Gebruiksaanwijzing /service van het product DFKTWC75GS van de fabrikant Electrolux
Ga naar pagina of 20
Use & Care Guide Installation Instructions Vent Hood 316495007 - 09/2007.
2.
3 Finding Information Purchase date Electrolux model number Electrolux serial number (see picture for location) Please read and save this guide Thank you for choosing Electrolux , the new premium brand in home appliances.
4 Safety Important Safety Instructions Read all instructions before using this appliance. Save these instructions for future reference. Do not attempt to install or operate your appliance until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a WARNING or CAUTION based on the risk type.
5 Safety TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:* 1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
6 Unpack hood and check contents. You should receive: 1 - Hood 1 - Decorative Flue Assembly 1 - Parts Bag containing: 1 - Mounting Bracket 1 - Discharge Collar 1 - Flue Mounting Bracket 6 - Mounting Screws (4,8 x 38mm Pan Head) 7 - Mounting Screws (3,9 x 9,5mm Pan Head) 2 - Mounting Screws (3.
7 Installation 1. Decide where the ductwork will run between the hood and the outside. 2. A straight, short duct run will allow the hood to perform most efficiently. 3. Long duct runs, elbows, and transitions will reduce the performance of the hood. Use as few of them as possible.
8 Installation Wiring GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug.
9 Installation Install mounting bracket FRAMING BEHIND DRYWALL 37"= bottom of hood 24" above cooktop 43"= bottom of hood 30" above cooktop 37” to 43” above cooktop 1. Construct wood wall framing that is flush with inte- rior surface of wall studs.
10 Installation Prepare the hood NOTE On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation. 1. Remove the polystyrene block and the tape (Fig.1).
11 DUCTED CONFIGURATION 1. Install the discharge collar into the duct connector of the range hood. Fig. 6. FIG. 6 DISCHARGE COLLAR DUCT CONNECTOR Non - Ducted Recirculation Kit, Model DFKTWC75GS. 5” diameter duct. 1. Discard discharge collar/damper supplied with the hood.
12 Installation FIG. 9 MOUNTING SCREWS (4.8x38mm) MOUNTING SCREWS (4.8x38mm) RECTANGULAR OPENING WALL MOUNTING BRACKET MOUNTING SCREWS (3.9x9.5mm) FIG.10 PLATE OF THE ELECTRICAL SYSTEM MOUNTING SCREWS (3.9x9.5mm) Install the hood 1. Raise the hood into its mounting position.
13 9. Carefully place the decorative flue on the hood. Fig. 13. - On ducted installation in rooms with 8-foot ceilings , the air vents are concealed. Install the flue with the air vents down. - On non-ducted installations in rooms with 8-foot ceilings , the air vents are exposed.
14 (DUCTED AND NON-DUCTED HOODS) 1. To remove the GREASE filters, pull the metal latch ta b outside and unlock the filter. 2. To install the GREASE filters, align rear filter tabs with slots in the hood. Depress the metal latch tab, push filter into position and release.
15 The grease filters should be cleaned when the filter reset switch will be illuminated. Use a warm detergent solution. Grease filters are dishwasher safe.
16 Operation Controls Dead-front mode IMPORTANT The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the integral disconnecting switch located inside the blower housing.
17 Remove the grease filters. Open the fuse box. Replace with the same type of fuse (5x20mm, 4A, 125V). Fuse Key : 5304455332 FUSE BOX This range hood requires two halogen bulbs (max 20W, 12V, Type T3 bulb, G4 Base).
18 Warranty Information In the U.S.A., your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industries, Inc.
19.
04307838/3S.
Een belangrijk punt na aankoop van elk apparaat Electrolux DFKTWC75GS (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Electrolux DFKTWC75GS heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Electrolux DFKTWC75GS vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Electrolux DFKTWC75GS leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Electrolux DFKTWC75GS krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Electrolux DFKTWC75GS bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Electrolux DFKTWC75GS kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Electrolux DFKTWC75GS . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
