Gebruiksaanwijzing /service van het product HD8110 van de fabrikant Emerson
Ga naar pagina of 22
PE R S O N A L C D , CD - R / R W P L A YE R w i t h 40 SE C O N D E L E C T R O N I C AN T I - S K I P P R O T E C T I O N , a n d F M D I G I T A L T U N E R H D 8 1 1 0 O W N E R ’ S M A N U A L V i s i t ou r w eb s i t e a t w ww . e m e r s on r ad i o .
1 T h a n k y o u . ........ F o r pu r c ha s i ng t h i s E m e r s on P e r s on a l CD P l a y e r wi t h F M d i g i t a l t une r . T he CD p l a y e r ha s a 20 t r a ck p r og r a mm ab l e m e m o r y s o y ou c a n li s t en t o t he s ong s on y ou r f a v o r i t e CD ' s i n a n y o r de r y ou c h oo s e .
2 W A RN I N G: T O P R EVE N T F I R E O R S H O C K H A Z A R D , D O N O T EXP O SE T H I S UN I T T O R A I N O R M OI S T UR E . T h i s de v i c e c o m p li e s w i t h pa r t 15 o f t he F CC r u l e s .
3 P R E P AR A T I O N F O R U S E REMOVE THE TRANSIT CARD This personal CD player is shipped with a dummy CD ‘ transit card ’ inside the CD compartment. The purpose of this card is to prevent the laser from moving during shipment of the product. This card must be removed before using the CD playe r.
4 INS TA LLING THE B ATTERIES Note : The battery compartment is located inside the CD compartment. 1.) Slide the OPEN switch to the right to open the CD door. If you have not already done so, remove the dummy CD ‘ transit card ’ and discard it. 2.
5 CONNECTING THE OPTION AL AC ADAPTER (NOT INCLUDED) 1.) Connect the small female plug of the optional AC adapter to the “ DC IN 4.5 V ” jack on the right side of the CD player. 2.) Connect the adapter housing to your 120V AC 60Hz outlet. Notes: • Never connect or disconnect the adapter from the AC outlet while your hands are wet.
6 CONNECTING THE STEREO HEADPHONES Connect the plug of the supplied stereo headphones to the green-colored PHONES jack on the left side of the cabinet. NOTE : Make sure the headphone plug is inserted into the PHONES jack as far as it will go. If the plug is not fully inserted, you may only hear sound from one side of the headphones.
7 PRESET MODE MEMORY RADIO PLAY/ PAUSE STOP SKI P REV./ TUN. DOWN SKI P FWD./ TUN. UP L O C A T I O N O F C O N T R O L S A ND I ND I C A T O R S 1 2 3 4 5 6 7 8 9 10 1 1 12 13 14 15 16 HD8110_052404.
8 1 . ) O PE N S w i t c h – S l i de t o t he r i gh t t o un l o c k a nd open t he CD doo r . . 2 . ) V O L U M E C on t r o l – R a i s e s o r l o w e r s t he v o l u m e . 3 . ) P H O N ES J a ck – C onne c t s t e r eo he adph one s , i n c l uded , t o t h i s j a ck .
9 1 . ) F M R ad i o I nd i c a t o r . 2 . ) F M S T E R E O I nd i c a t o r . 3 . ) P R O G ( P r og r a m) I nd i c a t o r – A ppea r s w hen p r og r a mm i ng t r a cks / F M p r e s e t s t a t i on s , o r p l a y i ng p r og r a mm ed t r a cks .
10 O P E R A T I N G I N S T RUC T I O N S SPECIAL FUNCTIONS HOLD Switch The HOLD switch (on the left side cabinet) must be in the ‘ Off ’ (left) position to start the CD player. If you plan to carry the CD player in a handbag, briefcase, school bag, back pack, etc, slide the HOLD switch to the ‘ On ’ (right) position.
11 Electronic Skip Protection (ESP) This CD player includes an Electronic Skip Protection circuit that continuously stores 40 seconds of CD music in an electronic memory. If the player is bumped or shaken you will not hear any skipping because the player is reading from the memory, not directly from the disc.
12 NORMAL CD PL AYBACK • Make sure you have installed the batteries. • Make sure the HOLD switch is set to the ‘ Off ’ (left) position. • Make sure to set the VOLUME control to a low setting before you put on the headphones. IMPOR TANT: This CD player can play normal CDs plus CD Recordable (CD-R) and CD Rewriteable (CD-RW) discs.
13 6.) Playback will continue until the end of the disc, then the player will stop automatically and the display will again show the total tracks and playing time on the disc. After approximately 30 seconds the power switches ‘ Off’ automatically to conserve the batteries and the display goes blank.
14 MODE BUTTON Pressing the MODE button during CD playback cycles the player through the following four special playback modes: REPE AT 1 REPE AT ALL INTRO SHUFF (Shuffle) Playback. REPE AT PLAYBACK The player can be programmed to continuously repeat a single track or the entire disc automatically.
15 INTRO (Intro Scan) PL AYBACK The Intro Scan feature plays only the first 10 seconds of each track on the disc. This feature is useful when you are trying to find a particular song but you cannot remember the title. 1.) Load your disc in the player as usual and press the PL A Y/ PA USE button to begin playback.
16 PROGRAMMED PL AYBACK You can program up to 20 tracks on a disc to play in any desired orde r. NOTE: You can program a disc either during Playback or in Stop mode. 1.) Press the MEMORY button once. The Program Number ‘ 01 ’ appears. The PROG indicator and the the track number ‘ 00 ’ flash.
17 L I S T E N I N G T O T H E RAD I O 1 . ) P r e ss t h e R AD I O bu t t on , t he F M r ad i o f r equen cy a ppea r s i n t he d i s p l a y . 2 . ) T une t o t he de s i r ed s t a t i on b y p r e ss i ng t he T UN . U P o r T UN . D O W N bu tt on .
18 P R ESE T T I N G S T A T I O N S I N M E M O R Y U p t o 20 F M s t a t i on s c an be s t o r ed i n t o t he P r e s e t m e m o r i e s . T he y w ill r e m a i n i n m e m o r y a s l ong a s t he ba tt e r i e s a r e i n s t a ll ed . 1 . ) P r e ss t he RA D I O bu tt on t o t u r n t he r ad i on ‘ O n ’ .
19 C L E AN I N G T H E CAB I N E T W i pe w i t h a s o f t c l o t h . If t he c ab i ne t i s v e r y d i r t y , da m pen t he c l o t h w i t h a w ea k s o l u t i on o f neu t r a l de t e r gen t a nd w a t e r , and t hen w i pe c l e an .
20 L I M I T E D W AR RAN T Y E m e r s on R a d i o C o r p . w a rr a n t s m a nu f a c t u r i n g d e f ec t s i n o r i g i n a l m a t e r i a l , i n c l ud i ng o r i g i n a l p a r t s a nd.
E M E R S O N P a r t N o . 1 6 - 2 9 3 7 405 - 0 1 P r i n t e d i n C h i n a HD8110_052404.p65 25/5/2004, 12:21 21.
Een belangrijk punt na aankoop van elk apparaat Emerson HD8110 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Emerson HD8110 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Emerson HD8110 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Emerson HD8110 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Emerson HD8110 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Emerson HD8110 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Emerson HD8110 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Emerson HD8110 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
