Gebruiksaanwijzing /service van het product H20.5 SERIES van de fabrikant Frymaster
Ga naar pagina of 42
Frymaster, a member of the Co mmercial Food Eq uipment Service Asso ciation, recomm ends using CFESA Certified Tec hnicians. 24-Hour Service Hotline 1-800-551-8633 JUNE 2003 *8195606* H20.
Please read all sections of this manual and retain for future reference. NOTICE IF, DURING THE WARRANTY PERIOD, THE CUST OMER USES A PART FOR THIS ENODIS EQUIPMENT OTHER TH AN AN UNMODIFIED NEW OR REC.
DANGER Improper installation, adjustment, maintenance or service, and unauthorized alterations or modifications can cause property damage, injury , or death. Read the installation, operating and service instructions thoroughly before installing or servicing this equipment.
H20.5 SERIES ELECTRIC FRYER TABLE OF CONTENTS Page # 1. INTRODUCTION 1-1 1.1 General 1-1 1.2 Safety Information 1-1 1.3 Computer Information 1-2 1.4 Shipping Damage Claim Procedure 1-2 1.5 Computer Information 1-3 2. INSTALLATION INSTRUCTIONS 2-1 2.1 General 2-1 2.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 1: INTRODUCTION 1-1 1.1 General Read the instructions in this manual thoroughly befo re attempting to operate this equipment. This manual covers all H20.5 Series electric fryers. H20.5 Series electric fryers featur e easy to clean, open frypots with tilt-up elements.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 1: INTRODUCTION 1-2 1.3 Computer Information This equipment has been tested and found to comp ly with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. While this device is a verified Cl ass A device, it has been shown to meet the Class B limits.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 1: INTRODUCTION 1-3 1.5 Service Information For non-routine maintenance or repairs, or for service information, cont act your local Frymaster Authorized Service Center (FASC). Service in formation m ay also be obtained by calling the Frymaster Technical Services Department (1 -800-551-8633).
H20.5 SERIES ELECTRIC FRYERS CHAPTER 1: INTRODUCTION 1-4 1.7 SERVICE PERSONNEL 1.7.1 Definitions A. Qualified and/or Authorized Operating Pers onnel 1.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 2: INSTALLATION INSTRUCTIONS 2-1 2.1 General Proper installation is essential for the safe, e ff ici ent, trouble-free operation of this appliance. Qualified, licensed, and/or authorized installati on or service perso nnel, as defined in Section 1.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 2: INSTALLATION INSTRUCTIONS 2-2 All installation and service on Frymaster equipm ent must be perform ed by qualified, certified, licensed, and/or authorized inst allation or serv ice personnel. Service may be obtained by contacting your lo cal Factory Authorized Service Center.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 2: INSTALLATION INSTRUCTIONS 2-3 6. Close fryer drain-valve and fill fryp ot with wate r to the bottom OIL LEVEL line. 7. Boil out frypot prior to first use. S ee Frypot Boil-Out instructions on page 2.4 . 8. Drain, clean, and fill frypot(s) with cooking oil.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 2: INSTALLATION INSTRUCTIONS 2-4 Also, after the fryer has been in use for a period o f time, a hard f ilm of caram elized vegetable oil will form inside the frypot. This film should be periodically removed by following the boil-out procedure.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 2: INSTALLATION INSTRUCTIONS 2-5 2.5 Equipment Setup and Shutdown Proc edures Setup WARNING Fill the frypot to the bottom OIL LEVEL line with vegetable oil before pressing the ON/OFF switch to the "ON" position.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-1 3.1 Operating Fryers with Computer Magic III.5 Computers 1 2 4 5 3 8 6 7 ITEM DESCRIPTION 1 Lighted Display -- left display of various functions and operations. 2 Lighted Display -- right display of various functions and operations.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-2 3.1 Operating Fryers with Computer Magic III.5 Computers (cont.) 3.1.1 Equipment Setup and Shutdown Procedures Setup WARNING Fill the frypot to the bottom OIL LEVEL line with vegetable oil before pressing the ON/OFF switch to the "ON" position.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-3 3.1.1 Equipment Setup and Shutdown Procedures (cont.) Operating the Fryer A. Turn the computer on by pressing the switch. 1. One of the following displays will appear: a. , indicating that the element is operating in the m elt-cycle mode.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-4 3.1.1 Equipment Setup and Shutdown Procedures (cont.) 2. The display will indicate the progr ammed cook tim e and begin countdown.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-5 3.2 Programming The Computer Magic III.5 (cont.) 4. " " (Setpoint) will appear in the left display. This is for se tting the cooking temperature. The temperature previously selected will be displayed in the right display.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-6 3.2 Programming The Computer Magic III.5 (cont.) 3.2.1 Boil Feature CAUTION Do not drain water or boil-out solution into the filtration system (if applicable). Irreparable damage will result and void the warranty.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-7 3.2.4 Constant Oil Te mperature Display Mode 1. To program constant temperature display, press the switch. 2. Press the switch. will appear in the left display. 3. Enter 1, 6, 5, L in that sequence.
H20.5 SERIES ELECTRIC FRYERS CHAPTER 3: OPERATING INSTRUCTIONS 3-8 3.3 Fallback Controller (Optional) If the computer fails, place the fallback controller switch in the "up" ("ON") position (Figure 1). The fallback controller switch is located inside the fryer door, on the le ft-side panel, under the component box.
4–1 H20.5 SERIES ELECTRIC FRYERS CHAPTER 4: PREVENTATIVE MAINTENANCE 4.1 Cleaning Fryer 4.1.1 Clean Inside and Outside of Fryer Cabinet- Daily Clean inside the fryer cabinet with a dry, clean clo th. Wipe all accessible m etal surfaces and components to remove accum ulated oil/shortening and dust.
4–2 4.1.4 Draining and Manual Filtering: Non-Filtration Fryers DANGER Allow oil/shortening to cool to 100ºF (38ºC) or lower before draining to an appropriate container for disposal.
5-1 H20.5 SERIES ELECTRIC FRYERS CHAPTER 5: OPERATOR TROUBLE SHOOTING 5.1 Introduction This section provides an easy reference guide to some of the common problems that m ay occur during the operation of this equipment.
5-2 5.2 Troubleshooting 5.2.1 Control and Heating Problems Problem Probable Causes Corrective Action A. Power cord is not plugged in or circuit breaker is tripped. A. Plug power cord in and verify that circuit breaker is not tripped. B. Controller has failed.
5-3 5.2.1 Control and Heating Problems (cont.) Problem Probable Causes Corrective Action Fryer repeatedly cycles on and off when first started. Fryer is in melt-cycle mode. This is normal for fryers equipped with CM III.5 computers and Digital Controllers .
5-4 5.2.1 Control and Heating Problems (cont.) Problem Probable Causes Corrective Action Fryer heats until high- limit trips without heat indicator ON. Contactor or controller has failed. Call FASC. Fryer stops heating with heat indicator ON. The high-limit thermostat or contactor has failed.
5-5 5.2.2 Error Messages and Di splay Problems (cont.) Problem Probable Causes Corrective Action Display shows . Fryer is more than 21°F (12°C) above setpoint. This display is normal if the fryer setpoint has been changed to a lower temperature. The display should revert to the normal four dashes when the frypot temperature cools to the setpoint.
5-6 5.3 Wiring Diagrams 5.3.1 Wiring Diagram, Contactor.
5-7 5.3.2 Wiring Diagram, Main.
6-1 H20.5 SERIES ELECTRIC FRYERS CHAPTER 6: PARTS LIST 6.1 Cabinet Assemblies and Related Components 1 2 9 3 4 5 6 8 7 10 11 12 13 14 15 16 17 18 19.
6-2 6.1 Cabinet Assemblies and Component Parts (cont.) ITEM PART # COMPONENT 1 900-2981 Rail, Front Top 2 806-7714 Base Assembly, Single 3 806-8277 Upright and Nutsert Assembly, Left 4 806-8295 Uprigh.
6-3 6.3 Component Box Assembl y and Associated Hardware 1 4 3 2 5 6 7 Solder non-terminal wires here To Com puter 8 9 10.
6-4 6.3 Component Box Assembly an d Associated Hardware (cont.) ITEM PART # COMPONENT 1 806-8303 Box, Com ponent 2 806-9495 Terminal Block * 816-0217 Insulating Paper, Terminal Block 3 807-0979 Transformer, 208/240/12 VAC 50/60 Hz. 43VA 4 807-0680 Transformer, 208/240/24 VAC 50/60 Hz.
6-5 6.4 Contactor Box and Related Components (cont.) ITEM PART # COMPONENT 1 807-0922 Holder, Buss Fuse HPS * 807-2278 Fuse, KTK-R-20 20 Amp 2 807-0501 Fuse Block, 3-Pole 3 807-2464 Power Block, Delta.
6-6 6.6 Control Panel Assemblies, Top Caps/Tilt Housings and Related Components 1 2 3 2 4 ITEM PART # COMPONENT 1 824-0594 Tilt Housing 2 806-7713 Control Panel Assembly 3 823-2555 Top Cap 4 823-2568 .
6-7 6.7 Frypot Assembly and Related Components 1 2 3 4 6 7 5 8 11 12 13 14 15 9 10 17 16.
6-8 6.7 Frypot Assembly and Related Components (cont.) ITEM PART # COMPONENT 1 809-0417 Nut, ¼-20 Flange-Serrated 2 900-5851 Retainer, Insulation—Bottom 3 816-0275 Insulation, Side and Bottom 4 900-4100 Retainer, Insulation—Side 5 813-0070 Elbow, 90° 1-¼ NPT 6 813-0144 Nipple, 1-¼ x 2.
6-9 6.8 Heating Elements and Related Components 1 2 3 4 5 6 9 7 8 10 11 12 13 14 15 16 17 18 19 20.
6-10 6.8 Heating Elements and Related Components (cont.) ITEM PART # COMPONENT 1 806-8306 Tilt-Plate Assembly 2 807-1025 Bushing, 3/8-Split 3 807-2534 Probe, Temperature 4 807-2557 Element, Heating 10.
THIS PAGE INTENTIONALLY LEFT BLANK.
Frymaster, L.L.C., 8700 Line Av enue, PO Box 51 000, Shreveport, Louisiana 71135-1000 Shipping Address: 8700 Line Av enue, Shreveport, Louisiana 71106 TEL 1-318-865-1711 FAX (Parts) 1-31 8-219 -7140 (.
Een belangrijk punt na aankoop van elk apparaat Frymaster H20.5 SERIES (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Frymaster H20.5 SERIES heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Frymaster H20.5 SERIES vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Frymaster H20.5 SERIES leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Frymaster H20.5 SERIES krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Frymaster H20.5 SERIES bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Frymaster H20.5 SERIES kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Frymaster H20.5 SERIES . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
