Gebruiksaanwijzing /service van het product 45xx Series van de fabrikant Ultra Start
Ga naar pagina of 16
-The system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
Page 2 This device complies with Part 15 of the FCC rules. Operation of this device is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
2WAY R EMOTE ST ARTER/ ALARM OWNER ’S GUIDE Page 3 R emote Star t - A u t o m a t i c T r a n s m i s s i o n 1. Press and release button #3. 2. The park light s will flash and the siren will chirp one time. 3. The vehicle will then remote start. The p ark light s will flash four times then remain on while the vehicle is running.
Page 4 Idle Mode 1. While the vehicle is running with key , press button #3 . 2. The park light s will turn on and the siren will chirp once. 3. T urn the ignition key off and the vehicle will continue to run. 4. Exit the vehicle and leave it running safely without leaving the keys in the Ignition.
Manual transmission remote st arters must be set into Reservation Mode before the remote st arter will activate. There are two different ways to place the system into Reservation Mode. The activation type of Reservation Mode is determined when the system is inst alled.
Page 6 1. Press and hold button #2 and the doors will unlock, continue holding button #2, the trunk release will activate. The trunk release will be confirmed by one park light flash and one siren chirp. Note: The trunk release output will not activate when the ignition key is in the “On” position.
Page 7 Car Finder is a feature that can be used to find your vehicle in a crowded parking lot. 1. Press and release button #4 twice within 3 seconds. 2. The park light s will flash and the siren will chirp five times to draw attention to the location of the vehicle.
Page 8 Auxiliary Output 1 (Optional) Sir en On/Of f Auxiliary Output 2 (Optional) Auxiliary Output are optional output s from the system. These output s Can be used to activate such things as power window roll-up/ down modules or to open and close a power sun roof.
Page 9 Cold S tart Mode will st art the vehicle at a user selectable st art interval or temperature setting. The vehicle can be set to start once every 1, 2, 3 or 4 hours in T imer Mode or to st art at 0,-5,-15 or -25 Celsius in T emperature Mode (L T Models Only) for a maximum 12 start s.
Page 10 KEY ICON- This icon will begin to flash when the remote st arter button is first pressed. Af ter the vehicle has st arted this icon will stay on solid. SIREN ICON- This icon indicates that the alarm has been triggered. The remote will st art to beep and the siren icon will come on solid at the same time as the icon for the violated zone.
Page 1 1 TIMER ICON- When this icon is displayed in the left program column if confirms that the T imer Mode has been programmed ON. When this icon is turned on in remote program mode the Cold S t art feature will be activated. Cold S t art will default to the last time or temperature setting.
Page 12 1 2 3 4 1 2 3 4 1st 2nd This feature can be used if the vehicle is p arked in an area with above average noise or vibrations. (Airport s, construction zone...) T o T emporally Byp ass The Shock Press the button #1 to arm the alarm then press button #3 within three seconds.
Page 13 1) Press and hold buttons #1 and #4 until the minute portion of the clock begins to flash. 2) T o set the minute, press button #3 to increase and button #2 to decrease the minute. 3) T o set the hour , press button #1 and the hour portion of the clock will begin to flash.
Page 14 A TTENTION: T O A VOID SERIOUS INJUR Y , this remote st art system must be set into Service Mode before any under hood servicing is st arted. Service Mode will prevent the vehicle from st arting while the vehicle is being serviced. It is the sole responsibility of the vehicle’ s owner to place the system into Service Mode.
Page 15 Being that the installer does not always see when the system shut s down or fails to start, Diagnostic Memory will store in memory up to four shut down codes. This information can then be accessed to determine the source of the shut down. T o Enter Diagnostic Mode: St ep 1 - T urn the ignition on then off.
Limited Lif etime W ar r anty The manufacturer warrants to the original purchaser of their remote starters and alarms, that the product shall be free from defects in material and workmanship.
Een belangrijk punt na aankoop van elk apparaat Ultra Start 45xx Series (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Ultra Start 45xx Series heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Ultra Start 45xx Series vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Ultra Start 45xx Series leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Ultra Start 45xx Series krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Ultra Start 45xx Series bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Ultra Start 45xx Series kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Ultra Start 45xx Series . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
