Gebruiksaanwijzing /service van het product Advantium PSB1200BB van de fabrikant GE
Ga naar pagina of 20
Installation Instructions Advantium ® 120V Built-In SpeedCook Ovens PSB1200 PSB1201 ZSC1201 ZSC1202 For a Spanish version of this manual, visit our Website at ge.com. Para consultar una version en español de este manual de instrucciones, visite nuestro sitiode internet ge.
Safety Information 2 CONTENTS Design Information Models Available ......................................................................2 Product Dimensions and Clearances ............................3 T ools and Parts Required .......................
Design Information 3 PRODUCT DIMENSIONS AND CLE ARANCES NOTE: Appearance will vary by model. 19 1/32” 29 3/4” T OOLS AND P AR TS REQUIRED (NO T SUPPLIED ) • #2 Phillips screwdriv er • Hand-hel.
Installation Pr eparation 4 ELECTRICAL REQUIREMENTS Single Advantium 120 Installation: This product r equires a 120-volt , 60 Hz, 15-amp circuit and draws 1.8 kilowatts. This pr oduct must be connected to a supply circuit of the pr oper voltage and frequency.
5 Installation Pr eparation Pr eparation WITHOUT an Accessory St orage Drawer PREP ARE THE OPENING (cont .) Installation over a GE/Monogram Warming Drawer : NO TE: Additional clearances between the cutouts may be requir ed. Check to be sure the oven supports above the Warming Drawer location do not obstruct the requir ed interior depth and height .
Installation Pr eparation 6 Pr eparation WITHOUT an Accessory St orage Drawer PREP ARE THE OPENING (cont .) Installation over a GE/Monogram Oven and Warming Drawer : NO TE: Additional clearances between the cutouts may be requir ed.
7 Installation Pr eparation Pr eparation WITHOUT an Accessory St orage Drawer PREP ARE THE OPENING (cont .) Installation under a GE/Monogram Microwave Oven and over a W arming Drawer : NO TE: Additional clearances between the cutouts may be requir ed.
PREP ARE THE OPENING (cont .) Installation beside another GE/Monogram Built-in Speedcook Oven: • If you are mounting one Under -the-Counter GE/Monogram oven beside the other , use the dimensions shown. The middle rail separating the two openings may need to be larger than the 4-1/2 ″ minimum shown.
9 Installation Pr eparation Pr eparation WITH an Accessory St orage Drawer NO TE: MODEL ZSC1201 CAN ONL Y BE INST ALLED WITH AN A CCESSORY ST ORAGE DRA WER IF INST ALLED ABOVE 36-3/4 ″ . MODEL ZSC1202 CANNO T BE INST ALLED WITH AN ACCESSORY ST ORAGE DRA WER.
10 Installation Pr eparation Pr eparation WITH an Accessory St orage Drawer NO TE: MODEL ZSC1201 CAN ONL Y BE INST ALLED WITH AN A CCESSORY ST ORAGE DRA WER IF INST ALLED ABOVE 36-3/4 ″ . MODEL ZSC1202 CANNO T BE INST ALLED WITH AN ACCESSORY ST ORAGE DRA WER.
11 Installation Pr eparation Pr eparation WITH an Accessory St orage Drawer NO TE: MODEL ZSC1201 CAN ONL Y BE INST ALLED WITH AN A CCESSORY ST ORAGE DRA WER IF INST ALLED ABOVE 36-3/4 ″ . MODEL ZSC1202 CANNO T BE INST ALLED WITH AN ACCESSORY ST ORAGE DRA WER.
12 Installation Pr eparation Cooktop Cooktop 25 ″ 1-1/2 ″ Min. 4 ″ High T oekick 23-1/2 ″ 25-1/4 ″ 21 ″ 36 ″ Countertop Height PREP ARE THE OPENING (cont .) Installation beside another GE/Monogram Built-in Speedcook Oven: • If you are mounting one Under -the-Counter GE/Monogram oven beside the other , use the dimensions shown.
REMOVE THE P ACKA GING AND P ARTS 1 13 Installation Instructions • Remove all packing material and tape. • Locate parts package containing mounting screws. • Remove the oven fr om the carton. Do not lift unit by handle or conduit . Two people are r equired to lift this oven.
Installation Instructions 14 SLIDE THE OVEN INT O THE CUTOUT CA UTION: Two people are r equired to lift the oven into the opening. Grasp the bottom at front and r ear . DO NOT USE THE HANDLE T O LIF T THE OVEN. DAMA GE WILL OCCUR . • Lift and hold the oven at the fr ont of the opening.
15 Installation Instructions INST ALL MOUNTING SCREWS • Slide the oven the remaining w ay into the opening so that the side flanges and control panel ar e against the cabinet frame. Make sure that the ov en is centered in the opening. • Open the door , place a turntable tray in the oven and make sure that the tray in the unit is lev el.
16 GE Consumer & Industrial Appliances Assembly Instructions Advantium ® Built -In Accessory St orage Drawer JX2200, JX2201, ZX2201 NO TE: Appearance will vary by model.
UNDER-THE-COUNTER (UT C) MOUNTING BRACKET INST ALL A TION NO TE: For UTC models PSB1200, PSB1201 and ZSC1201 only. Open the accessory drawer so you have access to the top bracket . Remove the three scr ews securing the top bracket . Install the new UTC mounting brack et using the screws r emoved previously.
18 ASSEMBLING THE OVEN T O DRA WER (cont .) Remove the fr ont two bottom screws on each side of the oven and the top center screw on each side of the storage drawer . Place the side supports into the tabs on the drawer and secure using the scr ews supplied and the screws r emoved in Step C.
19 Notes.
Printed in Korea NOTE: While performing installations described in this book , safety glasses or goggles should be worn. NOTE: Product improv ement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice.
Een belangrijk punt na aankoop van elk apparaat GE Advantium PSB1200BB (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen GE Advantium PSB1200BB heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens GE Advantium PSB1200BB vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding GE Advantium PSB1200BB leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over GE Advantium PSB1200BB krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van GE Advantium PSB1200BB bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de GE Advantium PSB1200BB kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met GE Advantium PSB1200BB . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.