Gebruiksaanwijzing /service van het product TX-10 van de fabrikant Yamaha
Ga naar pagina of 19
Natural Sound AM/FM Stereo T uner Syntonisateur AM/FM stéréo de la série “Natural Sound” “Natural Sound” MW/UKW -Stereo-T uner Natural Sound AM/FM stereotuner Sintonizzatore stereo AM/FM a .
● Indoor FM Antenna ● Antenne FM intérieure ● UKW-Innenantenne ● FM inomhusantenn ● Antenna FM per interni ● Antena FM interior ● FM Binnenantenne ● Audio connection cord ● Câble d.
FEA TURES • 40 Station Random Access Preset Tuning • Automatic Preset Tuning • Multi-Status Station Memory • Direct PLL Synthesizer Tuning • Preset Station Shifting Capability • Multi-Functions for RDS Broadcast Reception (U.K. and Europe models only) CONTENTS Supplied Accessories.
ANTENNA CONNECTIONS ● Each antenna should be connected to the designated terminals correctly, referring to the following figure. ● Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength.
m Optional outdoor FM antenna Consult with your dealer or authorized service center about the best method of selecting and erecting an outdoor FM antenna.
m Optional outdoor AM antenna In steel buildings or at a great distance from the transmitter, it may be necessary to install an outside long wire antenna. GND terminal For maximum safety and minimum interference, connect the GND terminal to a good earth ground.
1 2 Select the reception band while watching the display. 3 4 If “PRESET” is being illuminated on the display, press the KEY MODE button to turn it off. 5 Tune to a desired station. To tune to a higher frequency, press the UP button once. To tune to a lower frequency, press the DOWN button once.
1 Follow steps 1 and 2 on the previous page. 2 3 If “PRESET” is being illuminated on the display, press the KEY MODE button to turn it off. 4 Tune to a desired station manually.
9 English 1 1 Select the page where the preset station is stored. 2 2 If “PRESET” is not being illuminated on the display, any preset station cannot be recalled. If so, press the KEY MODE button to turn it on. 3 3 Select the preset station number.
1 2 3 The automatic preset tuning begins from the frequency currently displayed. Received stations are programmed to A1, A2 ... A8 sequentially. * If more than 8 stations are received, they are also programmed to the preset station numbers on other pages (B, C, D and E) in that order.
11 English 1 Recall the preset station on E1 (by following the method of “To recall a preset station” on page 9). 2 3 Next, recall the preset station on A5 by following the same method with step 1.
12 RECEIVING RDS ST A TIONS ( U .K. and Europe models onl y ) RDS (Radio Data System) is a data transmission system gradually being introduced by FM stations in many countries. Stations using this system transmit an inaudible stream of data in addition to the normal radio signal.
13 English T o turn the unit into the PS mode or PTY mode Press the FREQ/PS/PTY button. Whenever pressed, the mode changes into the PS mode, PTY mode and returns to usual mode in turn. * When an RDS station is received, the display is automatically turned into the PS mode.
14 1 2 Turn the unit into the PS mode. * If “NO PS” flashes, proceed to the next step while flashing. If “NO PS” disappears before you proceed to the next step, press the FREQ/PS/PTY button again. 3 4 Select the first letter or numeral of the station name.
15 English Calling a preset RDS station b y the program type (PTY SEEK) By designating a program type, the unit automatically searches all preset stations for RDS stations of that program type. * There are 15 program types to classify RDS stations. For details, refer to page 12.
1 Tune to a desired RDS station. * Wait for about 10 seconds before proceeding to the next step. This allows the unit to search for more stations. 2 The unit searches for other stations with the same program. * If the station is not an RDS station, or there is no other station with the same program, “NO AF” flashes.
17 English TR OUBLESHOO TING If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested.
18 SPECIFICA TIONS FM SECTION Tuning Range ...................................................87.5 to 108 MHz 50 dB Quieting Sensitivity (IHF) [Except Europe model] 75 ohms Mono ........................................1.55 µV (15.1 dBf) 75 ohms Stereo .
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A. YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, D-2084 RELLINGEN BEI HAMBURG, F.
Een belangrijk punt na aankoop van elk apparaat Yamaha TX-10 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Yamaha TX-10 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Yamaha TX-10 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Yamaha TX-10 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Yamaha TX-10 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Yamaha TX-10 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Yamaha TX-10 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Yamaha TX-10 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
