Gebruiksaanwijzing /service van het product Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 van de fabrikant Alliance Laundry Systems
Ga naar pagina of 30
Operation/Pr ogramming/Maintenance www .comlaundry .com Drying T umblers 50 Pound Capacity 75 Pound Capacity Refer to Pa ge 3 for Model Identif ication Part No. 70400301R3 August 2007 K eep These Instructions f or Future Refer ence. (If this machine changes o wnership, th is manual must acc ompan y machine.
.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70400301 1 Installation must conf orm with local code s or in the absence of lo cal codes with: In the U .S.A. , installation must conf orm to the latest edit ion of the American Nati onal Standard Z223.
© Copyright 2007, Alliance Laundry Systems LLC All rights reserv ed. No part of the cont ents of this book may be reproduced or transmitted in an y form or by an y means without the e xpressed written consent of the publisher . © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 2 70400301 Ta b l e o f Contents Introduction .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 3 70400301 Intr oduction Model Identification Information in this manual is applicable to these models: Includes models with con.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Introd uction 70400301 4 Customer Ser vice If literature or replacement parts are required, contact the source from which the machine was purchased or contact Alliance La undry Systems at (920) 74 8-3950 for the name and address of the nearest authorized parts distributor .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT 5 70400301 Safe ty Inf ormation Explanation of Safet y Messages Precautionary statements (“D ANGER , ” “W ARNING, ” and “CA UTION”), followed b y specific instructions, are found in this manual an d on machine decals.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Sa fe ty In for m at i on 70400301 6 Impor tant Safety Instructions Sa ve These Instructions 1. Read all instructions before using the tumbler . 2. Refer to the GR OUNDING INSTRUCTIONS for the proper grounding of the tumbler .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Safety Information 7 70400301 23. Remove laundry immediately after tumb ler stops. 24. Always read and follo w manufacturer’ s instructions on package s of laundry and clea ning aids.
70400301 8 © Copyright, Alliance Laundr y Systems LLC – DO NOT COPY or TRANSMIT Operating Instructions Emergenc y Stop Button on CE Models All CE appro ved OPL tumblers are f actory equipped with an emergenc y stop button located on the front panel.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 9 70400301 Contr ol Instructions Figure 3 Electr omechanical Coin Contr ol CD and CX Control Suffix es 1. Set the TEMPERA TURE selector at HIGH or LO W , or anywhere between these settings.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 70400301 10 Figure 4 Manual Timer Control MT and R T Control Suffixes 1. Set the HEA T/DR YING timer for the number of minutes (from 0-60) desired. 2. Set the COOL DO WN/COOLING timer for the number of minutes (from 0-15) desired.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 11 70400301 Figure 5 Dual Digital Timer Control QT and RQ Control Suffix es 1. Select HIGH, MED, LO W or NO HEA T by turning the temperature knob . 2. Set the HEA T TIME for the number of minutes (from 0-60) desired.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 70400301 12 T o Program a Short T est Cycle: 1. Unplug machine po wer cord. 2. Write do wn machine cont rol dip swi tch settings, then set them all to th e of f position.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 13 70400301 Figure 7 Single Dr op Contro l SD and SX Control Suffix es 1. Select HIGH, MED, LO W or NO HEA T by turning the temperature knob . 2. Insert the coin(s) in the coin slot.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 70400301 14 T opoffs Any time the control recei ves a coin drop pulse du ring a cycle it will add the programmed dry t ime to the time currently remaining in the cycle.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 15 70400301 Diagnostic Micr oprocessor Contr o l General Oper ation The Diagno stic Micropro c essor Control (DMP) is designed to ma nage the drying and cooling cycles of the tumbler .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 70400301 16 DMP Coin D V and DX Control Suffix es Description of The Coin Control P anel Refer to Fi g u re 8 . TMB1955N 1 Clock Symbol. This symbol of a clock indicates that the time in the display is counting down to z ero .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 17 70400301 DMP Coin F eatures Coin Ke ypad Interface - ST AR T button to start or resume a cycle. - TEMP bu tton to select HIGH, MEDIUM, or LO W temperature.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 70400301 18 DMP OPL Models DO Control Suffix Description of the OPL Control Panel Refer to Fi g u re 9 . Figure 9 TMB1956N 1 ST ART . Starts or resumes the current program or cycle .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 19 70400301 DMP OPL F eatures DIP Switch Settings The DMP has an 8 position DIP switch bank that is accessible from the back of the control board.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 70400301 20 Programming 1. Set DIP switch #8 to the ON position. 2. Select the desired program number to change. The LED should be flashing. 3. Select DR Y TIME.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 21 70400301 Rotation Sensor The rotation sensor must “read” the ke y on the bask et shaft or pulley . The senso r must be set approximat ely 1/4 inch from the k ey o r pulle y .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 70400301 22 Ignition Contr ol Operation Po w e r U p After 24 V A C is applied to the ignition control pins 24V and GND, the Diagnostic LED on the ignition control will turn orange/yello w .
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Operating Instructions 23 70400301 Gas V alve The ignition control v erifies that the gas v alve is connected. Failure of this te st results in the ignition control entering Lockout Mo de with the Di agnostic LED displaying Error Code 2.
70400301 24 © Copyright, Alliance Laundr y Systems LLC – DO NOT COPY or TRANSMIT Maintenance Daily 1. Inspect the area surrounding tumblers, remov e all combustible materials, including l int, before operating the machines. 2. Check c ylinder for foreign objects to a void damage to clothing and equipment.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Maintenance 25 70400301 Monthly 1. Remov e lint and debris from inside exhaust duct to maintain proper airflo w and a v oid ov erheating. a. Remov e external duct and duct access co vers, if present.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Maintenance 70400301 26 Daily Maintenance Monthly Maintenance T o reduce the risk of electric shoc k, fire , explosion, serious i njury or death: • Disconnect electri c powe r to the tumble r bef ore servicing.
© Copyright, Alliance Laundry Systems LLC – DO NO T COPY or TRANSMIT Maintenance 27 70400301 Quar ter ly Maintenance Bi-Annually Maintenance T o reduce the risk of electric shoc k, fire , explosion, serious i njury or death: • Disconnect electri c powe r to the tumble r bef ore servicing.
70400301 28 © Copyright, Alliance Laundr y Systems LLC – DO NOT COPY or TRANSMIT Bef ore Y ou Call f or Ser vice Customer Ser vice If literature or replacement parts are required, contact the sourc.
Een belangrijk punt na aankoop van elk apparaat Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Alliance Laundry Systems Drying Tumblers 50 Pound Capacity 75 Pound Capacity Model Identification Part No. 70400301R3 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.