Gebruiksaanwijzing /service van het product gnc 300 van de fabrikant Garmin
Ga naar pagina of 46
Av. Kit Install. Manual 190-00067-02 Rev. J Page 1 GNC 300 INSTALLATION MANUAL GARMIN INTERNATIONAL, INC. PART NUMBER: 190-00067-02 1200 E. 151st STREET REVISION J, 30 MARCH 1998 OLATHE, KANSAS 66062-.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 2 © Copyright 1995-1998 Garmin Corporation All Rights Reserved This publication is the proprietary property of Garmin International Inc. It may not be reproduced or transmitted in any form whether printed or electronic, without the expressed written consent of Garmin International.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 3 TABLE OF CONTENTS SECTION 1 GENERAL DESCRIPTION 1.1 INTRODUCTION 1.2 TECHNICAL CHARACTERISTICS 1.2.1 PHYSICAL CHARACTERISTICS 1.2.2 OPERATIONAL CHARACTERISTICS 1.2.3 INTERFACES 1.3 LICENCE REQUIREMENTS SECTION 2 INSTALLATION CONSIDERATIONS 2.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 4 LIST OF ILLUSTRATIONS FIGURE 1-1 PINOUT DEFINITION, 37 PIN DSUB 1-2 PINOUT DEFINITION, 26 PIN HD-DSUB 1-3 INTERCONNECT SCHEMATIC 1-4 INTERCONNECT SCH.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 5 SECTION 1 GENERAL DESCRIPTION 1.1 INTRODUCTION This manual describes the physical, mechanical, and electrical characteristics and the installation requirements for the GNC 300 Aviation Kit.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 6 of the rack. Figure 1-2 defines the function of each pin in the 26 pin HD-DSUB connector (J102) located above the 37 pin connector at the back of the rack. Figures 1-3 and 1-4 defines the interconnects between the rack and other instruments.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 7 NAV Super Flag Output: Output capable of driving positive logic NAV Super (Pin 10) Flag by sourcing up to 500mA for flag out of view (NAV valid). RS422 input: Input capable of receiving serial OBS data from (Pins 11 & 27) Collins Pro Line 2 EFIS DSP unit.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 8 Sequence Hold Low: Input, when grounded, activates HOLD mode. See (Pin 13) the GNC 300 Pilot's Guide (GPN 190-00067-00) for more information. 1.2.3.3 COMM Antenna Connector (J4) Capable of providing 5 watts, minimum, at 13.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 9 The antenna should be located at least 3 feet from transmitting antennas such as VHF Comm, HF transmitter, DME, Transponder, and Radar. 2.1.2 COMM ANTENNA LOCATION The COMM antenna should be well removed from all projections, engines and propellers.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 10 If a COMM antenna is found to be the problem, a 1.57542 GHz notch filter (GPN 330- 00067-00) may be installed in the VHF COMM coax, as close to the COMM as possible. This filter (GPN 330-00067-00) is required for the GNC 300 transmitter).
Av. Kit Install. Manual 190-00067-02 Rev. J Page 11 dissipating equipment can produce unacceptably high ambient air temperatures around the unit. A 5/8 inch diameter air fitting is provided on the rear of the mounting rack for the purpose of admitting cooling air under such conditions.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 12 2.6 EXTERNAL ALTITUDE INPUT Pressure altitude input from an external source may be derived from a RS-232 compatible serial altitude input or Parallel Gray Code/Gillham Altitude as described in Section 4 of this manual.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 13 The following installation accessories are required but not provided: COMM ANTENNA: BROAD BAND 50 OHM VERTICALLY POLARIZED WITH COAXIAL CABLE. HEADPHONES: 500 OHM NOMINAL IMPEDANCE MICROPHONE: LOW IMPEDANCE CARBON OR DYNAMIC WITH TRANSISTORIZED PRE-AMP.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 14 Non- GARMIN part numbers shown are not maintained by GARMIN and consequently are subject to change without notice.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 15 3.5 GNC 300 INSTALLATION AND REMOVAL The GNC 300 is installed in the rack by gently sliding it straight in until it rests against the back of the rack. A 3/32 inch hex drive tool is then inserted into the access hole at the bottom of the unit face.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 16 4.2 INSTALLATION CONFIGURATION Note that the below pages are in the order found when rotating the outer knob clock-wise starting at the Display Test Page.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 17 Note: Verify with manufacturer of data input device that unit supports GARMIN interface. Output: Field Description off No units connected to Channel.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 18 Output: Field Description off No units connected to ARINC 429 output Collins PL2 EFS Collins Pro Line 2 EFIS connected (w/ GAMA) King EFS 40/50 King.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 19 Identification data Label (octal) Description 377 Equipment identifier 371* General Aviation equipment identifier *These labels are formatted per the General Aviation Manufacturers Association (GAMA) definition.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 20 4.2.8 CONFIGURATION Select the Configuration Test Page. Change the selectable Strap and Fuel selections to match that of the aircraft.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 21 4.2.10 I/O CHANNEL 2 Note: This page is not found in the Test Pages but is included here to aid installation. For more information see SET pages in the Pilot's Guide (GPN 190-00067-00). Select the I/O CHANNEL 2 Set Page.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 22 The first line, below the COMM frequencies, shows the source of external power as shown below: External Power voltage Battery Power Wall Adapter The presence of a Wall Adapter will override the other two sources.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 23 SUPERFLAG IN VIEW Ensure superflag in view OUT OF VIEW Ensure superflag out of view 4.3.3 ANNUNCIATOR TEST Select the Annunicator Test Page.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 24 except for RS232 channel 2. This channel is only tested at power on and the results displayed on this page. Therefore the unit must be turned off and the receiver/ transmitter connected or disconnected and then turn the unit on to perform the test.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 25 4.3.9 VHF COMM INTERFERENCE CHECK a) Go to the Satellite Status Page, verify that 7 to 8 satellites have been acquired b) See that the NAV flag is out of view c) Select 121.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 26 FIGURE 1-1 PINOUT DEFINITION, 37 PIN DSUB.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 27 FIGURE 1-2 PINOUT DEFINITION, 26 PIN HD-DSUB.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 28 FIGURE 1-3A INTERCONNECT SCHEMATIC.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 29 FIGURE 1-3B INTERCONNECT SCHEMATIC.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 30 FIGURE 1-3C INTERCONNECT SCHEMATIC.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 31 FIGURE 1-4 INTERCONNECT SCHEMATIC NOTES.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 32 Maintain 6"(16 cm) compass safe distance FIG 2-2 GNC 300 INSTALLATION CONSIDERATIONS FIG 2-1 GPS ANTENNA INSTALLATION CONSIDERATIONS A ntenna masked by vertical fin, T tail, or dorsal fin A ntenna must be on top of aircraft.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 33 FIGURE 2-3 SWITCH/ANNUNCIATOR LAYOUT.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 34 FIG 3-1 STUD MOUNT GA 56 ANTENNA INSTALLATION.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 35 FIGURE 3-2 FLANGE MOUNT GA 56 ANTENNA INSTALLATION.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 36 FIGURE 3-3 COAX CABLE INSTALLATION.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 37 FIGURE 3-4 AVIATION RACK DIMENSIONS.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 38 FIGURE 3-5 AVIATION RACK INSTALLATION.
APPENDIX A CERTIFICATION DOCUMENTS (19,5210(17$/48$/,),&$7,21)250 120(1&/$785( *1&*36$,5%251(51$9&2006<67(0 7<3(02'(/3$57.
7KHLQIRUPDWLRQOLVWHGEHORZSURYLGHVH[DPSOH VRQO,WLVQRWLQWHQGHGWREHDFRPSUHKHQVLYH OLVWLQJRIDOOWHVWFRQGLWLRQV &RQGLWLRQV .
(19,5210(17$/48$/,),&$7,21)250 120(1&/$785( *$*36$9,$7,21$17(11$ 7<3(02'(/3$5712 762.
7KHLQIRUPDWLRQOLVWHGEHORZSURYLGHVH[DPSOHVRQO,WLVQRWLQWHQGHGWREHDFRPSUHKHQVLYH OLVWLQJRIDOOWHVWFRQGLWLRQV &RQGLWLRQV 6.
APPENDIX B CONNECTOR CHANGES STAMPED CONTACT CONNECTOR USAGE Garmi n panel m ount GPS radios h ave prev iously been shipped w ith s tam ped crimp t ype con tacts. All products are n ow being shipped w ith m achined m il-spec contacts w ith color-coded barrels.
REMOTE BATTERY PIN ASSIGNMENTS A change w as m ade to the rem ote battery connect ors startin g w ith serial nu mbers 33050055. Units wi th low er seri al nu mbers hav e pin contact s on th e battery pack.
APPENDIX C STC PERMISSION Consistent with N8110.69 or Order 8110.4, Aviation Authority approved installers are hereby granted permission to use STC# SA00372WI data to modify aircraft.
Av. Kit Install. Manual 190-00067-02 Rev. J Page 46.
Een belangrijk punt na aankoop van elk apparaat Garmin gnc 300 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Garmin gnc 300 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Garmin gnc 300 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Garmin gnc 300 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Garmin gnc 300 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Garmin gnc 300 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Garmin gnc 300 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Garmin gnc 300 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
