Gebruiksaanwijzing /service van het product PH1-2000D van de fabrikant Kole Audio
Ga naar pagina of 20
.
PH4-800 / PH4-1000 / PH4-1400 PH1-2000D / PH1-4000D / PH1-5500D PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 OWNERS MANU AL.
.
- 2 - INTRODUCTION Kole Audio amplifiers provide high-performance sound reinforcement for your mobile audio equipment. Its versatility enables compatibility with optional Equalizers, Frequency Dividing Crossover Networks, and other audio processors in a customized system.
- 3 - Before beginning the installation, consider the following: 1. Do you plan to add additional mobile electronics equipment in the future? If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left and cooling requirements are met.
- 4 - CONNECTING THE POWER (Fig.1) CAUTION: AS A PRECAUTION, DISCONNECT THE POWER WIRE FROM THE BATTERY WHILE MAKING THE POWER AND GROUND CONNECTIONS TO THE AMPLIFIER. 4/8 GAUGE (Thicker if planning for additional Amplifiers) wire is recommended for both the power and ground wires.
- 5 - RCA input jacks These RCA input jacks are for use with source units that have RCA or Line level outputs. A source unit with a minimum level of 200mV is required for proper operation. The use of high quality twisted pair cables is recommended to decrease the possibility of radiated noise entering the system.
- 6 - High pass x-over frequency control This control is used to select the desired high pass x-over frequency. PH4-800/PH4-1000/PH4-1400 : The frequency can be adjusted between 40Hz and 250Hz. PH2-700/PH2-1000/PH2-1500/PH2-2000/PH2-2400 : The frequency can be adjusted between 50Hz and 500Hz.
- 7 - LED Will illuminate GREEN to indicate the amplifier is on and operating normally, and will be illuminated RED if the amplifier shuts down due to short circuit, DC offset, or overheating detected by on board protection circuitry. REMOTE Controls the subwoofer amplifier gain, from a remote location for ease of adjustment during listening.
- 8 - MASTER MODE CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D 1.Lowest Recommended Impedance is 1ohm mono. 2.RCA Inputs are connected to both Left and Right channels 3.
- 9 - STRAPPED CONFIGURATION PH1-2000D / PH1-4000D / PH1-5500D STRAPPED 2-4ohms 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 10 - 2 CHANNEL STEREO CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 2 CHANNEL BRIDGED CONFIGURATION PH2-700/1000/1500/2000/2400 HEAD UNIT FRONT P ANEL REAR P ANEL 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 11 - 2 CHANNEL TRI MODE CONFIGURATION PH2-700 / PH2-1000 / PH2-1500 / PH2-2000 / PH2-2400 HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 12 - 4 CHANNEL STEREO CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest Recommended Impedance is 2ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 13 - 4 CHANNEL BRIDGED CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 HEAD UNIT 1.Lowest recommended impedance is 4ohm bridged mono 2.RCA Inputs are connected to both Left &Right channels 3.
- 14 - 4 CHANNEL TRI MODE CONFIGURATION PH4-800 / PH4-1000 / PH4-1400 3CH 4-8 Ohms 4CH 4-8 Ohms WOOFER 1CH 4-8 Ohms WOOFER 2CH 4-8 Ohms HEAD UNIT 1.Lowest Recommended Impedance is 4ohm Stereo 2.RCA Inputs are connected to both Left and Right channels 3.
- 15 - TROUBLE SHOOTING GUIDE Check fuses in amplifier. Be sure Turn-on lead is connected Repair power wire or connections Check connections to radio Check fuse Inspect for short circuit or an open connection. Reverse Left and Right RCA inputs to determine if it is occurring before the amp.
- 16 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH2-700 700W 2 X 150W 2 X 180W 1 X 360W 0.
- 17 - MODEL# MAXIMUM POWER OUTPUT POWER OUTPUT @4Ohm POWER OUTPUT @2Ohm POWER OUTPUT @1Ohm BRIDGED POWER THD FREQUENCY RESPONSE -1.0dB HPF LPF SUBSONIC FIL TER BASS BOOST ADJUST ABLE SENSITIVITY RANGE INPUT IMPEDANCE (LOW LEVEL) FUSE DIMENSION (D x W x H inch) PH4-800 800W 4 X 80W 4 X 95W - 2 X 190W 0.
- 18 - W ARNINGS Investigate the layout of your automobile throughly before drilling or cutting any holes. Take care when to work near the gas tanks, lines, or hydraulic lines, and electrical wiring. Don't use power amplifier unmounted. Attach this system securely to the automobile to prevent damage, particularly in the event of an accident.
Een belangrijk punt na aankoop van elk apparaat Kole Audio PH1-2000D (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Kole Audio PH1-2000D heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Kole Audio PH1-2000D vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Kole Audio PH1-2000D leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Kole Audio PH1-2000D krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Kole Audio PH1-2000D bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Kole Audio PH1-2000D kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Kole Audio PH1-2000D . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
