Gebruiksaanwijzing /service van het product KDC-3026R van de fabrikant Kenwood
Ga naar pagina of 26
KDC-3026R © B64-2729-00 / 00 (MW) INSTRUCTION MANUAL CD-RECEIVER KDC-3026R_U.S 2003.09.30 04:08 PM Page 1.
— 2 — English Contents Safety precautions ......................3 About RDS ..................................5 About CDs .........................
— 3 — Safety precautions To prevent injury or fire, take the following precautions: • Insert the unit all the way in until it is fully locked in place. Otherwise it may fall out of place when jolted. • When extending the ignition, battery , or ground wires, make sure to use automotive- grade wires or other wires with a 0.
— 4 — English • If you experience problems during installation, consult your Kenwood dealer . • If the unit does not seem to be working right, try pressing the reset button first. If that does not solve the problem, consult your Kenwood dealer .
— 5 — About CDs About RDS RDS (Radio Data System) When listening to an RDS station, the programme service name of the station is displayed, advising you quickly which station is being received. RDS (Radio Data System) stations also transmit alternative frequency data for the same station.
Compensating for low and high tones during low volume. Loudness Tu rning the volume down quickly . Press the [A TT] button. Each time the button is pressed the Attenuator turns ON or OFF . When it’ s ON, the "A TT" indicator blinks. Attenuator Increasing V olume Press the [ u ] button.
1 Select the source for adjustment Press the [SRC] button. 2 Enter Audio Control mode Press the [AUD] button for at least 1 second. 3 Select the Audio item for adjustment Press the [FM] or [AM] button. Each time the button is pressed the items that can be adjusted switch as shown below .
The faceplate of the unit can be detached and taken with you, helping to deter theft. Removing the Faceplate Press the Release button. The faceplate is unlocked, allowing you to detach it. • The faceplate is a precision piece of equipment and can be damaged by shocks or jolts.
T uner features — 9 — VOL ADJ SCRL SCAN AUD TI RDM REP M.RDM CLK MENU OFF PTY LOUD SRC 1 - 6 AM FM ¢ 4 MENU ST indicator Band display Preset station number Frequency display AUTO indicator Putting the station in the memory . 1 Select the band Press the [FM] or [AM] button.
RDS features Calling up the stations in the memory . 1 Select the band Press the [FM] or [AM] button. 2 Call up the station Press the [1] — [6] button. Preset T uning Putting a station with good reception in the memory automatically . 1 Select the band for Auto Memory Entry Press the [FM] or [AM] button.
— 11 — 20. Children's programs "CHILDREN" 21. Social Affairs "SOCIAL" 22. Religion "RELIGION" 23. Phone In "PHONE IN" 24. T ravel "TRA VEL" 25. Leisure "LEISURE" 26. Jazz Music "JAZZ" 27.
Selecting the Program T ype display language. 1 Enter PTY mode Refer to <PTY (Program T ype)> (page 11). 2 Enter Changing Language mode Press the [CLK] button. 3 Select the language Press the [1] — [3] button. Button Language [1] English [2] French [3] German 4 Exit Changing Language mode Press the [CLK] button.
CD/External disc control features — 13 — VOL ADJ SCRL SCAN AUD TI RDM REP M.RDM CLK MENU OFF PTY LOUD SCRL AM/ DISC- FM/ DISC+ ¢ 4 MENU 0 SCAN RDM REP M.RDM SRC T rack time T rack number IN indicator Disc number Playing discs set in the optional accessory disc player connected to this unit.
Play the songs on all the discs in the disc changer in random order . Press the [M.RDM] button. Each time the button is pressed the Magazine Random Play turns ON or OFF . When it's ON, "MRDM ON" is displayed. When the [ ¢ ] button is pressed, the next song select starts.
— 15 — Scrolling the displayed CD text or MD title. Press the [SCRL] button. T ext/T itle Scroll Attaching a title to a CD. 1 Play the disc you want to attach a name to A title can't be attached to a MD. 2 Enter Menu mode Press the [MENU] button for at least 1 second.
Setting during operation beep sound etc. functions. The Menu system basic operation method is explained here. The reference for the Menu items and their setting content is after this operation explanation. 1 Enter Menu mode Press the [MENU] button for at least 1 second.
— 17 — Selecting the button illumination color as green or red. Display Setting "COL GRN" The illumination color is green. "COL RED" The illumination color is red. Selectable Illumination removed, warning potential thieves. Display Setting "DSI ON" LED flashes.
Y ou can choose whether or not to restrict the RDS channels, received with the AF function for a particular network, to a specific region. Display Setting "REG ON" The Region Restrict Function is ON. "REG OFF" The Region Restrict Function is OFF .
— 19 — The use of any accessories except for those provided might result in damage to the unit. Make sure only to use the accessories shipped with the unit, as shown above. 1. T o prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery.
English — 20 — Connecting Wires to T erminals 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 TEL MUTE P.CONT ANT.CONT REAR L R Rear right output (Red) 4 10 Rear left output (White) Connector Function Guide Pin N.
— 21 — Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip). Metal mounting strap (commercially available) Self-tap.
English — 22 — ■ Removing the hard rubber frame 2 When the lower level is removed, remove the upper two locations. The frame can be removed from the top side in the same manner . Catch Lock 1 Engage the catch pins on the removal tool and remove the two locks on the lower level.
— 23 — Accessory 2 Removal tool Screw (M4X8) (commercially available) ■ Removing the Unit 4 Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. Be careful to avoid injury from the catch pins on the removal tool.
English — 24 — ? No sound can be heard, or the volume is low . ✔ The fader or balance settings are set all the way to one side. 21 ☞ Center the fader and balance settings. ✔ The input/output wires or wiring harness are connected incorrectly .
— 25 — ? The disc won’ t insert. 65 ✔ There’ s already another disc inserted. ☞ Press the [ 0 ] button and remove the disc. ? T rack Search can't be done.
— 26 — English Specifications FM tuner section Frequency range (50 kHz space) ..............87.5 MHz – 108.0 MHz Usable sensitivity (S/N = 26dB) ...................8.1 dBf (0.7 µV/75 Ω ) Quieting Sensitivity (S/N = 46dB) ..............15.2 dBf (1.
Een belangrijk punt na aankoop van elk apparaat Kenwood KDC-3026R (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Kenwood KDC-3026R heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Kenwood KDC-3026R vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Kenwood KDC-3026R leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Kenwood KDC-3026R krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Kenwood KDC-3026R bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Kenwood KDC-3026R kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Kenwood KDC-3026R . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
