Gebruiksaanwijzing /service van het product KM-250BWF van de fabrikant Hoshizaki
Ga naar pagina of 21
™ INSTRUCTION MANUAL ISSUED: March 14, 2000 KM-250BAF KM-250BWF SELF-CONT AINED CRESCENT CUBER R eliability is a beautiful thing TM REVISED: December 22, 2004.
2 Only qualified service technicians should attempt to install, service or maintain this icemaker. No installation, service or maintenance should be undertaken until the technician has thoroughly read this Instruction Manual.
3 CONTENTS I. Specifications .............................................................................................................. ...... 4 1. Nameplate Rating ..................................................................................
4 I. Specifications 1. Nameplate Rating [a] KM-250BAF (air-cooled) See the nameplate for electrical and refrigeration specifications. This nameplate is located on the upper right hand side of the rear panel.
5 [b] KM-250BWF (water-cooled) See the nameplate for electrical and refrigeration specifications. This nameplate is located on the upper right hand side of the rear panel.
6 2. Dimensions/Connections [a] KM-250BAF Units: millimeters (inches).
7 [b] KM-250BWF Units: millimeters (inches).
8 II. Installation and Operating Instructions 1. Checks Before Installation IMPORT ANT 1. Remove shipping cartons, tape(s) and packing. If any are left in the icemaker, it will not work properly. 2. Ensure all components, fasteners and thumbscrews are securely in place.
9 2. Location IMPOR T ANT This icemaker is not intended for outdoor use. Normal operating ambient temperature should be within +45 ° F (7 ° C) to +100 ° F (38 ° C); Normal operating water temperature should be within +45 ° F (7 ° C) to +90 ° F (32 ° C).
10 4. W ater Supply and Drain Connections See Fig. 1 CA UTION To prevent damage to the equipment, do not operate the icemaker when the water supply is OFF, or if the pressure is below 10 PSIG (0.7 bar). Do not run the icemaker until the proper water pressure is reached.
11 KM-250BAF KM-250BWF Fig. 1.
12 5. Final Check List 1) Is the icemaker level? 2) Is the icemaker in a site where the ambient temperature is within +45 ° F (7 ° C) to +100 ° F (38 ° C) and the water temperature within +45 ° F (7 ° C) to +90 ° F (32 ° C) all year around? 3) Is there at least 6" (15 cm.
13 6. Startup CA UTION 1. All parts are factory-adjusted. Improper adjustments may result in failure. 2. If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent damage to the compressor. 1) Open the water supply line shut-off valve.
14 7. Preparing the Icemaker for Long Storage IMPOR T ANT When shutting off the icemaker for an extended time, drain out all water from the water line and remove the ice from the storage bin.
15 5) Allow the line to drain by gravity. 6) Attach compressed air or carbon dioxide supply to the potable water line drain valve. 7) Move the control switch to the “ ICE ” position. 8) Blow the potable water line out using compressed air or carbon dioxide.
16 III. Cleaning and Maintenance IMPORT ANT Ensure all components, fasteners and thumbscrews are securely in place after any maintenance or cleaning is done to the equipment. 1. Cleaning and Sanitizing Instructions W ARNING 1. HOSHIZAKI recommends cleaning this unit at least once a year.
17 4) Remove the plug at the bottom of the water tank to drain the tank. See Fig. 3. After draining, replace the plug in its correct position. 5) Pull out the cap at the front of the plastic body 1" or more. See Fig. 4. 6) Pour the cleaning solution into the water tank.
18 [c] Sanitizing Solution Dilute 1 fl. oz. (30 ml or 2 tbs) of 5.25% sodium hypochlorite solution (chlorine bleach) with 2 gallons (7.6 l) of warm water. Using a chlorine test strip or other method, confirm that you have a concentration of about 200 ppm.
19 14) Move the control switch to the “ ICE ” position to fill the water tank with water. 15) After 3 minutes, move the control switch to the “ OFF ” position. 16) Move the control switch to the “ WASH ” position. 17) After 5 minutes, move the control switch to the “ OFF ” position.
20 2. Maintenance IMPOR T ANT This icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker. 1) Exterior Panels To keep the exterior clean, wipe occasionally with a clean and soft cloth. Use a damp cloth containing a neutral cleaner to wipe off oil or dirt build up.
21 HOSHIZAKI HOSHIZAKI AMERICA, INC. 618 HIGHW A Y 74 SOUTH PEA CHTREE CITY , GA 30269 U.S.A. PHONE: 770-487-2331 91A1AQ10D.
Een belangrijk punt na aankoop van elk apparaat Hoshizaki KM-250BWF (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Hoshizaki KM-250BWF heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Hoshizaki KM-250BWF vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Hoshizaki KM-250BWF leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Hoshizaki KM-250BWF krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Hoshizaki KM-250BWF bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Hoshizaki KM-250BWF kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Hoshizaki KM-250BWF . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
