Gebruiksaanwijzing /service van het product 6321L van de fabrikant Grindmaster
Ga naar pagina of 40
Crathco Beverage Freezers Service Manual for Model 6321L TABLE OF CONTENTS Description........................................... 2 - 3 Unpacking............................................ 3 - 4 Assembly & Installation....................... 4 - 6 Sanitizing and Starting Unit .
The Model 6321L is a freezer that dispenses frozen carbonated alcoholic beverages (see photo on front cover). The freezer has two major components, the freezer sections (dispense head) and the product feed system (lower cabinet area).
The freezer is equipped with an automatic defrost system to allow the frozen product to melt back to a liquid. This eliminates any large ice crystal formation or poor product consistency that may develop. This automatic timer can be pre-programmed to occur at desired times of the day.
Periodic Inspection Freezer Assembly and Installation 1) Check the CO 2 tank pressure gauge on the cylinder regulator assembly. Replace if tank pressure drops below red line. 2) Make sure the unit contains a sufficient supply of syrup and alcohol. 3) Check to see that there is sufficient air space on both sides of the unit.
1) The drip tray is mounted on two screws that are located on the lower front of the freezer cabinet. 2) Place the key hole slot of the drip tray support bracket W0471022 on to these screws and tighten the screws. 3) Angle the back of the drip tray surround bracket into the drip tray support bracket W0471022 and lower bracket to lock it into place.
NOTE: CO 2 regulators are pre-set at the factory. Check for accuracy. 1) Adjust the CO 2 regulator that drives the bag-in-box syrup pump and alcohol pump to 60 psi. Turning regulator adjustment clockwise raises the pressure. Tighten locknut at this setting.
Adding Product Connecting Syrup Supply 1) Open new bag-in-box as instructed on box. 2) Connect red QCD syrup connector to new bag-in-box. 3) Repeat for second bag-in-box. NOTE: Make sure that the BIB lines run behind the bottle rack line so the bottle rack can be slid open easily.
6) If the volume is not 3.7 oz. (110 ml), consult the Troubleshooting Guide in this manual. Note: Due to the thick viscosity of the syrup, it may be necessary to purge the syrup line to obtain an accurate flow rate reading.
NOTE: Before cleaning, all product should be drained from the freezing cylinder, pres - sure vented, and either the valves set closed or product removed from the machine. 1) Disassemble the dispensing valve by first removing the dispensing valve pin (Figure 12) 2) Push up on the dispensing valve plunger and pull out the dispensing handle.
NOTE: The following product consistency (thickness) control adjustment procedure requires removal of the right side panel. It is suggested that a qualified service technician make this adjustment because side panel removal exposes hazardous moving parts.
BRIX Correct BRIX effects product flavor and freezing characteristics. Frozen product with low BRIX may have a weak fla - vor, larger ice crystals, and a tendency to dispense slowly. Product with high BRIX has an overly strong flavor, increased portion cost and results in lower freezer output capacity.
Operating Freezer Unit Operation 1) Check that a "Mix Out" light is not illuminated. This indicates the freezer has an adequate amount of syrup, CO 2, alcohol and water (only one light will be ON at a time). Check machine after each product is filled.
Service and Maintenance Servicing Dispensing Valves, O-Rings, and Freeze Cylinder Drive Shaft/Seal Assemblies NOTE: Dispensing valve "O" Rings should be replaced every 120 days to correspond with quarterly preventative maintenance visits.
Drive Belt Adjustment CAUTION: Unplug the machine before performing any adjustments. Check the belt tension quarterly. Proper belt tension is ½" deflection measured mid way between the drive and driven pulleys.
Part Description Monthly Every 3 Months Every 6 Months Annually Quantities to be Replaced Drive shaft seal W0340210 Inspect & replace if necessary Replace 1 Drive shaft W0451067 Inspect & repl.
Problem Probable Cause Remedy Machine won’t run (no lights, not motor) • Machine not plugged into wall receptacle • Building circuit breaker tripped or fuse blown • Switches in wrong position • Plug machine directly into outlet. Do not use extension cord.
Addendum 1 - Complete Unit Exploded View ITEM PART # DESCRIPTION 1 W0150590 Stock Assembly 2 00800 Serial Label 4 W0800120 Base Board Assembly 5 W0800121 Shipping Box 6 W0800122 L-Block 7 W0800124 Foa.
Page 18 Crathco Beverage Freezers Regulators Alcohol Valve/Control Syrup Valve/Control Test Port Water Valve/Control Carbonator Water Pump Addendum 2 - Base Cabinet POWER ON OFF SAMPLE TIMER OFF ON CO.
Addendum 3 - Electrical Connections in Lower Cabinet Addendum 4 - Electrical Connections in Lower Cabinet Addendum 5 - Electrical Connections Cabinet to Freezer Crathco Beverage Freezers Page 19 29 28.
Addendum 6 - 6321 Base Cabinet Electrical Schematic ITEM PART NUMBER DESCRIPTION 30 W0570045 BALLAST 61 W0570235 TERMINAL BLOCK 32 90811 TIMER 33 61847 POWER SWITCH 34 61847 TIMER SWITCH 45 W0570924 S.
Addendum 7 - 6321L-A Ladder Diagram Crathco Beverage Freezers Page 21.
Addendum 8 - 6321 Freezer Electrical Schematic ITEM LENGTH DESCRIPTION 72 W0570662 RELAY SOCKET 71 W0570661 RELAY 70 W0570682 TIMER 69 W0570242 SPLICE CAPS 67 60110 PIGGYBACK TERMINAL 56 60034 LIGHT, .
Addendum 9 - Product Flow Schematic Crathco Beverage Freezers Page 23.
Addendum 10 - 6321 Base Cabinet Panels Exploded View ITEM PART NO. DESCRIPTION 1 90780 PANEL, BOTTOM ASSY, BASE CART 2 90727 PANEL ASSY, INTERIOR, BASE CART 3 90746 ALCOHOL HOLDER 4 90827 TOP PANEL AS.
Addendum 11 - 6321 Base Cabinet Exploded Parts View Crathco Beverage Freezers Page 25.
ITEM PART NO. DESCRIPTION 1 90726 PANEL, INTERIOR-BASE CART 2 90729 SYRUP PUMP 3 90730 FITTING, SHURFLO TO 3/8” JOHN GUEST 4 90875 SWITCH, PRESSURE, BARKSDALE-40 PSI 5 W0620283 ADAPTER, 1/8” FPT X.
Addendum 12 - Rack Exploded View ITEM NO. PART NO. DESCRIPTION 1 90751 MNT BRACKET, LEFT, BERG ALCOHOL HOLDER ASSY 2 90752 MNT BRACKET, RIGHT, BERG ALCOHOL HOLDER ASSY 3 90794 3/8” X 3/8” X 3/8” BARB TEE 4 61153 TUBING, BRAIDED .375” ID X .625” OD X 2.
Addendum 13 - 6321 Cabinet Base Exploded View Page 28 Crathco Beverage Freezers.
ITEM PART NO. DESCRIPTION 1 90723 PANEL, BOTTOM-BASE CART 2 W0630900 CASTER, RIGID-TWIN BASE CART 3 W0630898 CASTER, SWIVEL-TWIN BASE CART 4 W0611086 NUT, 5/16-18 HEX ZINC 5 W0611255 WASHER, 5/16 LOCK.
Addendum 14 - 6321 Base Cart Top Panel Exploded View ITEM PART NO. DESCRIPTION 1 90722 PANEL, TOP-BASE CART 2 90840 REGULATOR ASSEMBLY 3 W0570043 BULB, FLUORESCENT 4 W0570044 SOCKET, LIGHT-LEVITON 5 9.
Addendum 15 - 6321 Front Cabinet Door ITEM PART NO. DESCRIPTION 1 90721 DOOR, FRONT-BASE CART 2 90851 DOOR HINGE, STANDARD DUTY 3 W0610923 PEM STUD, 8-32 X 3/8” 4 61339 8-32 UNF S.
Addendum 16 - Rear Door and Key ITEM NO. PART NO. DESCRIPTION 1 90720 DOOR, REAR-BASE CART 2 W0610921 PEM STUD, 8-32 X 1/4” 3 61339 8-32 UNF S.S. ACORN NUT 4 90851 DOOR HINGE, STANDARD DUTY 5 90771 .
ITEM PART # DESCRIPTION 10 W0610682 5/16-18 x 3/4 Hex Hd Cap Screw 20 W0611254 5/16 Flat Washer 30 W0611255 5/16 Split Lock Washer 40 W0611086 5/16-18 Hex Nut Z/P 50 W0201191 Suction Line Pressure 60 .
ITEM Part # Description 1 W0201001 Compressor Assembly 2 W0201000 Condenser Assembly 3 W0320129 Fan Sub-Assembly 4 W0321026 Drive Motor Assy. 5 W0210106 Base Pan Assy.
ITEM PART # DESCRIPTION 1 W0570603 Start Capacitor 2 W0570617 Run Capacitor 3 W0630006 Heyco Bushing 4 W0630811 Clip, Capacitor (small) 5 W0570638 Compressor Relay 6 W0572409 Relay Bracket 7 W0570656 .
ITEM PART # DESCRIPTION 1 W0340011 #115 O-ring (Carburetor) 2 W0471115 Pressure Inlet Fill 3 W0471118 Pressure Inlet Fill Retainer 4 W0650400 Press Switch MSPS - JJ100SS-F 5 60552 Accumulator 6 W06202.
Addendum 21 - Refrigeration Components ITEM Part # Description 1 W0650501 Access Valve 2 W0650112 Filter Drier 3 W0201191 Suction Line 4 W0200123 Compressor 5 W0200256 Condenser 6 W0201009 Hot Gas Lin.
Addendum 22 - Refrigeration Schematic Page 38 Crathco Beverage Freezers.
Crathco Beverage Freezers Page 39 NOTES.
Cocktail Machine Indemnity The Purchaser and/or Lessee hereby releases the manufacturer of this machine, Grindmaster Crathco Systems, Inc. (the Company), any and all alcohol and non-alcohol product co.
Een belangrijk punt na aankoop van elk apparaat Grindmaster 6321L (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Grindmaster 6321L heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Grindmaster 6321L vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Grindmaster 6321L leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Grindmaster 6321L krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Grindmaster 6321L bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Grindmaster 6321L kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Grindmaster 6321L . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
