Gebruiksaanwijzing /service van het product RCR 148 van de fabrikant Blaupunkt
Ga naar pagina of 24
Bergamo RCR 148 Montana RCR 148 Wiesbaden RCR 148 Radio / Cassette Operating instructions Ber/Mon/WiRCR148 d 08.05.2002, 11:35 Uhr 1.
2 3 2 4 11 Fernbedienung RC 06 (Option) Remote control RC 06 (optional) Télécommande RC 06 (en option) Telecomando RC 06 (optional) Afstandsbediening RC 06 (Optie) Fjärrkontroll RC 06 (Tillval) Man.
24 Contents Quick reference ............................ 25 Important notes ............................ 30 Precautions ........................................... 30 Traffic safety ......................................... 30 Installation ...........
25 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS When pressing VOL- , the (mute) volume will be adopted. To programme the mute volume level, proceed as follows: • Adjust the desired volume. • Press for 1 second until you hear a beep.
26 Tape operation / Title selection (S-CPS) Up Down Fast forward Fast rewind Stop function by pressing the opposite key. Extra rocker switch functions: Further setting functions with AUD B DSC Mode A PTY @ Condition: The corresponding function is activated.
27 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS 6 KeyCard theft protection system To operate the set the KeyCard must be inserted first. K eyCard Insert KeyCard When the KeyCard tongue is protrud- ing out of the unit, insert the KeyCard with the contact area facing up into the slot in the middle of the area.
28 Preset Scan Preset Scan cannot be started unless PTY has been switched off (“PTY” does not light up in the display). Press SC for approximately 1 second until you hear a beep. “SCAN” will alternate with the name or frequency of the scanned station in the display.
29 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS @ PTY ( P rogramme Ty pe) In the PTY mode, the preset buttons become programme type buttons. With every preset you can select one pro- gramme type, such as for example NEWS, SPORT, POP MUSIC, EDU- CATE, etc.
30 Important notes Precautions Before starting to use your new car radio, please read the following information care- fully. Traffic safety Traffic safety always has the highest priori- ty. As the driver of a motor vehicle, it is your responsibility to pay attention to the traffic situation at all times.
31 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS If a wrong KeyCard is inserted, then “CARD ERR” followed by “WAIT” will appear in the display. In this case please do not make any further adjustments. The system will switch off by itself after ap- proximately 10 seconds.
32 Switching the audio source Using the SRC button you can switch be- tween radio and tape operation. Tape operation is only available if a cassette is inserted.
33 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS If “SEARCH” appears in the display when switching on the radio or recalling one of the stored frequencies, the unit is automatically searching for an alternative frequency.
34 Manual tuning: • Press << >>; the frequency will change in short intervals in downwards or up- wards direction. When holding the right or left part of the rock- er switch depressed, the frequency scan is speeded up.
35 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Recalling stored stations You can recall any stored station at the touch of a button. • Select the memory bank with FM T or BND . • Press the corresponding preset button briefly to recall the station.
36 The sensitivity level can be altered sepa- rately in both modes. Please refer to chap- ter “DSC programming - S-LO, S-DX”). Switching from stereo to mono Every time the radio is switched on, stereo playback is activated automatically. The unit will gradually switch to mono if re- ception is poor.
37 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS FOLK M USIC DOCUMENT ARY ALARM TEST (for service only) Checking the programme type of the station • Press PTY for approximately 1 sec. After the beep tone the display will show the programme type offered by the tuned in sta- tion.
38 - The system will switch to the linked NDR2 station for the duration of the “POP” programme. During tape operation, the set will also au- tomatically switch to the programme offer- ing the selected PTY within the broadcast- ing network. After the PTY programme the system will remain in the radio mode.
39 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Receiving traffic programme stations with RDS-EON Traffic announcement priority on/off If the priority for traffic announcement pro- grammes is activated, “TA” will light up in the display.
40 Adjusting the volume for traffic announcements and the beep tone This volume was preset at the factory, though you can alter the value using the DSC function (see “DSC programming, TA VOL”). If the volume level is altered while a mes- sage is being played, this will only affect the current announcement.
41 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Switching the tape side (autoreverse) To change the tape direction during cassette playback: • Press briefly. At the end of a tape side the mechanism changes directions automatically to play the other side (autoreverse).
42 DSC programming DSC ( D irect S oftware C ontrol) allows you to customise certain programmable, basic settings to suit your personal needs and preferences and then store them.
43 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS LEARN KC To “train” a second Key- Card. Please read the information in chapter “KeyCard theft protection system - Training a second KeyCard”. READ KC To read out the KeyCard data.
44 Appendix Specifications Amplifier Output power: 4 x 23 W RMS power acc. to DIN 45324 at 14.4 V 4 x 35 W max. power Tuner Wavebands: FM : 87.5 – 108 MHz (only Bergamo RCR 148) MW 531 – 1602 kHz LW 153 – 279 kHz FM sensitivity: 0.
24 Blaupunkt-Werke GmbH Bosch Gruppe 10/97 Ts K7/VKD 8 622 401 345 Ber/Mon/WiRCR148 d 08.05.2002, 11:34 Uhr 24.
Een belangrijk punt na aankoop van elk apparaat Blaupunkt RCR 148 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Blaupunkt RCR 148 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Blaupunkt RCR 148 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Blaupunkt RCR 148 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Blaupunkt RCR 148 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Blaupunkt RCR 148 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Blaupunkt RCR 148 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Blaupunkt RCR 148 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
