Gebruiksaanwijzing /service van het product EP750 van de fabrikant Optoma Technology
Ga naar pagina of 26
E nglish 1 -- Usage Notice ------- Precautions ........................................................................................... 2 Introduction ------- Product Features ........................................................................
E nglish 2 Usage Notice Warning- Do not look into the lens. The bright light may hurt your eyes. Warning- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. Warning- Please do not open or disassemble the product as this may cause electric shock.
E nglish 3 Product Features This product is an SVGA single chip 0.7” DLP TM projector. The outstanding features of it are listed as follows: u True SVGA, 800 x 600 addressable pixels u 6.
E nglish 4 Package Overview This projector comes with all the items shown below. Check to make sure your unit is complete. Contact your dealer immediately if anything is missing.
E nglish 5 Main Unit Product Overview Introduction 1. Panel Control 2. Power Connector & Power Switch 3. Connection Ports 4. Focus Ring 5. Zoom Lens 6.
E nglish 6 Introduction Panel Control Connection Ports 1 RS232 Input Connector (RS232 is for after service purpose only) 2. Audio Input for Video 3. Composite Video Input Connector 4. S-Video Input Connector 5. Audio Input for DVI 6. DVI Input Connecter 7.
E nglish 7 Remote Control with Mouse Function & Laser Pointer Source Re-sync Freeze Keystone Correction Power / Standby Volume ( + / - ) Mute Multi-Directional Selector Enter Key Menu Laser Pointe.
E nglish 8 1. Power Cord 2 . VGA Cable 3 . S-Video Cable 4. Audio Cable Jack/RCA 5 . Composite Video Cable 6 . DVI to D-Sub Cable 7 . Remote Mouse Y Cable 8 .
E nglish 9 Lens cap Power / Standby Installation Powering On the Projector 1. Remove the lens cap. 2. Ensure that the power cord and signal cable are securely connected. 3. Turn on the main power switch on the side of the projector and allow the projector to warm up for 1-2 minutes.
E nglish 10 Installation Powering Off the Projector 1. Press the “Power/Standby” button to turn off the projector lamp. 2. After pressing the “Power/Standby” button, you will see a message “Power off the lamp?” on the on-screen display. Press the “Power/ Standby” button again to confirm.
E nglish 11 Elevator Button Elevator Foot Installation The projector is equipped with an elevator foot for adjusting the projector height. To raise the projector: 1. Press the elevator button . 2. Raise the projector to the desired display angle , then release the button to lock the elevator foot into position.
E nglish 12 Focus Ring Zoom Ring Screen (Diagonal) Distance Screen Size Adjusting the Projector Zoom / Focus You may adjust zoom ring to zoom in / out. Rotate the zoom ring counter- clockwise to zoom in and clockwise to zoom out. To focus the image, rotate the focus ring until the image is clear.
E nglish 13 Remote Control Panel Control User Controls Panel Control & Remote Control There are two ways for you to control the functions: Remote Control and Panel Control. Power / Standby 4 Refer to the “Power On/Off the Projector” section on page 9~10.
E nglish 14 Four Directional Select Keys 4 When you close the cover of remote control, this key can be used as a mouse to control direction. v The above function is only enabled with the connection between computer and projector by remote mouse Y cable.
E nglish 15 How to operate 4 The Projector has multilingual On-Screen Display(OSD) menus that allow you to make image adjustments and change a variety of settings. In computer source, the OSD will be the “Computer OSD”. In video source, the OSD will be the “ Video OSD”.
E nglish 16 Brightness Adjusting the brightness of the image. 4 Press the to darken the image. 4 Press the to lighten the image. Contrast The contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting the contrast changes the amount of black and white in the image.
E nglish 17 Image-I (Video mode) User Controls Brightness Adjusting the brightness of the image. 4 Press the to darken the image. 4 Press the to lighten the image. Contrast The contrast controls the degree of difference between the lightest and darkest parts of the picture.
E nglish 18 Frequency “Frequency” is for changing the display data frequency to match the frequency of your computer’s graphic card. When you experience a vertical flickering bar, use this function to make an adjustment. Tracking Choose “Tracking” item to synchronize the signal timing of the display with that of the graphic card.
E nglish 19 Image-II (Video mode) Keystone Correction Adjust image distortion caused by tilting the projector. (±16 degrees) 16 : 9 / 4 : 3 You can use this function to fit your desired aspect ratio type. Color Temperature Adjust the color temperature.
E nglish 20 Volume 4 Press the to decrease the volume. 4 Press the to increase the volume. Treble The treble setting controls the higher frequencies of your audio source. 4 Press the to decrease the treble. 4 Press the to increase the treble. Bass The Bass setting controls the lower frequencies of your audio source.
E nglish 21 Menu Location Choose the Menu location on the display screen. Projection 4 Front-Desktop The factory default setting. 4 Rear-Desktop When you select this function, the projector reverses the image so you can project behind a translucent screen.
E nglish 22 Problem : No image appears on screen. 4 Ensure all the cables and power connections are correctly and securely connected as described in the “Installation” section. 4 Ensure the pins of connectors are not crooked or broken. 4 Check if the projection lamp has been securely installed.
E nglish 23 Problem : The screen of the Notebook or PowerBook computer is not displaying your presentation. 4 If you are using Notebook PC: Some Notebook PCs may deactivate their own computers’ screen when a second display device is in use. Each of them has a different way to be reactivated.
E nglish 24 Changing the lamp The projector will detect the lamp life itself. It will show you a warning message “Lamp is running out of standard lifetime. Be sure to replace the lamp as soon as possible.” When you see this message, change the lamp as soon as possible.
E nglish 25 Specifications Light Valve - Single Chip DLP TM Technology Contrast Ratio - 600 :1 ( Ful l On / Ful l Of f) Lamp - 200W User Replaceable UHP Lamp Number of Pixels - 800 pixels(H) X 600 lines(V) Displayable Color - 16.7M colors Projection Lens - F/2.
E nglish 26 A G V A S E V 0 5 3 X 0 4 6 5 8 9 . 7 3 5 8 9 . 7 3 A G V A S E V 0 0 4 X 0 4 6 5 8 9 . 7 3 5 8 9 . 7 3 A G V A S E V 0 8 4 X 0 4 6 0 6 5 . 1 3 0 6 5 . 1 3 A G V A S E V 0 8 4 X 0 4 6 2 7 9 . 7 3 2 7 9 . 7 3 A G V A S E V 0 8 4 X 0 4 6 5 7 5 .
Een belangrijk punt na aankoop van elk apparaat Optoma Technology EP750 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Optoma Technology EP750 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Optoma Technology EP750 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Optoma Technology EP750 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Optoma Technology EP750 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Optoma Technology EP750 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Optoma Technology EP750 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Optoma Technology EP750 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
