Gebruiksaanwijzing /service van het product CFD-S47 Operating Instructions (primary manual) van de fabrikant Sony
Ga naar pagina of 36
3-864-534- 51 (1) ©1998 by Sony Corporation CD Radio Cassette-Cor der Operating Instructions CFD-S47.
Introduction 2 Warning To prevent fire or shock hazard, do not expose the player to rain or moisture. This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
3 Introduction Basic Operations T able of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player 12 Using the display 13 Locating a spe.
Basic Operations 4 Playing a CD Basic Operations Connect the supplied AC power cord (see page 25). 1 Press 6 CD OPEN/CLOSE (direct power-on) and place the CD on the CD tray.
Basic Operations Basic Operations 5 Use these buttons for additional operations To Press adjust the volume VOL +, – stop playback p pause playback ^ ( P on the remote) Press the button again to resume play after pause.
Basic Operations 6 Listening to the radio Connect the supplied AC power cord (see page 25). 1 Press BAND until the band you want appears in the display (direct power-on). 2 Hold down TUNE +/ + or TUNE –/ = (TUNE + or – on the remote) until the frequency digits begin to change in the display.
Basic Operations Basic Operations 7 Use these buttons for additional operations To Press adjust the volume VOL +, – turn on/off the radio POWER To improve broadcast reception Reorient the antenna for FM.
Basic Operations 8 Playing a tape Connect the supplied AC power cord (see page 25). 1 Press p6 to open the tape compartment and insert a recorded tape. Use TYPE I (normal) tape only. Close the compartment. 2 Press ( . The player turns on (direct power-on) and starts playing.
Basic Operations Basic Operations 9 Use these buttons for additional operations To Press adjust the volume VOL +, – stop playback p6 f ast-forward or rewind the tape ) or 0 pause playback P Press the button again to resume play after pause.
Basic Operations 10 Recording on a tape Connect the supplied AC power cord (see page 25). 1 Press p6 to open the tape compartment and insert a blank tape. Use TYPE I (normal) tape only. 2 Select the program source you want to record. To record from the CD player, insert a CD (see page 4) and press p on the CD section.
Basic Operations Basic Operations 11 3 Press r to start recording ( ( is depressed automatically). Use these buttons for additional operations Tips • Adjusting the volume or the audio emphasis (see page 27) will not affect the recording level.
The CD Player 12 Using the display You can check information about the CD using the display. The CD Player Checking the total track number and playing time Check the display in stop mode. If the CD has more than 12 tracks, “OVER 12” appears in the display.
The CD Player The CD Player 13 Locating a specific point in a track You can quickly find a specific point in a track while playing a CD. You can also locate any track using the number buttons on the remote.
The CD Player 14 Playing tracks r epeatedly (Repeat Play) You can play tracks repeatedly in normal, shuffle or program play modes (see page 16). 1 Press p . “Cd” appears in the display. 2 Proceed as follows. To repeat Do this a single track 1 Press MONO/ST ISS• PLAY MODE until “REP 1” appears.
The CD Player The CD Player 15 Playing tracks in random order (Shuffle Play) You can play tracks in random order. 1 Press p . “Cd” appears in the display. 2 Press MONO/ST ISS•PLAY MODE until “SHUF” appears in the display. 3 Press ^ to start shuffle play.
The CD Player 16 Cr eating your own pr ogram (Program Play) You can arrange the playing order of up to 20 tracks on a CD. Programed track Playing order 1 Press p . “Cd” appears in the display. 2 Press MONO/ST ISS•PLAY MODE until “PGM” appears in the display.
The CD Player The CD Player 17 Tips • You can play the same program again, since the program is saved until you open the CD tray. • You can record your own program. After you’ve created the program, insert a blank tape and press r to start recording.
The CD Player 18 Enjoying sound ef fects (LOOP/FLASH) You can repeat part of a CD (LOOP) and can “flash” the CD sound (FLASH) during playback. 1 Play a CD.
The Radio The Radio 19 The Radio Pr esetting radio stations You can store radio stations into the player’s memory. You can preset up to 20 radio stations, 10 for each band in any order. 1 Press BAND until the band you want appears in the display. 2 Set the frequency to the station you want.
The Radio 20 Playing pr eset radio stations Once you've preset the stations, use the number buttons on the remote or PRESET +/– on the player to tune in to your favorite stations. 1 Press BAND to select the band. 2 Press PRESET + or – to tune in the stored station.
The Timer 21 The Timer Setting the clock “--:--” indication appears in the display until you set the clock. The Timer Tip The time display system: 12-hour system 1 Press CLOCK for 2 seconds until the hour digit flashes. 2 Press TUNE +/ + or TUNE –/ = until you set the current hour.
The Timer 22 W aking up to music You can wake up to music or a radio program at a preset time. Make sure you have set the clock (“Setting the clock” on page 21). Before you begin, make sure the t (clock) indication is not lit in the display. If it is lit, press STANDBY.
The Timer 23 The Timer Tips • The display window does not light while the waking up timer is on. • You can have the player go on the next day at the same time. Just press STANDBY until the t indication appears in the display. The preset settings remain until you reset them.
The Timer 24 Falling asleep to music You can set the player to turn off automatically after 10, 20, 30, 60, 90, and 120 minutes, allowing you to fall asleep while listening to music. Tips • The display window does not light while the sleeping timer is on.
Setting Up 25 Setting Up Setting Up Choosing the power sources You can use the AC power or batteries as a power source. 1 Inserting the back-up batteries Insert four size AA (R6) batteries (not supplied) into the battery compartment. These batteries work to save the memory data.
Setting Up 26 3 Inserting batteries into the remote Insert two size AA (R6) batteries (not supplied) Replacing batteries With normal use, the batteries should last for about six months. When the remote no longer operates the player, replace all the batteries with new ones.
Setting Up 27 Setting Up Selecting the sound characteristic Press one of the PRESET SOUND MODE buttons to select the audio emphasis you want. Choose To get OFF the whole dynamic range for music such a.
Additional Information 28 Pr ecautions Additional Information On placement • Do not leave the player in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. • Do not place the player on an inclined or unstable place.
Additional Information 29 Notes on CDs • Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out. • Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs.
Additional Information 30 T roubleshooting Symptom The power is not on. There is no audio. “no disc“ lights in the display even when a CD is in place. The CD does not play. The sound drops out. The audio is weak or has poor quality. The picture of your TV becomes unstable.
Additional Information 31 Symptom The tape does not move when you press an operation button. The REC r button does not function/The tape does not play. The tape does not erase completely. The tape does not record. The audio is weak/The audio quality is poor.
Additional Information 32 Maintenance Demagnetizing the tape heads After 20 to 30 hours of use, enough residual magnetism will have built up on the tape heads to begin to cause loss of high frequency sound and hiss.
Additional Information 33 Specifications General Speaker Full range: 8 cm (3 1 ⁄ 4 in.) dia., 6 ohms, cone type (2) Outputs Headphones jack (stereo minijack) For 16 - 68 ohms impedance headphones Power output (except US model) 3.
Additional Information 34 Index A Audio emphasis 27 B Batteries for player 26 memory back-up 25 for remote 26 C CD player 12 Choosing power sources 25 Cleaning cabinet 32 tape heads and tape path 32 C.
Additional Information 35.
Sony Corporation Printed in China.
Een belangrijk punt na aankoop van elk apparaat Sony CFD-S47 Operating Instructions (primary manual) (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Sony CFD-S47 Operating Instructions (primary manual) heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Sony CFD-S47 Operating Instructions (primary manual) vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Sony CFD-S47 Operating Instructions (primary manual) leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Sony CFD-S47 Operating Instructions (primary manual) krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Sony CFD-S47 Operating Instructions (primary manual) bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Sony CFD-S47 Operating Instructions (primary manual) kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Sony CFD-S47 Operating Instructions (primary manual) . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
