Gebruiksaanwijzing /service van het product 4.10ESiVH van de fabrikant Alto-Shaam
Ga naar pagina of 28
MN-29805 • 08/12 printed i n u . s . a . Combitherm ® Combination Oven / Steamer CT EXPRESS™ 4•10es i 4•10esiVH • InstallatIon W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA PHONE: 262.251.
i Delivery .................................. 1 Unpacking ................................ 1 Safety Procedures and Precautions ............. 2 Installation Site Installation .......................... 3 Ventilation Requirements ................... 3 Positioning on Site .
INSTALLATION MANUAL • 1. DELIVERY This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier.
INSTALLATION MANUAL • 2. CAUTION Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored.
INSTALLATION MANUAL • 3. SITE INSTALLATION INSTALLATION DANGER IMPROPER INSTALLATION, ALTERATION, ADJUSTMENT, SERVICE, OR MAINTENANCE COULD RESULT IN SEVERE INJURY, DEATH, OR CAUSE PROPERTY DAMAGE.
INSTALLATION MANUAL • 4. NOTE: Note dimensions required for doorways and aisles for access of the oven and pallet to the installation site. Transport the oven in an upright and level position only. Do not tilt the oven.
INSTALLATION MANUAL • 5. LIFTING INSTRUCTIONS INSTALLATION Remove banding before lifting. Lift the unit from either side of the unit, never from the front o r back . Adjust the forks so that they do not damage any of the components under the unit.
INSTALLATION MANUAL • 6. SITE INSTALLATION INSTALLATION EXHAUST VENT 18" (46cm) 4" (102mm) 4" (102mm) 20" (50cm) MINIMUM 20" (50cm) POSITIO.
INSTALLATION MANUAL • 7. ACCESSORIES CombiClean® Tablets — CE-28892 s P E c i a l l y F O r M u l a t E d FOr cOMbitHErM OvENs ➥ t w O (2) c O N t a i N E r s .
INSTALLATION MANUAL • 8. WATER REQUIREMENTS WATER QUALITY MINIMUM STANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET : 3/4" G* LI NE PR ES SU RE: 30 to 90 psi 2.
INSTALLATION MANUAL • 9. WATER REQUIREMENTS WATER QUALITY MINIMUM STANDARDS ONE (1) COLD W A TER INLETS - DRINKING QUALITY ONE (1) W A TER INLET : 3/4" G* LI NE PR ES SU RE: 30 to 90 psi 2.
INSTALLATION MANUAL • ELECTRICAL CONNECTION INSTALLATION DANGER ENSURE POWER SOURCE MATCHES VOLTAGE IDENTIFIED ON APPLIANCE RATING TAG.
INSTALLATION MANUAL • 11. ELECTRICAL CONNECTION INSTALLATION DANGER ELECTRICAL CONNECTIONS MUST BE MADE BY A QUALIFIED SERVICE TECHNICIAN IN ACCORDANCE WITH APPLICABLE ELECTRICAL CODES.
INSTALLATION MANUAL • 12. MOBILE EQUIPMENT RESTRAINT INSTALLATION Any appliance that is not furnished with a power supply cord but includes a set of casters, stand with casters, or a stacked configuration must be installed with a tether.
INSTALLATION MANUAL • 13. INSTALLATION WATER QUALITY REQUIREMENT WARNING TO PREVENT WATER PIPES FROM BURSTING, INCOMING WATER SUPPLY SHOULD BE TURNED OFF WHEN THE APPLIANCE IS NOT IN USE. WARNING WATER SUPPLY MUST BE OPEN WHEN CLEANING PROGRAM IS ACTIVATED.
INSTALLATION MANUAL • 14. INSTALLATION WATER CONNECTIONS WATER SUPPLY & INSTALLATION WATER REQUIREMENTS ONE (1) COLD WATER INLET - DRINKING QUALITY ONE (1) TREATED WATER INLET: 3/4" G LINE PRESSURE: 30 to 90 psi 2.
INSTALLATION MANUAL • 15. INSTALLATION OPTIONAL HAND HELD SPRAY HOSE V alve bracket INSTALLATION 1 Using the valve bracket as a template for placement, and a #28 drill bit (0.14" diameter), drill two holes at the lower rear side of the unit (same side as door opening).
INSTALLATION MANUAL • 16. INSTALLATION WATER VALVE WATER DRAINAGE NOTE: THE SHUT-OFF VALVE MUST BE IN THE OPEN POSITION WHEN THE OVEN IS BEING USED. The oven must discharge through an indirect waste pipe by means of an air gap.
INSTALLATION MANUAL • 17. INDICATOR LIGHT If the indicator light does not illuminate, the filters may be missing or not properly aligned. Check them for proper positioning. Ventless hood and oven will not operate unless the hood is closed properly.
INSTALLATION MANUAL • 18. INSTALLATION VENTLESS HOOD MODEL TOP EXHAUST VENT 1 Charcoal Filter: The charcoal filter should be inspected for contaminant's on a regular basis.
INSTALLATION MANUAL • 19. INSTALLATION CT EXPRESS™ CHECKLIST Use this list as a nal check of oven installation conformance. Damage directly attributed to improper set up, installation, or cleaning can invalidate warranty claims.
INSTALLATION MANUAL • continued on next page ERROR CODES This section is provided for the assistance of qualified technicians only and is not intended for use by untrained or unauthorized service personnel.
INSTALLATION MANUAL • 21. continued on next page ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E13 .
INSTALLATION MANUAL • 22. ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E34 Steam Generator Drain .
INSTALLATION MANUAL • 23. ERROR CODES Error Code Error Call Out in Display Description of Error Possible Cause E57 No Rinse Water During rinse no water .
INSTALLATION MANUAL • 24. ERROR CODES When the oven malfunctions, an error code will appear in the display . PRESS THE ST AR T ICON TO ACKNOWLEDGE THE ERROR. The icons that begin to flash repr esent operational modes that are still usable.
INSTALLATION MANUAL • 25. ORIGINAL EQUIPMENT LIMITED WARRANTY Alto-Shaam, Inc. warrants to the original purchaser that any original part that is found to be defective in material or workmanship will, at Alto-Shaam’s option, subject to provisions hereinafter stated, be replaced with a new or rebuilt part.
TRANSPORTATION DAMAGE AND CLAIMS All Alto-Shaam equipment is sold F.O.B. shipping point, and when accepted by the carrier, such shipments become the property of the consignee. Should damage occur in shipment, it is a matter between the carrier and the consignee.
Een belangrijk punt na aankoop van elk apparaat Alto-Shaam 4.10ESiVH (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Alto-Shaam 4.10ESiVH heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Alto-Shaam 4.10ESiVH vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Alto-Shaam 4.10ESiVH leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Alto-Shaam 4.10ESiVH krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Alto-Shaam 4.10ESiVH bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Alto-Shaam 4.10ESiVH kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Alto-Shaam 4.10ESiVH . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
