Gebruiksaanwijzing /service van het product RDM 126 van de fabrikant Blaupunkt
Ga naar pagina of 32
London RDM 126 Radio / CD Operating instructions London RDM126 d 20.06.2002, 13:40 Uhr 1.
3 ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS 1 3 14 2 17 20 18 19 11 9 45 1 2 15 8 16 7 6 13 10 London RDM126 d 20.06.2002, 13:40 Uhr 3.
32 Contents Quick reference ............................ 33 Important notes ............................ 39 Precautions ........................................... 39 Traffic safety ......................................... 39 Installation ...........
33 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS To programme the mute volume level, proceed as follows: • Adjust the desired volume. • Press for two seconds until you hear a beep. Now this volume level is stored as your mute volume.
34 6 Rocker switch Radio operation / Station search Up Down <</>> Up/Down in short intervals when AF is off <</>> To scroll through the station net- works when AF is on , e.g. NDR 1, 2, 3, 4, N-JOY, FFN, ANTENNE ... . CD operation / Title selection Up Down Press once to go back to the be- ginning of the current title.
35 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS 7 Display d k e f g i h j l a m n b o p c a) NDR2 - Station name b) VIVALDI - CD name or c) 1 : 52 - CD time (playback time.
36 < TIM ( T raff i c M emo) To play back the stored traffic an- nouncements: Press TIM briefly. To switch the priority for traffic an- nouncements on and off: Press TIM for approximately two sec- onds. When “TA” ( t raffic a nnouncement) lights up in the display, the system will play traffic stations only.
37 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS (Eject) Hold down the button for approximate- ly two seconds (beep) and the CD will eject. @ 1, 2, 3, 4, 5, 6 - preset buttons On FM, you can store six stations for each of the memory banks I, II and T.
38 C GEO To adjust the balance (left/right) and fader (front/rear) with the rocker switch. Fader front Fader rear Balance left Balance right The last setting will be stored automat- ically. To switch off GEO: Press button once again. If the setting remains unchanged with- in four seconds, the display will switch back to the previous condition.
39 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Important notes Precautions Before starting to use your new car radio, please read the following information care- fully. Traffic safety As the driver of a motor vehicle, it is your responsibility to pay attention to the traffic situation at all times.
40 • Press << or >>. The display will switch to “CHANGE”. • Push in the KeyCard. The card is re- leased and put in the proper position for being removed. • Remove the first KeyCard and insert the new one while “CHANGE” is still being displayed.
41 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Optical indication for extra security Flashing KeyCard tongue When the vehicle is stationary and the Key- Card removed, the KeyCard tongue can be switched to flash for extra anti-theft secu- rity.
42 Radio operation with RDS ( R adio D ata S ystem) If you leave the service area of the regional programme tuned into, or if you would like to take advantage of the full RDS service, switch to “REG OFF”. • Press the AF button for approximately two seconds until “REG OFF” appears.
43 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Scrolling through the broadcast- ing networks (only FM) You can use the << >> buttons to tune in stations of your reception area.
44 Automatically storing the strongest stations with Travel- store You can automatically store the six most powerful FM stations of your current recep- tion area sorted according to their signal strength. This function is particularly con- venient on longer trips.
45 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Switching from stereo to mono (FM) If reception is poor, you may get better sound quality by switching to mono: • Press the lo button for approximately two seconds. With mono playback, the stereo sign will disappear from the display.
46 If the system is unable to find a station of- fering the selected programme type, the dis- play will show “NO PTY” and a beep tone will be released. The station received be- fore starting seek tuning will be tuned in. You can assign different programme types to each preset position.
47 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS - NDR2 airs a PTY-POP programme. - The system will switch to the linked station NDR2 for the duration of the “POP” programme. During CD or CDC operation, the set will also switch to the programme offering the selected PTY within the broadcasting net- work.
48 Automatic seek tuning start (CD and CDC operation) When leaving the reception area of the tuned in traffic programme station while listening to a CD, the system will automatically start searching for a new TA programme. If no such station is found within approxi- mately 30 seconds, CD operation will be stopped and a warning beep will sound.
49 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Programming the TIM standby mode / TIM times You can programme two TIM times (TIMER 1 and TIMER 2). For example, TIMER 1 could be the time when leaving home in the morning, TIMER 2 the time when driving home after work.
50 • Press / to set the timer. • Press << to set the hours and >> to set the minutes. Once you have completed the setting, • press or DSC . The clock setting for TIMER 1 has been stored. Proceed in the same way to set the TIMER 2. Recalling stored traffic messag- es • Press TIM briefly.
51 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS Warning note Danger of damaging the motor antenna in a car wash If you have installed a motor antenna, it will remain extracted when turning off the radio while the TIM timer is active.
52 CD and CDC changer operation (optional) Removing a CD • Press the button for approximately one second (beep). The CD will be ejected. To protect the CD mechanism, do not im- pair or try to help the automatic insertion and ejection of the disc in any way.
53 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS CDC operation (optional) Switching to CDC operation Make sure that at least one CD has been inserted into the magazine. Press SRC to go through the available au- dio sources: • Press as many times until the display briefly shows “CDC”.
54 Storing the display mode You can store your preferred display mode which will then be active each time the ra- dio is switched on. If required, • press AF as many times until the de- sired setting is displayed. • Hold down the AF button until you hear a beep.
55 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS b) Clearing a CD from the TPM: • Switch on TPM . • Press the CLR button for approxi- mately four seconds until “CLR DISC” appears in the display. Now this disc has been cleared from the TPM.
56 Once you have completed the name as de- sired: • Press in order to store it. To quit the naming mode, • leave the DSC menu by pressing DSC . If you would like to name another CD, • insert a new disc in the CD mode or select a new one for CDC operation.
57 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS DSC programming DSC ( D irect S oftware C ontrol) allows you to customise certain programmable, basic settings to suit your personal needs and preferences and then store them.
58 BEEP Acknowledgement tone for all functions which require a button to be pressed for more than one second. The volume can be adjusted from between 0 to 9. (0 = off). ANGLE Use this setting to alter the viewing angle to your liking from -1 to 0 to +1.
59 ENGLISH DEUTSCH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS S-LO To adjust the seek tuning sensitivity for local recep- tion. LO 1 - high sensitivity LO 3 - low sensitivity The seek tuning sensitivity values can be separately set for AM and FM.
60 Appendix Specifications Amplifier Output power: 4 x 23 W RMS power acc. to DIN 45324 at 14.4 V 4 x 35 W max. power Tuner Wavebands: FM : 87.5 – 108 MHz MW : 531 – 1602 kHz LW : 153 – 279 kHz FM sensitivity: 0.
32 Blaupunkt-Werke GmbH Bosch Gruppe 8/96 Pf K7/VKD 8 622 400 572 London RDM126 d 20.06.2002, 13:41 Uhr 32.
Een belangrijk punt na aankoop van elk apparaat Blaupunkt RDM 126 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Blaupunkt RDM 126 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Blaupunkt RDM 126 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Blaupunkt RDM 126 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Blaupunkt RDM 126 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Blaupunkt RDM 126 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Blaupunkt RDM 126 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Blaupunkt RDM 126 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
