Gebruiksaanwijzing /service van het product 120-2154 van de fabrikant Optimus
Ga naar pagina of 27
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Features Faxback Doc. # 48528 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
Programming stations in each band (AM and FM) into a separate travel memory so you can quickly find local stations while traveling. Seek Tuning - searching forward or backward to the next strong station in the selected band. This makes finding a station quick and easy.
The CD player in this stereo system is made and tested to meet exacting safety standards. It meets FCC requirements and complies with safety performance standards of the U.S. Department of Health and Human Service. WARNINGS: This system employs a laser light beam.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Installation Faxback Doc. # 48529 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
it is mounted. Be sure to avoid obstructions behind the mounting surface. Routing Speaker Wires If you install speakers, avoid routing the speaker wires near moving parts or sharp edges. You can usually route them along the wiring channel beneath the vehicle's door facings by carefully removing the molding that holds the carpet in place.
4 Ohms. Your local RadioShack store carries a full line of speakers. You must connect the GROUND, +12V TO IGNITION, and +12V TO BATTERY wires first, then make all other connections as described in the following sections before you plug the harness with the 14-pin connector into the stereo.
(Black) - Ground (Red) - + 12V to Ignition (Yellow) - + 12V to Battery (Blue/White) - AMP Remote Turn on 500 mA MAX 1. Disconnect the cable from your vehicle's negative (-) battery terminal. 2. Connect the black ground wire to a chassis ground, such as a metal screw attached to a metal part of the vehicle's frame.
Connecting Two Pairs of Speakers If you are using both front and rear speakers, follow these steps to connect the harness with the 14-pin connector to the speakers. 12-2154 Only: Before connecting the speakers, remove the tape that holds the mounting sleeve in place and slide the sleeve off of the stereo.
(White) - Left Speaker (+) (White/Black) - Left Speaker (-) (Gray) - Right Speaker (+) (Gray/Black) - Right Speaker (-) (Green) - | (Green/Black) - |___ Do Not Connect (Violet) - |// (Violet/Black) - .
Make sure you have securely made all other connections, then plug the harness' connector into the stereo's 14-pin wiring socket. Reconnect the cable to the vehicle's negative (-) battery terminal.
7. Reconnect the wire harness and the antenna. 8. Slide the stereo into the sleeve until it locks into place. 9. If you are securing the stereo in an existing mounting hole in the dash, push the supplied rubber mounting grommet onto the mounting bolt.
Note: The keys are labeled to show their top edges. 5. Remove the keys from the slots. 6. Disconnect the wire harness and the antenna. 7. If you are mailing or shipping the stereo, use a Phillips screwdriver to reinstall the shipping screw in the top of the stereo.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Control Panel Faxback Doc. # 48530 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Operation Faxback Doc. # 48531 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
number appear. WARNING: To protect your hearing, do not listen at high volume levels. Slowly increase the volume to a comfortable listening level. AUDIO CONTROL SEL - Repeatedly press until bAS, TRE, .
1. Repeatedly press FSM until FSM I or FSM II appears. 2. Adjust the volume, bass, treble, balance and fader using the information in "Adjusting the Sound" above. Note: FSM I or FSM II blinks while you adjust the controls. 3. When you finish adjusting the stereo's settings, hold down FSM until the stereo beeps twice.
Seek Tuning: Hold down TUNE/SEEK TRACK - or + for about 1 second to tune to the next lower or higher station. 4. Press AUDIO CONTROL SEL + or - to increase or decrease the volume as desired.
memory. Note: If the stereo could not find any stations, P - 1 - - - appears on the display. Press BND or select another station to listen to the radio.
As the radio scans each memory channel, P- and the channel number flash and the frequency is displayed. After scanning all memory channels, the stereo returns to the original station. To stop scanning when the radio pauses at a station you want to listen to, press BND again during the pause.
resume play, press CD again. Note: If you pause a CD for more then 5 minutes, the stereo turns off. 5. To remove a CD from the CD player, press (symbol). EJ cd appears. Notes: If you eject a CD while it is playing and do not remove it from the CD player, the stereo automatically draws the CD back in and starts playing again after about 5 seconds.
To repeat a track, press RPT/2 during play. RPT appears during repeat play. When the track ends, it automatically repeats. To stop repeating the track and resume normal play, press RPT/2.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Troubleshooting Faxback Doc. # 48532 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Care and Maintenance Faxback Doc. # 48533 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
CD CARE TIPS Even though a CD is very durable, you should handle it with care. We recommend the following precautions. Keep the CD in its protective case or sleeve when you are not playing it. Handle a CD by its edges to avoid fingerprints which can prevent the CD player's laser beam from accurately reading the CD.
3. If the fuse is brown, replace it. Use only the supplied 1-1/4 inch fuse or a replacement fuse with the proper rating (such as Cat. No. 270-1005). The fuse must be 1 amp. 4. Reassemble the fuse holder by inserting the fuse into the longer of the fuse holder's ends, and pushing together and twisting the two parts until they latch together.
High-Power In-Dash AM/FM Stereo CD Player (120-2154/55) Specifications Faxback Doc. # 48534 This document contains instructions for both Cat. No. 120-2154 and 120-2155 stereos. (You can find the Cat. No. of your model on the top of the stereo.) 120-2154 has a LOUD button while 120-2155 has an FSM button.
Sampling Frequency: .............................................. 8 times Pick-Up System: ......................................... Optional Pick-Up Optical Source: .................................................... Laser Wavelength: ..............
Een belangrijk punt na aankoop van elk apparaat Optimus 120-2154 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Optimus 120-2154 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Optimus 120-2154 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Optimus 120-2154 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Optimus 120-2154 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Optimus 120-2154 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Optimus 120-2154 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Optimus 120-2154 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
