Gebruiksaanwijzing /service van het product 09 730 840 van de fabrikant Miele
Ga naar pagina of 48
Operating and installation instructions Cooker hood To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
Warning and Safety instructions .....................................4 Caring for the environment .........................................1 3 Guide to the appliance ............................................1 4 Modes of operation ..................
Connection for air extraction .......................................3 6 Condensate trap ..................................................3 7 Silencer .........................................................3 8 Electrical connection ................
This appliance complies with all relevant safety requirements. Improper use of the appliance can, however, present a risk of both personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before installation and before using it for the first time.
~ The appliance can only be used by people with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised whilst using it, or have been shown how to use it in a safe way and recognise and understand the consequences of incorrect operation.
Technical safety ~ A damaged appliance can be dangerous. Check the appliance for visible signs of damage. Do not use a damaged appliance. ~ The electrical safety of this appliance can only be guaranteed if it is correctly earthed. It is essential that this standard safety requirement is met.
~ A damaged connection cable must only be replaced by an approved and suitably qualified technician. ~ Miele can only guarantee the safety of the appliance when original Miele replacement parts are used. Faulty components must only be replaced by genuine Miele original spare parts.
Using at the same time as other heating appliances that depend on the air from the room Danger of poisoning by toxic fumes. ~ Great care should be taken when using the cooker hood at the same time and in the same room or area of the house as another heating appliance which depends on air in the room.
In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure of 0.04 mbar (4 pa) is the maximum permissible in the room.
Correct use ~ Danger of burning with open flames. Never use an open flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the cooker hood could draw flames into the filter. Fat particles sucked into the cooker hood present a fire hazard.
~ Do not use the cooker hood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. ~ The filters should be regularly cleaned or changed as appropriate. Saturated filters are a fire hazard.
~ All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. ~ The appliance must not be connected to a chimney or vent flue which is in use. Neither should it be connected to ducting which ventilates rooms with fireplaces.
Disposal of the packing material The packaging is designed to protect the appliance from damage during transportation. The packaging materials used are selected from materials which are environmentally friendly for disposal, and should be recycled.
Guide to the appliance 14.
a Extension piece b Tower c Canopy d Controls e Grease filters f Recirculation grille (only for recirculation mode) g Hob lighting h Charcoal filter (special accessory for recirculation mode) i Sensor.
The cooker hood works with . . . air extraction: The air is drawn in, cleaned by the grease filters and directed outside. If the on-site ventilation system does not have a non-return flap , then the non-return flap supplied with the appliance must be fitted in the exhaust socket of the motor unit.
Con | ctivity 2.0 Automatic control This cooker hood is fitted with a communication module which enables the operation of the cooker hood to be automatically controlled by the operating status of a Miele electric hob with onset controls. The hob transmits information about its operating status to the cooker hood via radio.
When Con | ctivity 2.0 is activated, the cooker hood always operates in automatic mode (see "Activating the Con | ctivity 2.0 function"). To operate the cooker hood manually, see "Cooking without the Con | ctivity 2.0 function". Cooking with the Con | ctivity 2.
Frying food ^ If the hob is switched on at the highest setting and is turned down to a lower setting after approx. 60 to 90 seconds*, a frying process is recognised.
Leaving automatic mode temporarily ^ You can also leave automatic mode during cooking, by – manually selecting a different fan power level, or – manually switching off the cooker hood, or – activating the run-on option " "o n the cooker hood.
Cooking without the Con | ctivity 2.0 function (Manual mode) The Con | ctivity 2.0 function must not be activated for this mode. However, manual operation is temporarily possible even if the Con | ctivity 2.0 function is activated (see "Leaving automatic mode temporarily").
Power management system The cooker hood features a Power management system to help save energy. The fan power level is reduced and the lighting is switched off automatically.
Filter operating hours counter [ The number of hours the cooker hood has been in operation is stored in memory. The operating hours counters tell you when the grease filters or charcoal filters need to be cleaned or replaced.
One or more of sensors 1 to IS will flash. The number of flashing sensors indicates the percentage of the operating time which has already been used up. Sensor 1 ....................2 5% Sensor 1 and 2 ...............5 0% Sensor 1 to 3 ...............
Checking the charcoal filter operating hours counter To check the percentage of time set already used: ^ Touch the On/Off sensor s to switch the fan on. ^ Touch and keep your finger on the Charcoal filter sensor . One or more of sensors 1 to IS will flash.
, Disconnect the cooker hood from the mains supply before mainentance and care (see "Warning amnd Safety"). Housing General The surfaces and controls are susceptible to scratches and abrasion. Please observe the following cleaning instructions.
Grease filters The re-usable metal grease filters in the appliance remove solid particles (grease, dust, etc.) from the kitchen vapours, preventing soiling of the cooker hood. The grease filters should be cleaned regularly (at least every 3-4 weeks) to avoid a build-up of grease, but always clean immediately if the Grease filter sensor [ lights up.
^ After cleaning, leave the filters to dry on an absorbent surface before replacing them. ^ When removing the filters for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. ^ Replace the grease filters, making sure that the locking clips are facing down towards the hob.
Fitting and replacing the charcoal filters If the cooker hood is connected for recirculation, a charcoal filter must be inserted in addition to the grease filters. This is designed to absorb cooking odours. It is fitted in the canopy above the grease filters.
The diagram is not drawn to scale. Appliance dimensions 30.
a Extraction b Recirculation c Ventilation grill positioned at the top for recirculation d , e The shaded areas represent the wall or ceiling area for the vent cut-out and for fitting the connection socket. For recirculation mode, you only require cut-out area d and a connection socket.
– When deciding on the safety distance between the hob and cooker hood, please note that a distance of 650 mm above electric cookers/hobs may be preferable to give more working space under the hood. – Account should also be taken of the height of the person who will be using the hood most often.
Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and safety instructions" at the beginning of this booklet.
Installation accessories Installation 34.
a 3 protective sheets for use when fitting the tower. b 1 exhaust socket for exhaust ducting C 150 mm. c 1 reducing collar for exhaust ducting C 125 mm. d 1 non-return valve for fitting into the exhaust connection on the motor unit (not for recirculation mode) e Telescopic wall bracket for securing the cooker hood to the wall.
Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations.
– If the exhaust air is to be ducted into the open air, the installation of a telescopic wall vent or roof vent (available as an optional accessory) is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue.
Silencer (optional accessory) To achieve even further reductions in noise levels, a special silencer can be fitted in the ducting system. ...with air extraction: The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.
All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable.
Installing the Con | ctivity 2.0 stick The hob must be fitted with the Con | ctivity 2.0 stick so that the Con | ctivity 2.0 function can be used. This is supplied with this cooker hood. ^ Please refer to the installation instructions for the Con | ctivity 2.
^ Touch the IS sensor to activate Con | ctivity 2.0. While it is searching for the radio connection, the 2 sensor will light up and 3 will flash. ^ Meanwhile you can start the activation process for the hob.
Deactivating To deactivate the cooker hood: ^ Switch off the fan, hob lighting and hob. ^ Touch the Run-on sensor ¢ for approx. 10 seconds until the 1 sensor lights up. ^ Touch in turn – the 1 sensor, – then the IS sensor, – then the lighting sensor I .
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Service Department (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.
Total connected load * .........9 9W - Fan motor* .................9 0W - Hob lighting ..............3x3W Voltage ................. A C2 3 0V Frequency .................. 5 0H z Fuse rating ...................1 0A Electrical cable length .............
45.
46.
47.
M.-Nr. 09 730 840 / 01 e n-G B DA 6690 W DA 6690 W EXT.
Een belangrijk punt na aankoop van elk apparaat Miele 09 730 840 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Miele 09 730 840 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Miele 09 730 840 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Miele 09 730 840 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Miele 09 730 840 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Miele 09 730 840 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Miele 09 730 840 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Miele 09 730 840 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
