Gebruiksaanwijzing /service van het product HCW-2 van de fabrikant Henny Penny
Ga naar pagina of 26
Henny Penny Humidified Counter W armer Model HCW -2 Model HCS-2 Model HCW -3 Model HCW -5 Model HCS-5 Model HCW -8 OPERA T OR’S MANUAL.
.
Model HCS-2/HCW-3/HCW-5/HCW-8 FM05-019-F Revised 02-14-07 LIMITED W ARRANTY FOR HENNY PENNY EQUIPMENT Subject to the following conditions, Henny Penny Corporation makes the following limited warrantie.
Model HCS-2/HCW-3/HCW-5/HCW-8 T ABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... 1 - 1 1-1. Heated Display Cabinet ...........................
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 1. INTRODUCTION 1-1. HEA TED DISPLA Y The Henny Penny Heated Display Cabinet is a basic unit of food CABINET processing equipment used to display the food product and maintain the temperature of hot foods in the commercial food service operation.
Model HCS-2/HCW-3/HCW-5/HCW-8 1-5. SAFETY The only way to ensure safe operation of the Henny Penny Heated Display Cabinet is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures.
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 2. INST ALLA TION 2-1. INTRODUCTION This section provides the installation instructions for the Henny Penny Heated Display Cabinet. Installation of this unit should be performed only by a qualified service technician.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-2. UNP ACKING (Continued) 2. Open top flaps and remove packing. 3. Lift carton off skid. 4. Remove four bolts from under skid.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-3. LOCA TION Place the unit on a table, preferably with a cut-out opening below the cabinet to allow easy service connections and serviceability . When setting up the Henny Penny Heated Display Cabinet, be sure to level the table.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-5. DRAIN CONNECTION The drain can be connected to a 1 inch N.P .T . directly below the water well or to a 3/4 inch N.P .T . from the operator ’ s side. W e recommend the 1 inch N.P .T . connection as this will allow straight down draining of the water .
Model HCS-2/HCW-3/HCW-5/HCW-8 2-6. ELECTRICAL CONNECTION The electrical power can be connected from the bottom or from the (Continued) operator ’ s side. There is a 1-3/32 inch diameter hole for either connection. Again, we recommend the bottom connection as this will give a cleaner appearance to the unit.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-8. W A TER SUPPL Y CONNECTION (Continued) This unit as manufactured requires the installation of an appropriate back-siphoning device (as per National Plumbing Code ASA-A40.8-1955) to be connected to the water inlet line.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS 1006 2-7 Model HCS-2 Model HCW-3.
Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS (Continued) 2-8 1006 Model HCW-5.
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 3. OPERA TING INSTRUCTIONS 3-1. INTRODUCTION This section provides operating procedures for the heated display cabinets. The Introduction, Installation and Operation sections should be read, and all instructions should be followed before operating the cabinet.
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERA TING CONTROLS (Continued) 3-2 1 03 Figure 3-1 Figure 3-2 Figure 3-3 Figure 3-4 Figure 3-5 Figure 3-6.
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERA TING CONTROLS (Continued) 103 3 - 3 Figure 3-7 Figure 3-8 Figure 3-9 Figure 3-10 Figure 3-1 1 Figure 3-12.
Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3- 1 1 W ater V alve An electrical solenoid valve energized by the float switch or the water control switch (in manual position) th.
Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3-10 13 W ater Control A three-position switch with center position being OFF; Switch i n the position marked AUTOMA TIC (up), the .
Model HCS-2/HCW-3/HCW-5/HCW-8 Fig. Item Description Function No. No. 3 - 11 2 2 Float Switch An electro-mechanical sensing device used to automati- cally control the water level in the water pan; the .
Model HCS-2/HCW-3/HCW-5/HCW-8 4. Install the perforated bun pans over the water well. This will help in a more rapid heat up of the water . 5. Close the doors. 6. Turn the power switch to the ON position. 7. T urn the light switch to the ON position. 8.
Model HCS-2/HCW-3/HCW-5/HCW-8 3-5. SHUT -DOWN AND 1. T urn the water thermostat to OFF . CLEANUP 2. T urn the radiant heat to OFF . 3. T urn the water control switch to OFF . 4. Open the doors. 5. Remove all the pans. 6. Remove the drain standpipe. 7.
Model HCS-2/HCW-3/HCW-5/HCW-8 4-1. TROUBLESHOOTING GUIDE Product not • Doors are not kept closed • Keep doors closed when holding possible temperature • Product held too long • Only hold produ.
Model HCS-2/HCW-3/HCW-5/HCW-8 G L O S S A R Y HENNY PENNY HOLDING CABINETS air temperature probe a round device located inside the cabinet that measures the inside air temperature and sends that infor.
Model HCS-2/HCW-3/HCW-5/HCW-8 probe clip a metal holder that attaches to the outside of the control panel to hold the food probe when not in use; the clip is an optional accessory product load capacit.
*FM0 5 - 0 19 - F * Henny Penny Corp., Eaton, Ohio 4532 0, R evised 02-14-07 Henny Penny Corporation P.O.Box 60 Eaton,OH 45320 1-937-456-8400 1-937-456-8402 Fax Toll free in USA 1-800-417-8417 1-800-417-8434 Fax www.
Een belangrijk punt na aankoop van elk apparaat Henny Penny HCW-2 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Henny Penny HCW-2 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Henny Penny HCW-2 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Henny Penny HCW-2 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Henny Penny HCW-2 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Henny Penny HCW-2 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Henny Penny HCW-2 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Henny Penny HCW-2 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
