONTROLS The ability to access the feature settings of your amplifier is only possible with the use of a Directed Electronics Bitwriter ® unit. Firmware version 1.8 or later is required in the Bitwriter ® .
1 1 3 3 © 2004 Directed Electronics, Inc SPEAKER WIRING DIAGRAMS Stereo operation (top view) Mono operation (top view) Simultaneous stereo/mono operation (top view).
1 1 4 4 © 2004 Directed Electronics, Inc CROSSOVER SETTINGS AND GAIN ADJUSTMENT Y our Directed Audio power amplifier needs to be adjusted carefully to achieve maximum performance.
1 1 5 5 © 2004 Directed Electronics, Inc SUBSONIC FIL TER ADJUSTMENT Sealed Enclosure: Set to Fs of the woofer or higher . Ported Enclosure: Set to tuning frequency of enclosure or higher . Sealed Bandpass: Set to Fs of enclosure. Ported Bandpass: Set to low tuning frequency of enclosure.
1 1 6 6 © 2004 Directed Electronics, Inc Conversion Efficiency >82% @ 4 ohms T otal Harmonic Distor tion THD+N (10Hz–30kHz BW) 4 ohms, 180 watts <0.
1 1 7 7 © 2004 Directed Electronics, Inc RCA Input/Output Jacks 2-channel in/2-channel buffered full-range out Input Impedance 30K ohms Input Sensitivity V ariable from 250 mV to 8 volts Supply V olt.
The company behind this system is Directed Electronics, Inc. Since its inception, Directed has had one purpose, to provide customers with the finest vehicle security , car stereo products, rear seat entertainment, and accessories avail- able.
Een belangrijk punt na aankoop van elk apparaat Directed Audio 1200T (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Directed Audio 1200T heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Directed Audio 1200T vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Directed Audio 1200T leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Directed Audio 1200T krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Directed Audio 1200T bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Directed Audio 1200T kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Directed Audio 1200T . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.