Gebruiksaanwijzing /service van het product 78410 van de fabrikant Kawasaki
Ga naar pagina of 38
Kawasaki ® ZX-7 Owner ’ s Manual with Assembly Instructions Please read this manual and save it with your original sale’s receipt. For Model 78410 T ools needed for assembly: Phillips Screwdriver , Slotted Screwdriver , Hammer , Safety Scissors.
W ARNING • Children can be harmed by small parts, sharp edges and sharp points in the vehicle’ s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle the battery or other parts, or help in assembly .
CAUTION • Do not operate the vehicle for the first time until you have inserted the 25 amp fuse into the battery and charged the batter y for at least 18 hours. Never charge the battery longer than 30 hours. • After first-time use, r echarge the batter y for at least 18 hours after each use.
T able of Contents A Message to Parents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 B Important Infor mation . . . . . . . . . . . . . . . . . . . . . .
Impor tant Infor mation • Carefully read this manual for important safety infor mation and operating instructions befor e using your vehicle. • Please complete and retur n the enclosed V ehicle Registration Card, or call 1-800-348-0751 to register your vehicle by phone.
Pa r t s C Not Shown: Literature Bag 6-V O L T C H A R G E R Small Parts Bag Hubcap – 2 Battery Retainer 6 If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store.
Wheel Bushing – 2 #6 x 3 / 8 " Screw – 2 #8 x 7 / 8 " Screw Cap Nut – 3* #8 x 1 1 / 2 " Screw – 4 25 Amp Fuse –2* Radio Knob – 2 Fairing Not Shown: Label Sheets 6 V olt Batt.
Par ts Diagram FOR MODEL 78410 6 VOL T 8 Kawasaki ® ZX-7 44 45 46 48 6 21 12 19 CHARGER 18 15 17 16 49 43 42 41 14 13 12 9 8 39 38 40 37 12 36 52 10 35 34 33 32 2 31 30 1 29 28 22 4 51 20 27 26 25 5 .
Par ts List E I tem No. Description Part No. Qty. 1 Battery 80008-0110 1 2 25 amp Fuse 80014-0070 1 3 Wheel Driver Screw 80006-0017 1 4 Foot Switch 80014-0022 1 5 Motor/Gearbox Assembly 74780-0640 1 6 Wiring Har ness 80064-0083 1 7 Driver 80001-0247 1 8 Windshield 80063-0068 1 9 Lens Cover Set 80030-0074 1 10 .
10 First-Time Batter y Charging F W ARNING • The battery must be handled by adults only . • Never allow childr en to charge the batter y . Batter y charging must be done by adults only . A child could be injur ed by the electricity involved in charging the batter y .
® ® • Squeeze the Lock-In TM connector tabs on the charger connector and plug it into the battery connector . • Plug the charger into a standard 120 volt wall outlet. Note: If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
Assembly Do Not Omit Any Steps. Please set aside at least 30 minutes for assembly . • Position a handlebar plug against the top end of a handlebar . • Moisten a hand grip with war m water . • Slide the hand grip onto the end of the handlebar . • Repeat this procedure to attach the other handlebar plug and handgrip to the other handlebar .
• Apply labels to the dashboard as shown. • Make sure the areas where the labels will be applied are clean and dry. • For best adhesion, avoid applying labels more than once.
• Insert the four tabs on the underside of the windshield into the holes in the fairing. • Press fir mly on the windshield to fit the tabs into the holes. 7 14 Windshield Assembly Fairing • Lay the vehicle body on its belly. • Fit the dashboard onto the top of the swivel bracket.
Assembly • Stand the vehicle body on its rear wheels. • Fit the fairing onto the front of the swivel bracket. • Align the screw holes in the front of the fairing with the holes in the swivel bracket. • Insert two #8 x 1 1 / 2 " screws into the fairing.
• Fit the fender onto the ends of the handlebars. • Slide the fender up the handle- bars to the fairing. 10 • Fit one end of the front axle into a cap nut. • T ap the front axle with a hammer to secure the cap nut on the front axle. 11 Assembly 16 12 • Remove the rubber bands from the shock sets and dispose of the rubber bands.
14 Assembly • Slide the front axle through the hole in the shock halves and handlebar . 13 17 15 • Fit and hold an inner shock half to the inside of a handlebar . • Fit and hold an outer shock half to the outside of the same handlebar . • Make sure the top ends of the shock halves fit into the fender .
18 Assembly • Fit and hold an inner shock half to the inside of the exposed handlebar . • Fit and hold an outer shock half to the outside of the same handlebar . • Make sure the top ends of the shock halves fit into the fender . 16 • Position the front wheel between the handlebars.
Assembly • Position the vehicle upright. • Apply headlight labels to the fairing as shown. • Make sure the areas where the labels will be applied are clean and dry. • For best adhesion, avoid applying labels more than once. 19 L • Align the “L” on the left headlight lens with the “L” in the left head- light on the fairing.
• Snap the gas cap into the vehicle body. 22 • Insert the tabs on the front of the seat into the vehicle body. • Lower the seat. 23 Assembly Proper label application will help to keep the labels looking their best! • W ash your hands before applying the labels.
• Lift the seat to access the battery compartment. 1 Batter y Installation H • Place the battery upright in the battery compartment. Make sure the battery connector extends towards the rear of the vehicle. • Make sure a Power Wheels ® 25 amp fuse in good condition is installed in the battery.
Batter y Installation • Squeeze the tabs on each side of the motor harness connector . • Plug the battery connector into the motor harness connector . Please Note: If the battery connector will not plug into the motor harness connector , tur n it over and try again! Do not force the battery connector into the motor harness connector .
Batter y Installation • Rotate the lock fastener 1 / 4 turn using a slotted screwdriver to lock the battery compartment. • T o make sure the lock fastener is locked, insert the blade of the screwdriver under the back of the seat and push down on the screwdriver handle.
Charging the Batter y I W ARNING • The battery must be handled by adults only . • Never allow childr en to charge the batter y . Batter y charging must be done by adults only . A child could be injured by the electricity involved in char ging the batter y .
2 • Squeeze the tabs on the motor harness connector to unplug it from the battery connector . • Squeeze the tabs on the charger connector to plug it into the battery connector . • Plug the charger into a standard 120 volt wall outlet . Note: If power to the outlet is controlled by a wall switch, make sure the switch is “ON”.
Batter y Handling/Care/Disposal J W ARNING • The battery must be handled by adults only . • Never permit a child to handle the batter y . The battery is heavy and contains sulfuric acid (electrolyte), and if dr opped, could result in a serious injury .
• Adult supervision is r equired. Childr en do not have the judgement necessary to avoid many accidents. Be sure that children operating this vehicle can do so safely and that they are supervised at all times. • Never use on or danger ously close to steps, inclines greater than 10˚, r oadways, bodies of water , low obstructions or in the dark.
10˚ Rules for Safe Driving Incline should never be more than 10° • While driving across a steep slope, the vehicle may tilt and tip over . The wheels could lose traction causing the vehicle to slip. • While driving up a steep incline, the motor may stop and the vehicle could roll backwards at an unsafe speed.
29 STOP GO How to Operate your V ehicle L • Press down on the foot pedal to drive. • Lift your foot from the foot pedal to stop. Y our Kawasaki ® ZX-7 has a patented, electronic braking system that automatically stops the vehicle when your child ’ s foot if lifted from the pedal.
? Questions and Answers M Q. How often do I need to charge the battery? A. Charge the battery for a minimum of 18 hours after each use of the vehicle or whenever the vehicle begins to slow down. When the vehicle is not in regular use, charge the battery at least once a month until normal use is resumed.
Problems and Solutions Guide N Problem Possible Cause Solution V ehicle does not run Undercharged battery Charge the battery . A new battery should have been charged for at least 18 hours before using the vehicle for the first time. After first-time use, recharge battery for at least 18 hours after each use.
V ehicle was running but Loose wire or loose connectors Check all wir es and connectors. Make sure the batter y suddenly stopped connector is tightly plugged into the motor harness connector . Wr ong type or improperly installed fuse Make sure that the battery has a properly installed Power Wheels ® 25 amp fuse installed before charging.
Problem Possible Cause Solution V ehicle runs sluggishly Undercharged battery Charge the batter y . A new battery should have been charged for at least 18 hours before using the vehicle for the first time. After first-time use, recharge the battery for at least 18 hours after each use.
Problem Possible Cause Solution Sometimes the vehicle doesn’t Loose wire or connector Check all wires around the motor and all connectors to run, but other times it does make sure they ar e tight. Motor or electrical switch damage Contact your local Power Wheels ® Authorized Service Center for diagnosis and repair .
Statement of Limited W arranty O 90-day limited warranty for the Power Wheels ® Ride-On T oy V ehicle A 6-month battery warranty applying only to those 6-volt battery which was included by Power Wheels ® , with the Power Wheels ® vehicle when originally pur chased.
Authorized Ser vice Centers COLORADO COLORADO SPRINGS - Nelson Appliance Repair , Inc., 1220 E. Fillmore, 80907, (719) 635-1928 DENVER - Appliance Service, 4262 Lowell Blvd., 80211, (303) 458-1109, (800) 631-0941 (CO, WY only) DENVER (ENGLEWOOD) - Appliance Service, 3932 S.
Authorized Ser vice Centers MASSA CHUSETTS BOSTON (MEDFIELD) - Wills Hardw are, 5 Janes A venue, 02052, (508) 359-4381 BOSTON (W AL THAM) - Suburban Appliance Service Center , Inc., 271 Moody Street, 02154, (617) 893-6694 QUINCY - Appliance Service and Parts, Inc.
Authorized Ser vice Centers OKLAHOMA OKLAHOMA CITY - Brand Service Center, 538 N. P ennsylvania Av enue, 73107, (405) 235-0583 TULSA - H.L. Moss, Inc., 1714 E.
Een belangrijk punt na aankoop van elk apparaat Kawasaki 78410 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Kawasaki 78410 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Kawasaki 78410 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Kawasaki 78410 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Kawasaki 78410 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Kawasaki 78410 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Kawasaki 78410 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Kawasaki 78410 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
