Gebruiksaanwijzing /service van het product CW-216 van de fabrikant Henny Penny
Ga naar pagina of 24
Henny Penny Display Counter W armer Model CW -216/CW -1 14 OPERA T OR’S MANUAL REGISTER W ARRANTY ONLINE A T WWW .HENNYPENNY .COM.
.
Model CW -216/CW -1 14 FM05-020-F Revised 1 1-27-07 LIMITED W ARRANTY FOR HENNY PENNY EQUIPMENT Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to t.
Model CW -216/CW -1 14 T ABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... 1 - 1 1-1. Display Counter W armer .................................
Model CW -216/CW -1 14 SECTION 1. INTRODUCTION 1-1. DISPLA Y COUNTER The Henny Penny Display Counter W armer is a basic unit of W ARMER food processing equipment used to display the food product and maintain the temperature of hot foods in the commercial food service operation.
Model CW -216/CW -1 14 1-2 203 1-5. SAFETY The only way to insure safe operation of the Henny Penny Display Counter W armer is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures.
Model CW -216/CW -1 14 SECTION 2. INST ALLA TION 2-1. INTRODUCTION This section provides the installation instructions for the Henny Penny Display Counter W armer .
Model CW -216/CW -1 14 2-2. UNP ACKING (Continued) 2. Open top flaps and remove packing. Step 2 3 . Lift carton off skid. Step 3 4. Remove four bolts from under skid.
Model CW -216/CW -1 14 2-3. LOCA TION Place the unit on a table, preferably with a cut-out opening below the cabinet to allow easy service connections and serviceability . When setting up the Henny Penny Display Counter W armer , be sure to level the table.
Model CW -216/CW -1 14 2-5. DRAIN CONNECTION The drain can be connected to a 1 inch N.P .T . directly below the water well or to a 3/4 inch N.P .T . from the operator ’ s side. W e recommend the 1 inch N.P .T . connection as this allows straight down draining of the water .
Model CW -216/CW -1 14 2-6. ELECTRIC CONNECTION The electrical power can be connected from the bottom or from (Continued) the operator ’ s side. There is a 1-3/32 inch diameter hole from either connection. Again, we recommend the bottom connection as this will give a cleaner appearance to the unit.
Model CW -216/CW -1 14 2-8. W A TER SUPPL Y CONNECTION (Continued) This unit as manufactured requires the installation of an appro- priate back-siphoning device (as per National Plumbing Code ASA-A40:8-1955) to be connected to the water inlet line.
Model CW -216/CW -1 14 2-10. CABINET DIMENSIONS 203 2-7.
Model CW -216/CW -1 14 SECTION 3. OPERA TION 3-1. INTRODUCTION This section provides the daily operating procedure for your display counter warmer . Read the Introduction Section and this section before operating the cabinet. Also, refer to the Installation Section to b e sure the cabinet has been properly installed.
Model CW -216/CW -1 14 3-2 1107 3-2. OPERA TING CONTROLS (Continued) Figure 3-3 Figure 3-4 Figure 3-5 Figure 3-1 Figure 3-2 8.
Model CW -216/CW -1 14 1 107 3-3 3-2. OPERA TING CONTROLS (Continued) Figure 3-6 Figure 3-7 Figure 3-10 Figure 3-1 1 Figure 3-8 Figure 3-9.
Model CW -216/CW -1 14 Fig. Item No. No. Description Function 3 - 1 1 W ater valve An electrical solenoid valve energized by the float switch or the water control switch (in manual position); when ope.
Model CW -216/CW -1 14 Fig. Item No. No. Description Function 3 - 9 1 8 Power Light Illuminates when the power switch is on and the heat and water system controls are energized; if the power light goe.
Model CW -216/CW -1 14 3. Place pans into the water pan insert. 4. Install and close the doors. 5. T urn the power switch to the ON position. 6. T urn the light switch to the ON position. 7. T urn the radiant heat switch to the desired setting. W e recommend stating at 6 for the lower radiant.
Model CW -216/CW -1 14 3-5. SHUT -DOWN AND 1. T urn the water thermostat to OFF . CLEAN-UP 2. T urn the radiant heat to OFF . 3. T urn the water control switch to OFF . 4. Remove the doors. 5. Remove all the pans. 6. Remove the drain standpipe. 7. Remove the insert from the water pan and clean with soap and water at sink.
Model CW -216/CW -1 14 4-1. TROUBLESHOOTING GUIDE Product not • Doors are not kept closed • Keep doors closed when holding possible temperature • Product held too long • Only hold product for .
Model CW -216/CW -1 14 G L O S S A R Y HENNY PENNY HOLDING CABINETS air temperature probe a round device located inside the cabinet that measures the inside air temperature and sends that information .
Model CW -216/CW -1 14 probe clip a metal holder that attaches to the outside of the control panel to hold the food probe when not in use; the clip is an optional accessory product load capacity the h.
*FM05 - 020 - F * Henny Penny Corp., Eaton, Ohio 45320, Revised 11-27-07 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax www.
Een belangrijk punt na aankoop van elk apparaat Henny Penny CW-216 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Henny Penny CW-216 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Henny Penny CW-216 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Henny Penny CW-216 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Henny Penny CW-216 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Henny Penny CW-216 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Henny Penny CW-216 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Henny Penny CW-216 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
