Gebruiksaanwijzing /service van het product SG-1700 van de fabrikant Toshiba
Ga naar pagina of 20
.
1 IMPORT ANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Read and understand all instructions.
2 13. Do not use the telephone in the vicinity of a gas leak. CAUTION: TO REDUCE THE RISK OF FIRE OR INJUR Y TO PERSONS BY THE BA TTERY , READ AND FOLLOW THESE INSTRUCTIONS. 1. Use only the appropriate type and size battery pack specified in the instruction manual provided for this product.
3 SER VICE REQUIREMENTS If the cordless telephone should malfunction, or need changes or modifications, all repairs will be performed by an authorized T oshiba Service Station. This unit has been registered with the FCC for direct connection to the telephone network.
4 INTRODUCTION T oshiba America Consumer Products, Inc. takes pride in presenting the SG-1700, one of the finest digital spread spectrum cordless telephones available.
5 INST ALLA TION 1. SETTING UP THE BASE UNIT For use on a desk or counter top follow the instructions below . DESKTOP MOUNTING: Snap the bracket's tab into the notches on the base. • USE ONL Y WITH Supplied AC ADAPT OR (T AC-1700; power source AC 120V , 60Hz/DC 9V).
6 Red Black 2. CHARGE THE BA TTER Y P ACK Note Use only the supplied battery pack (TRB-8000; power source 600 mAh, 3.6V). q Remove the battery compartment cover on the back of the handset by sliding it down. w Plug the battery pack cord into the connector in the battery compartment in correct polarity .
7 After the battery pack is fully charged; Operation Approx. battery life While in use (T alk mode) up to 6 hours While not in use (Standby mode) up to 7 days When T ALK/BA TT LOW LED blinks, all handset buttons are disabled and the battery needs to be charged.
8 Wall mount template IMPORTANT: Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone. Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard.
9 LOCA TIONS OF CONTROLS HANDSET CONTROLS BASE UNIT CONTROLS T -P (T one-Pulse) Switch Antenna Charging Contacts REDIAL button DC IN 9V jack LINE Modular jack Antenna PAGE button Charging Contacts IN USE/CHARGE LED Speed Dial Index Card (back) Write down numbers stored in memory .
10 Please see “LOCA TION OF CONTROLS” for the location of each button used for the following operations. TONE/PULSE SETTING Set the TONE/PULSE switch on the back of the base unit to TONE and make a trial call. If the call does not connect, set the T ONE/PULSE to PULSE.
11 3. INTERFERENCE OR ST A TIC If you hear noise during a call, press CHANNEL to select another channel. The T ALK/BA TT LOW LED blinks during changing a channel. 4. CHANGING THE RINGER VOLUME Press / to select one of four ringer tone and volume combinations during standby mode.
12 8. SENDING T ONE SIGNAL (for Pulse service user) Even if you have Pulse service (the T one-Pulse switch is set to Pulse). Y ou can use this phone with banking and other phone services requiring touch tone signals. q Dial the service number and wait for the connection.
13 CARR YING THE HANDSET IN THE BEL T CLIP Y ou can attach the Belt Clip to the handset in order to carry it on your belt. Attaching the Belt Clip to the Handset Insert the Belt Clip tabs into the holes on each side of the handset until they click. Note Be sure to insert the tab properly into each hole to prevent the belt clip from falling off.
14 USING A HEADSET Y ou can talk with hands-free convenience using an optional headset (part #. RC008260) that has a 3/32-inch(2.5mm) plug. T o connect the headset, open the rubber cover on the left side of the handset, then insert the headset ’ s plug into the jack.
15 MEMOR Y DIALING Y ou can store up to 10 telephone numbers in memory . Notes In memory dialing operation, • If more than 20 seconds elapse between pressing buttons, the operation will be cancelled and you must start over again. • If you press a wrong button, an error tone sounds and the handset returns to standby mode.
16 2. DIALING A ST ORED NUMBER q Pick up the handset and press TALK . The T ALK/BA TT LOW LED lights. w Press MEM . e Enter the memory address (0 to 9). The stored number will be dialed. Note If you enter a memory address which does not have any stored number , error beeps sound.
17 ACCESSORIES SUPPLIED ACCESSORIES Rechargeable Battery pack (1) TRB-8000 Part #. RC004931 AC Adaptor (1) T AC-1700 Part #. RC009258 T elephone Cord (1) Part #. RC008231 Belt Clip (1) Part #. RC009263 Owner ’ s Manual (1) Part #. RC009259 Speed Dial Index (1) Part #.
18 PROBLEM Noise or interference. Battery goes low quickly . The handset battery does not charge. The unit operates abnormally . T ALK/BA TT LOW LED blinks. The operation is stopped. When the handset is returned to the base unit with the volume level set at High, a momentary squeal or howling sound may sometimes be heard.
UCZZ01700BZ RC009259 Printed in China © 2000 TOSHIBA AMERICA CONSUMER PRODUCTS. INC. (3) Within the continental U.S.A., if you should find a defective product within the warranty period please call 1- 877-644-7373.
Een belangrijk punt na aankoop van elk apparaat Toshiba SG-1700 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Toshiba SG-1700 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Toshiba SG-1700 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Toshiba SG-1700 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Toshiba SG-1700 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Toshiba SG-1700 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Toshiba SG-1700 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Toshiba SG-1700 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
