Gebruiksaanwijzing /service van het product 44070 VI van de fabrikant Electrolux
Ga naar pagina of 48
FAVORIT 44070 VI Fully Integrated Dishwasher User Instructions.
2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of thes e use r i nst ru ctio ns ! Please keep these us er ins tru cti ons for later reference. Pass them on to any subsequent owner o f the a ppl ia nce .
Contents 3 CONTENTS Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal . . . . . . . .
Contents 4 What to do, if ... . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 ...Error messages are displayed. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 ...there are problems with the operation of the dishwasher.
Operating Instructions 5 OPERATING INSTRUCTIONS 1 Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law.
Operating Instructions 6 • Never place the dishwasher in ope ration if the mains cable, water inlet or drain hose is damaged; or the control panel, work top or plinth area is damaged such that the inside of the appliance is freely accessible.
Operating Instructions 7 • In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. 2 Disposal Disposing of the Pa ckaging Material Dispose of the dishwasher packaging material correctly.
Operating Instructions 8 Appliance Features, Display and Control Panel Spray Arms Display and Control Panel Container for Special Salt Rating plate Container for Rinse Aid Detergent Dispenser Filters .
Operating Instructions 9 Display and control panel Function buttons: In addition to the dish washing cycle the following functions can also be set with the help of these buttons: Control indicators have the following meanings: 3 The indicators are never illuminated while a dishwashing cycle is run- ning.
Operating Instructions 10 Water softener To avoid scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft water, i. e. water with a low lime content. The dishwasher therefore has a built-in water softener, in which tap water with a hardness of 4°d (German degr ee) and harder is softened with the aid of special salt.
Operating Instructions 11 Setting the water softener Using the table as a guide, adjust th e water softener to that which cor- responds to the hardness of the water in your area: 0 The dishwasher must be switched off. Setting manually: 1. Open the dishwasher door.
Operating Instructions 12 8. Pressing function button 1 increases the hardness setting by 1. (Exception: hardness setting 1 follows hardness setting 10). 9. When the hardness setting is co rrect, press the ON/OFF switch. The hardness setting is now saved.
Operating Instructions 13 0 1. Set the water soft ener manually and electronically to the desired water hardness: 3 If the water softener is electronically set at “1” for the purpose of using detergent that includes special salt, the special s alt indicator is deacti - vated.
Operating Instructions 14 6. Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash wate r, this could lead to poor wash results. To avoid this run a rinse programme after filling the salt container with special salt. This will wash away salt water and any salt crystals that have been spilt.
Operating Instructions 15 1. Press the ON/OFF button. The LED indicators for all programme buttons (and the button for the delay start timer if present) light up. The LED indicators and any option buttons that are present only light up if they are activated.
Operating Instructions 16 Adding rinse aid If you are using dishwasher detergen t and rinse aid separately, add the rinse aid: – Before using the dishwasher for the first time. –W h e n t h e H indicator on the control panel is illuminated. The rinse aid compartment is on th e inside of the dishwasher door.
Operating Instructions 17 Adjusting Rinse Aid Dosing 3 As the dishes are washed rinse aid is released from the disp enser into the wash water. The dose is factory set at 4, and can be adjusted from 1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasses or crockery.
Operating Instructions 18 Activating/deactivating the acoustic signal The acoustic signal can indicate ac ousticall y: – at which water hardness the water softener is set. – whe n a dishwashing cycle has finished. – whe n an error has occurred with the dishwasher .
Operating Instructions 19 Loading Cutlery and Dishes 1 Sponges, household cloths and any obj ect that can absorb water should not be washed in the dishwasher . • Before loading the dishes, you should: – Remove all scraps of food. – Soften remnants of burnt food in pans.
Operating Instructions 20 Loading Cutlery 1 Long bladed knives stored in an upright position are a potential hazard. 1 Long and/or sharp items of cutlery such as carving knives must be positioned horizon tally in the upper basket. 1 Take care when loading or unload- ing sharp items such as knives.
Operating Instructions 21 Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower basket (Plates up to 29cm in diameter).
Operating Instructions 22 Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper basket. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items.
Operating Instructions 23 Adjusting the Height of the Upper Basket 3 The height of the basket can also be adjusted when it is loaded. Lowering the Upper Basket: 0 1. Pull the upper basket out completely. 2. Holding the upper basket at the rear right, lift it as far as it will go and then lower it vertically.
Operating Instructions 24 Filling with Detergent 1 Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme).
Operating Instructions 25 Use of "3 in 1"/ Co mbi Detergent Tablets General Advice These products are tablets with combined detergent/rinse-aid and salt functions.
Operating Instructions 26 Concentrated Detergent Based on their chemical compositio n, dishwasher detergents can be split into two basic types: – conventional , alkaline detergents with caustic components –l o w a l k a l i n e concentrated detergents with natural enzymes.
Operating Instructions 27 Selecting the Wash Progr amme (Programme Table) Choose the most suitable wash program me with the aid of this table: Type of Dishes Dinner Service and Cooking Utensils Dishes.
Operating Instructions 28 Starting a di shwashing cycle 0 1. Check that the dishes and cutlery are stacked in the dish washer in such a way that the spray arms are free to rotate. 2. Turn on the tap fully. 3. Press the ON/OFF button. The LED indicators for all programme buttons (and the button for the delay start timer if present) light up.
Operating Instructions 29 3. Release the cycle button. 4. Close the dishwasher door. The newly selected dishwashing cycle will commence from the beginning. Interrupting the dishwashing cycle by opening the dishwasher door 0 1. Open the door of the dishwasher.
Operating Instructions 30 Switching off the dishwasher If the acoustic signal has been en abled, a continuous tone will sound for 15 seconds at the end of the programme. 1 Hot steam may escape if the door is opened immediately after the pro- gramme has ended.
Operating Instructions 31 Cleaning the Filter 3 The filters should be checked and cleaned regularly. Dirty filters will give poor wash results. 0 1. Open the door, remove the lower basket. 2. The dishwasher fi lter system com- prises a coarse/fine filter, microfilter and a flat filter.
Operating Instructions 32 What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee.
Operating Instructions 33 After rectifying the fault related to 1 or 2 warning tones press the button for the commenced dishwashin g cycle. The dishwashing cycle will continue. If the fault is displayed again, please conta ct your Local Service Force Centre.
Operating Instructions 34 ...there are problems with th e operation of the dish- washer. ...the wash results are not satisfactory. The dishes are still dirty. – The wrong wash programme was selected. – The dishes were loaded is such a way that the wash waster did not reach all items.
Operating Instructions 35 There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. – Increase rinse aid dosing. – The detergent may be the cause. Contact the detergent manufac- turer’s customer advisor.
Operating Instructions 36 Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table).
Installation and Connection Instru ctions 37 INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted to ensure that it is stable and level.
Installation and Connectio n Instructions 38 Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations.
Installation and Connection Instru ctions 39 3 The following section is only applicable to dishwashers that have a safety valve on the threaded hose fitting for the tap: Water inlet hose with safety valve After connecting the double-walled wate r inlet hose, the safety valve is next to the tap.
Installation and Connectio n Instructions 40 Water drain Drain hose 1 The drain hose must not be kinked, crushed or entangled. • Connecting the drain hose : – Maximum permitted height: 1 metre. – Minimum required height 40 cm above the lower edge of the machine.
Installation and Connection Instru ctions 41 Leak prevention system To avoid damage caused by water leakage, the dishwasher is equipped with a leak prevention system. In the event of a fault, the safety valve in the appliance immediately interrupts the in flow of water and th e drain pump is activated.
Installation and Connectio n Instructions 42 Electrical Connection Any electrical work required to inst all this appliance should be car- ried out by a qualified elec tr ician or competent person. 1 WARNING - This appliance must be earthed. The manufacturer declines any resp onsibility should these safety measures not be observed.
Installation and Connection Instru ctions 43 Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installa tion example given below can only be regarded as a recommendation.
Guarantee Conditions 44 GUARANTEE CONDITIONS Standard guaran tee conditions We, AEG, undertake that if within 12 mont hs of the dat e of the purchase this AE G appliance or any part thereof is proved .
45.
46.
Service and Spare parts 47 SERVICE AND SPARE PARTS In the event of your appliance requir ing service, or if you wish to pur- chase spare parts, please contac t Service Force by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area.
From the El ectrolu x Group . The world´s No.1 choice. The Electrolux Gr oup is the world´s largest producer of po wered ap pliances for ki tchen, cleaning and outdoor use.
Een belangrijk punt na aankoop van elk apparaat Electrolux 44070 VI (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Electrolux 44070 VI heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Electrolux 44070 VI vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Electrolux 44070 VI leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Electrolux 44070 VI krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Electrolux 44070 VI bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Electrolux 44070 VI kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Electrolux 44070 VI . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
