Gebruiksaanwijzing /service van het product RCM 126 van de fabrikant Blaupunkt
Ga naar pagina of 31
Stockholm RCM 126 Radio / Cassette Operating instructions Stockh. RCM126 d® 30.04.2002, 15:19 Uhr 1.
3 PORTUGUÊS Stockh. RCM126 d® 30.04.2002, 15:19 Uhr 3 1 3 14 2 20 26 24 25 11 9 4 51 2 15 8 19 7 6 13 10 16 17 18 23 22 21.
32 Contents Quick reference ............................ 33 Important notes ............................ 39 Precautions ........................................... 39 Traffic safety ......................................... 39 Installation ...........
33 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS To programme the mute volume level, proceed as follows: • Adjust the desired volume. • Press for two seconds until you hear a beep. Now this volume level is stored as your mute volume.
34 6 Rocker switch Radio operation / Station search Up Down <</>> Up/Down in short intervals when AF is off <</>> To scroll through the station net- works when AF is on , e.g. NDR 1, 2, 3, 4, N-JOY, FFN, ANTENNE ... . Tape operation / Title selection (S-CPS) Up Down Fast forward Fast rewind Stop function by pressing .
35 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS 7 Display k e f g i h j l a m n o r b q p s c d a) NDR2 - Station name b) TR 2 - Track (side) 2 of the casset- te c) VIVALD.
36 < TIM ( T raff i c M emo) To play back the stored traffic an- nouncements: Press TIM briefly. To switch the priority for traffic an- nouncements on and off: Press TIM for approximately two sec- onds. When “TA” ( t raffic a nnouncement) lights up in the display, the system will play traffic stations only.
37 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS and number (disc number): • Press DIS briefly. A RM ( R adio M onitor) Press this button to listen to the radio while fast forwarding or rewinding the tape. To switch RM on/off: Press RM .
38 G LD Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range. LD on/off : Press the button. When the Loudness function is active, “LD” will light up in the display. See chapter “DSC programming” for more information.
39 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Important notes Precautions Before starting to use your new car radio, please read the following information care- fully. Traffic safety As the driver of a motor vehicle, it is your responsibility to pay attention to the traffic situation at all times.
40 • Press << or >>. The display will switch to “CHANGE”. • Push in the KeyCard. The card is re- leased and put in the proper position for being removed. • Remove the first KeyCard and insert the new one while “CHANGE” is still being displayed.
41 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Optical indication for extra security Flashing KeyCard tongue When the vehicle is stationary and the Key- Card removed, the KeyCard tongue can be switched to flash for extra anti-theft secu- rity.
42 Radio operation with RDS ( R adio D ata S ystem) If you leave the service area of the regional programme tuned into, or if you would like to take advantage of the full RDS service, switch to “REG OFF”. • Press the AF button for approximately two seconds until “REG OFF” appears.
43 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Scrolling through the broad- casting networks (only FM) You can use the << >> buttons to tune in stations of your reception area.
44 Automatically storing the stron- gest stations with Travelstore You can automatically store the six most powerful FM stations of your current recep- tion area sorted according to their signal strength. This function is particularly con- venient on longer trips.
45 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Switching from stereo to mono (FM) If reception is poor, you may get better sound quality by switching to mono: • Press the lo button for approximately two seconds. With mono playback, the stereo sign will disappear from the display.
46 If the system is unable to find a station offe- ring the selected programme type, the dis- play will show “NO PTY” and a beep tone will be released. The station received be- fore starting seek tuning will be tuned in. You can assign different programme types to each preset position.
47 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS During tape or CDC operation, the set will also automatically switch to the programme offering the selected PTY within the broad- casting network. After the PTY programme the system will remain in the radio mode.
48 Automatic seek tuning start (tape and CD changer operation) When leaving the reception area of the tuned in traffic programme station while listening to a tape or CD, the system will automatically start searching for a new TA programme.
49 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS T raffic Memo (TIM) This set is equipped with a digital speech memory, making it possible to automatically record up to four traffic messages lasting a maximum of four minutes.
50 TIM standby mode while the radio is switched off When the radio is off, you can set the TIM timer such that the broadcast traffic messa- ges will be automatically recorded at the programmed times. To recall these messa- ges, proceed as described above.
51 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Warning note Danger of damaging the motor antenna in a car wash If you have installed a motor antenna, it will remain extracted when turning off the radio while the TIM timer is active.
52 of at least three seconds between the indi- vidual titles. Switching the tape side (autoreverse) To change the tape direction during casset- te playback: • Press . At the end of a tape side, the mechanism changes directions automatically to play the other side (autoreverse).
53 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Care notes To avoid possible problems, we recommend you to use C-60/C-90 type cassette tapes only. Store your tapes in a cool place away from dirt, dust and temperatures exceeding 50 ° Celsius.
54 “TIME” – The elapsed playback time of the title is display- ed, for example “2 : 32”. “NUMBER” – The CD position in the magazine (disc number) is displayed, for example “CD8 T5”. To switch the display mode: • Press DIS during CD playback.
55 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS You have the choice between the capital letters A to Z, special characters and the numbers 0 to 9. • Use the rocker switch << >> to move to the next underscore and select a character.
56 TIME The current time will be dis- played or has to be set. For more information see chap- ter “Traffic Memo (TIM) - Setting the clock in the DSC menu”. TIMER 1 To set the first TIM time. For more information please refer to chapter “Traffic Memo (TIM) - Programming the TIM standby mode / TIM times”.
57 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS COLOUR (Variocolour) For gradually matching the radio illumination with the dashboard lighting. green .............. light orange ................. red LED ON Here you can choose be- tween LED ON or LED OFF.
58 VOL FIX Use this function to select the volume at which the ra- dio is set when it is switched on. Adjust the desired volu- me level with << >>. When adjusted to “VOL 0”, the system will come on with the volume selected before switching the radio off.
59 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Blaupunkt telephone hotline Address of the next service centre in your vicinity (only for Germany) If you would like to know the address of the next Blaupunkt service centre of your area without having our service list at hand: - Find out your area code.
32 Blaupunkt-Werke GmbH Bosch Gruppe 8/96 Pf K7/VKD 8 622 400 571 Stockh. RCM126 d® 30.04.2002, 15:20 Uhr 32.
Een belangrijk punt na aankoop van elk apparaat Blaupunkt RCM 126 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Blaupunkt RCM 126 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Blaupunkt RCM 126 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Blaupunkt RCM 126 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Blaupunkt RCM 126 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Blaupunkt RCM 126 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Blaupunkt RCM 126 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Blaupunkt RCM 126 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
