Gebruiksaanwijzing /service van het product HN6410 van de fabrikant CDA
Ga naar pagina of 24
IMPORT ANT : PLEASE REFER TO P A GE 20 FOR INFORMATION ON CONFIGURING THE POWER CONSUMPTION MODE CORRECTL Y . THE HOB MUST BE CONFIGURED A T FIRST SWIT CH ON. Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
2 Important The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment.
3 2004/108/EC. Parts intended to come into contact with food conform to 89/109/EC. IMPORT ANT INFORMA TION FOR CORRECT DISPOSAL OF THE PRODUCT IN A CCORD ANCE WITH EC DIRECTIVE 2002/96/EC.
4 • Do not place hot lids flat on the hob top. A “ suction” eect could cause damage to the hob. • Do not drag cookware across the hob top: in the long term, this could cause damage to the hob. • Do not store cleaning or flammable products in the unit below the hob.
5 Important • Do not use the hob if the glass surface is cracked or damaged to prevent the risk of electric shock. Disconnect it from the power supply . • Ensure that the power cables of connected electrical appliances near the hob are not in contact with the cooking zones.
6 Cooking on Induction The principle of induction cooking is based on magnetic eect. When you put your cookware on an induction zone and switch it on, the electronic boards in the hob produce induced currents in the base of the cookware and instantly raise its temperature.
7 Using Y our Hob The table below oers guidance as to what each power level is for . Power level Type of cooking 0 Switched o 1/2 Melting (butter/chocolate) or keeping food warm 2/3 K eeping food hot or to heat small quantities of liquid 3/4 Heat larger quantities of liquid (sauces etc.
8 Using Y our Hob T o switch the hob on T o switch the power on, touch and hold the key for appro ximately two seconds. The hob will beep and all four zone displays will show zero. Please note: If a power level is not set within ten seconds, the hob will switch o automatically .
9 Booster The hob is equipped with a booster function, allowing a higher power level than the maximum for appro ximately ten minutes. T o turn on the booster function, touch the “+” key when the power level is already set at 9 . “ P” will show in the display .
10 seconds remaining. At the end of the timer , the selected zone will switch o and the timer display and the zone timer LED will flash. The hob will beep for appro ximately one minute. T o switch o the beep and the flashing displays, touch any key .
11 childlock is switched o . Use of the childlock when the hob is o The childlock LED is illuminated to show the childlock is on. Use of the childlock when the hob is in use The childlock LED is illuminated to confirm that the childlock is switched on and no adjustments can be made to any of the zones or the timer .
12 Small object safety Anything left on the control panel (e.g. cutlery or towels) will cause the hob to switch o automatically and there will be a beep every ten seconds until the obstruction is removed.
13 Ecient Use of Y our Hob The hob is equipped with zones of dierent sizes, designed to accommodate most shapes and sizes of pan. For best results, only use pans with flat bottoms and choose an appropriate zone depending on the size of the pan.
14 Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. Important: • S team cleaners must not be used when cleaning this appliance. • Y ou should use a non-abrasive cleaner to clean the hob top.
15 In the event of a fault with the hob, please advise CD A Customer Care of any fault code shown on the display Contact CD A Customer Care A : Customer Care Department, The CD A Group L td, Harby Road, Langar , Nottinghamshire , NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
16 IMPORT ANT - PLEASE NOTE: In the event of any breakage , crack or cracking – even minimal – of the vitroceramic glass, immediately disconnect your appliance to prevent a risk of electric shock and contact CD A Customer Care. In use Y ou observe that Possible Causes What should you do ? The hob has stopped operating.
17 Fitting the Hob Unpacking the hob: T ake care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 180mm away from any adjacent vertical surfaces, e.
18 recommended) (Fig. 4). If the instructions supplied with the hood dictate that the hood must be installed at a height greater than 600mm, then that height is the minimum required. W all furniture requirements: The minimum height of any cabinet immediately above the hob is 900mm.
19 How to Install the Hob Overall dimensions of the hob: Width: 580 mm Depth: 510 mm W orktop cut-out dimensions: Width: 560 mm Depth: 490 mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance.
20 P ower Conguration This hob can be connected to a 13, 16, 25 or 32Amp supply and configured to work on any of these power settings. If the hob is connected to a 32Amp supply all four zones can be used on the maximum setting with boost at the same time.
21 Mains Electricity Connection W arning! this appliance must be earthed W e recommend that the appliance is connected by a qualified electrician, who is a member of the N.
22 3.5k W-7 .2kW modes When configured in any mode other the 2.8k W , the hob should be installed into a dedicated cooker outlet and protected by the size of fuse shown in the table above. This appliance is intended to be connected to fix ed wiring by a double pole switch, having a contact separation of at least 3mm in all poles.
23.
Please contact our Customer Care Department for Service on the details below Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
Een belangrijk punt na aankoop van elk apparaat CDA HN6410 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen CDA HN6410 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens CDA HN6410 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding CDA HN6410 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over CDA HN6410 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van CDA HN6410 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de CDA HN6410 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met CDA HN6410 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
