Gebruiksaanwijzing /service van het product K-11 van de fabrikant MK Sound
Ga naar pagina of 16
Miller & Kreisel Sound Corporation 9351 Deering Avenue Chatsworth, CA 91311-5858 USA (818) 701-7010 fax (818) 701-0369 www.mksound.com ©2002 Miller & Kreisel Sound Corp.
page 2 powered subwoofers T ABLE OF CONTENTS 1 . SAFETY INSTRUCTIONS...............................................................................................................3 2 . INTRODUCTION......................................................
pa ge 3 powered subwoofers 1. SAFETY INSTRUCTIONS 1. READ INSTRUCTIONS - All safety and operating instructions should be read before this product is operated. 2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference.
page 4 powered subwoofers 2. INTR ODUCTION Congratulations! You have just made perhaps the most exciting and dramatic addition that you could make to your audio or multichannel audio/video system. The new dimension of deep and powerful bass provided by your M&K K-series powered subwoofer will thrill and excite you.
pa ge 5 powered subwoofers A simple rule to remember is that you get more bass when you move the Subwoofer towards any wall or corner. Moving it away from a wall or corner gives you less bass. Remember that the floor also loads the Subwoofer, and that maximum bass is found with the woofer on the floor in a corner.
page 6 powered subwoofers WIRING WITH THE RCA JACK INPUTS The "INPUT" RCA jacks on the back panel of your Subwoofer allow you to directly connect the Subwoofer to preamp-level components such as surround sound processors, preamplifiers, integrated amps and receivers with preamp outputs, Electronic High-Pass filters, crossovers, etc.
pa ge 7 powered subwoofers FIGURE 2 - CONNECTING TO A STEREO AMP OR PREAMP USING SPEAKER WIRE CONNECTIONS Some M&K subwoofer owners hook up their Subwoofer by connecting it to their receiver or amplifier using speaker wires.
page 8 powered subwoofers If your receiver or amp has two sets of speaker outputs, you may connect the Satellite speakers to one set of outputs and the Subwoofer to the other set. FIGURE 3 - TO AN AMP OR RECEIVER USING SPEAKER WIRES IMPORTANT NOTE FOR DOLBY PRO LOGIC SURROUND SYSTEMS: (NOT DOLBY DIGITAL 5.
pa ge 9 powered subwoofers 2. For convenience, you can also connect the Satellite speakers to the Subwoofer. Both sets of wires will be connected to the same terminals on the Subwoofer.
page 10 powered subwoofers If you want to experiment further, you can move the Satellite speakers either towards or away from your listening position, making changes in small increments.
pa ge 11 powered subwoofers If you already own a K-10 and would like to upgrade your subwoofer performance, you don't need to trade your subwoofer in for a new model. The K-11 upgrade path will give you the full benefit of a push-pull dual-driver subwoofer, with its even-order harmonic distortion cancellation and higher output capability.
page 12 powered subwoofers e. Make sure that the input cables are OK. Double check your connections. If necessary, replace any defective cables or speaker wires.
pa ge 13 powered subwoofers Remove the fuse cap. If the fuse cap has an arrow printed on it, push the cap in and turn it counterclockwise. If the fuse cap has a slot in it, use a flat head screwdriver to turn it counterclockwise. Look carefully at the fuse.
page 14 powered subwoofers Here are the instructions for speaker setup. 1. Locate the front speakers. The left, right, and center speakers should be equidistant from the main listening position. Try to set up the speakers so that they are reasonably symmetrical to room surfaces.
pa ge 15 powered subwoofers D. THX Dolby Digital units have an adjustable limiter for the subwoofer feed, called “Bass Peak Level Management”. Turn it off, or set it for the highest possible level. M&K subwoofers do not need this limiter. 7. If you have a Pro-Logic only processor/receiver, follow these instructions .
page 16 powered subwoofers 14. SPECIFICA TIONS K-9 ENCLOSURE TYPE: Sealed Box WOOFER: Single 8" Driver POWER RATING: 75 watts RMS (150watts MAX) FREQUENCY RESPONSE: 35Hz - 200Hz ± 3dB WEIGHT: 21 lbs.
Een belangrijk punt na aankoop van elk apparaat MK Sound K-11 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen MK Sound K-11 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens MK Sound K-11 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding MK Sound K-11 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over MK Sound K-11 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van MK Sound K-11 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de MK Sound K-11 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met MK Sound K-11 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
