Gebruiksaanwijzing /service van het product SCM-103 van de fabrikant Premier Mounts
Ga naar pagina of 15
INSTALLATION INSTRUCTIONS SCM-103 Suspended Ceiling Mount NORTH AMERICA 3130 East Miraloma Avenue Anaheim, CA 92806 USA USA and Canada – Phone: 800-368-9700 Fax: 800-832-4888 EUROPE Swallow House, S.
Page 2 Installation Instructions Table of Contents W arning Statements Warning Statements 2 Parts List 3 Installation Tools 3 Locating the Mounting Points 4 Mounting the Brackets to the Display 5 Secu.
Installation Instructions Page 3 Parts List This ceiling mount is shipped with all proper installation hardware and components. Make sure that none of these parts are missing and/or damaged before beginning installation. If there are missing and/or damaged parts, please stop the installation and contact Premier Mounts (800-368-9700).
Page 4 Installation Instructions Locate the Mounting Points The display comes with four (4) M16 screws with quick release sleeves that are pre-installed on the display. Mounting Points Mounting Points Step 1. Locate the 4 quick release sleeves on the back of the display and remove.
Installation Instructions Page 5 Mounting the Brackets to the Display Step 1. Align the mounting bracket holes up with the mounting holes on the back of the display. There are two mounting holes used on each side of the display. Step 2. Place the split washer between the display and the mounting bracket.
Page 6 Installation Instructions Step 1. Insert the lower cover between the vertical mounting brackets. Step 2. Attach four (4) 10-32 Kep Nuts and tighten down securing the lower cover into place. Step 3. Insert two (2) 8-32 x ½” screws and tighten down the lower cover bracket against the vertical side mounting brackets.
Installation Instructions Page 7 THE SCM-103 IS HEAVY. IT IS STRONGLY RECOMMENDED THAT THREE PEOPLE PERFORM ALL INSTALLATION STEPS. Now that the mount is attached to the display, double check all mounting locations to insure all hardware is properly tightened and secured.
Page 8 Installation Instructions THE SCM-103 IS HEAVY. IT IS STRONGLY RECOMMENDED THAT THREE PEOPLE PERFORM ALL INSTALLATION STEPS. Lifting the Display into Position Step 1. Raise the display to the desired height (Refer to the display manufacturer specs on raising the display into position and the different options available).
Installation Instructions Page 9 Cable Routing Pre-Hung Cable 2 Hole Locations for Cable Routing Two holes are provided at the top of each mounting bracket. Cables can be routed so both are going through one hole or routed so each cable runs through its own hole.
Page 10 Installation Instructions THE SCM-103 IS HEAVY. IT IS STRONGLY RECOMMENDED THAT THREE PEOPLE PERFORM ALL INSTALLATION STEPS. Step 5. Route the cable down through the provided holes on the display mounting bracket. 6-32 x 1/4” Set Screw Step 3.
Installation Instructions Page 11 THE SCM-103 IS HEAVY. IT IS STRONGLY RECOMMENDED THAT THREE PEOPLE PERFORM ALL INSTALLATION STEPS. Step 6. Locate the ½”-20 Nuts & ½” flat washer. Step 7. Measure 1 ¾” inches up the threaded stud attached to the cable and thread one ½-20 nut into position.
Page 12 Installation Instructions Step 1. After all cables have been routed through mount and are properly installed, locate the display input cover panel. Step 2. Install the panel by sliding it into position behind the tubes. Step 3. Lock the cover into position by tightening the six (6) 8-3 x 3/8” screws.
Installation Instructions Page 13 Step 5. Once cover is slid into position tighten down using the 8-32 x 3/8” screws. 8-32 x 3/8” Screws Step 6. Drop the lower cover into position between the 2 display mounting brackets and lock into place using the 8-32 x 3/8” screws provided.
Page 14 Installation Instructions Technical Specifications All measurements are in inches(mm). SCM-103.
Warranty PREMIER MOUNTS LIMITED LIFETIME WARRANTY What and Who is Covered by this Limited Warranty and for How Long Premier Mounts warrants this product to be free from defects in material and workmanship for the lifetime of the original owner of this product.
Een belangrijk punt na aankoop van elk apparaat Premier Mounts SCM-103 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Premier Mounts SCM-103 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Premier Mounts SCM-103 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Premier Mounts SCM-103 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Premier Mounts SCM-103 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Premier Mounts SCM-103 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Premier Mounts SCM-103 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Premier Mounts SCM-103 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
