Gebruiksaanwijzing /service van het product 35.1070.IT van de fabrikant TFA
Ga naar pagina of 33
37 INTELLIGENT WE A THER STAT ION Instruction M anual INTRODUCTION: Congratulations on purchasi ng this state-of-the-art weat her station as an example of excellent design a nd innovative meas uring technique.
38 FEATURES: The Intelligent Weather Statio n • DCF-77 Radio co ntrolled time with manual setting opti on • DCF reception ON/OFF ( user selectabl e) • 12/24 hour time displ ay • Time zone opti.
39 • “Intelligent” weather informati on display • Can receive up to 3 transmitters • Wireless transmissi on at 868 MHz • Signal reception intervals at 4.
40 temperature and humidi ty should then be di splayed on the Weather station. If this does not happen after 2 mi nutes, the batteries will need to be removed from both units a nd reset from step 1.
41 station. Then within 2 minutes, t he channel 3 outdoor data from the third transmitter wi ll be displayed and the cha nnel icon will shift back to "1" once the t hird transmitter is successf ully received. If this is not happen, user shall restart t he setting up from step 1.
42 HOW TO INSTALL AND REPLACE BATTERIES IN THE OUTDOOR THERMO-HYGRO TR ANSMITTER The outdoor Thermo-hygro tr ansmitter uses 2 x A A IEC LR6, 1.5V batteries. To install and replace the batteries, pl ease follow the steps below: 1. Remove the battery cover wi th a small screwdri ver.
43 frequency signal DCF-77 (77. 5 kHz) and has a tra nsmitting range of approximately 1,500 km. Your r adio-controlled W eather Station receives this signal and converts it to s how the preci se time in summer or wintertime. The quality of the reception depe nds greatl y on the geographic l ocation.
44 FUNCTION KE YS: Weather Station: The Weather Station has 5 easy to use functio n keys. SET key • Press and hold the key to enter ma nual setti ng modes: LCD contrast, 12/24 hour time di splay, ti.
45 CH key (Channel ke y) • Select channel 1, 2, or 3 (if more t han 1 transmitter i s used) • Exit setting mode • Re-detect new transmi tters signal for all channels • Stop the outdoor tempera.
46 Air pressure history bar graph * When the signal form tra nsmitter is successfully received by the Weather station, this s ignal reception icon will be switched on. (If not successful, the icon wil l not be shown in LCD) So user can easil y see whether the last reception was s uccessful (i con on) or not (icon off).
47 • Time zone setting • Manual time setting • Calendar setting • DCF-77 time recepti on ON/OFF setting • °C/ °F temperature unit setti ng • Air pressure unit setti ng • Relative press.
48 The time zone can be set ±12 hour. The default ti me zone is set to “ 0h”. To set a different tim e zone: 1. The current time zo ne value starts flashing. 2. Use the MAX/+ or MIN/- key to set t he time zone. T he MAX/+ key increases the value and the MIN/- k ey decreases t he value in consecutive 1 hour intervals.
49 The date default of the W eather Station is 1. 1. i n the year 2005. Once the radio-controlled ti me signals are received, the date is automatically updated. However, if the sig nals are not recei ved, the date can also be set manually. 1. The year starts flas hing.
50 °C/°F TEMPERATURE UNI T SETTING The temperature displ ay can be selected to show temperat ure data in °C or °F. (default °C) 1. Use the MAX/+ or MIN/- key to tog gle between “°C” or “° F”. 2. Confirm with the SET key a nd enter the Air Pressure Unit setting .
51 be manually set to another val ue within the range of 960 – 1040 hPa (28.30 – 30.80 inHg) for a better refere nce. 1. The current relativ e pressure value will start fl ashing 2. Use the MAX/+ or MIN/- key to i ncrease or decrease t he value. Keep holding the key all ows the value to advance faster.
52 TO EXIT THE M ANUAL SET TING MO DE To exit the manual setti ng anytime from the ma nual setting modes, press the CH key anytime or wai t for automatic timeout.
53 2. Press the MAX/+ or MIN/- key to ac tivate the alarm ON or O FF. 3. Press t he SET key to enter the al arm value setti ng (alarm value flashing) 4. Use the MAX/+ or MIN/- key to set t he alarm val ue. 5. Press t he SET key to confirm a nd enter the HIGH outdoo r temperature alarm setting.
54 1. The O n/ Off icon is flashing. Press t he MAX/+ or MIN/- key to activate the alarm ON/OFF. 2. Press t he SET key to enter the al arm value setti ng (alarm value flashing) 3. Use the MAX/+ or MIN/- key to set t he alarm val ue. 4. Press t he SET key to confirm a nd return to the normal display .
55 WEATHER FOREC AST AND WEATHER TENDENC Y: WEATHER FOREC ASTING ICONS: There are 4 weather icons in t he fourth secti on of LCD which can be displayed in any of the foll owing combinations: For every sudden or signifi cant change in the air press ure, the weather icons will be updated accordingly to represent the c hange in weather.
56 Examples of changing w eather icons: Note: After initial set up of the Intell igent Weather Stati on with the setting of the relative value, readings for weat her forecasts sho uld be disregarded for the next 12-24 hours.
57 Note: • An upward air pressure tende ncy indicator mea ns that there is an increase in air press ure within the past 4 hours. • A downard air pressure tende ncy indicator mea ns that there is an decrease in air pressure wi thin the past 4 hours.
58 (-12, -9, -6, -3, -2, -1, a nd 0 hour). The bars are pl otted at each of the 7 steps and give the trend over t he recorded peri od. The scale on the rig ht compares the result. T he ″ 0 ″ in the middl e of this scale determines the current air pressure.
59 OUTDOOR TEM PERATURE AND HUM IDITY: The first LCD sectio n can show the outdoor temperat ure, the reception indicator, the minim um or maximum reading.
60 2. MAX or MIN indoor temperat ure data with ti me and date of recordings. Data wil l flash 3. MAX or MIN indoor humidity data with time and date of re cordings. Data will fl ash 4. Return to current indoor and o utdoor data. TO VIEW THE MIN/M AX DATA FROM DIFFEREN T TRANSMITTERS When more than 1 trans mitter used 1.
61 transmitters can be set up again. Then The “l ost” channel can be re- learned again by entering the c hannel re-learn mode. To relearn all the transmi tters, press and hol d the CH key for 3 seconds (outdoor reception signal will show again next to c hannel displ ay).
62 Some examples of the intelli gent weather di splay: German English French Italian Spanish.
63 DETAILED IN FORMATION S HOWN I N THE WEATHER DISPLAY: Displayed Information English German French Italian Spanish Time frame for weather forecast Forecast period: 6 hours / 12 hours / 24 hours/ 36 .
64 Probability of glazed frost Glazed frost Index 75% Rauhreif Index 75% Givre Index 75% Indice brina: 75% Indice escarcha: 75% Probability of tempest Tempest Index 80% Gewitter Index 80% Orage Index .
65 another location for the Thermo-hygro Trans mitter and/or the Weather Station. If the outdoor temperature and humidity data are not being received within few minutes after setti ng up (or the outdoor di splay show “--.-“ in the outdoor section of the Intel ligent Weather Stati on).
66 1. Fix a screw (not suppl ied) into the desired wall , leaving the head extended o ut the by about 5mm. 2. Remove the stand from the W eather Station by pulling it away from t he base and hang the station onto the screw. Remem ber to ensure that it locks into place before rel easing.
67 To wall mount: 1. Secure the bracket onto a desi red wall using the screws and plasti c anchors. 2. Clip the remote temperature/hum idity sensor onto the bracket. Note: Before permanently fi xing the transmitter wall base, place all units in the desired locations to check that t he outdoor temperat ure and humidi ty readings are receivable.
68 SPECIFICATIO NS: Temperature meas uring range: Indoor : 0ºC to +59.9ºC wi th 0.1ºC resolution 32°F to +139.8°F wi th 0.2°F resolution ( “OF.L” displ ayed if outside this range) Outdoor : -39.9ºC to +59.9ºC wi th 0.1ºC resolution -39.8°F to +139.
69 shall take an active part in the re use, recycli ng and recovery of the electrical and electronic waste. • The unrestricted disposal of electronic waste may do harm on public health and the quali ty of environment.
Een belangrijk punt na aankoop van elk apparaat TFA 35.1070.IT (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen TFA 35.1070.IT heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens TFA 35.1070.IT vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding TFA 35.1070.IT leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over TFA 35.1070.IT krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van TFA 35.1070.IT bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de TFA 35.1070.IT kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met TFA 35.1070.IT . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
