Gebruiksaanwijzing /service van het product HN6730 van de fabrikant CDA
Ga naar pagina of 28
Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
2 Important The CD A Group L td cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CD A reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment.
3 2004/108/EC. Parts intended to come into contact with food conform to 89/109/EC. IMPORT ANT INFORMA TION FOR CORRECT DISPOSAL OF THE PRODUCT IN A CCORD ANCE WITH EC DIRECTIVE 2002/96/EC.
4 surface prior to use. • Do not modify the appliance in any way as this will invalidate the guarantee and is potentially dangerous. • The hob top is not designed for any use other than cooking: any other use (e.g. as a worktop) is potentially dangerous and will invalidate the guarantee.
5 capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. • Children shall not play with the appliance. • Cleaning and user maintenance shall not be made by children without supervision.
6 divider must be made of material capable of withstanding 65°C above ambient temperature. • Never place inammable items or materials in a drawer or cupboard below the hob. Precautions in the event of an appliance fault • If a fault is noticed, switch o the appliance and turn o the electricity supply .
7 FOR THOSE WITH HEART P A CEMAKERS OR A CTIVE IMPLANTS: The function of this hob conforms to current electromagnetic interference standards and thus is in total compliance with legal requirements (2004/108/CE directives).
8 Cooking On Induction The principle of induction cooking is based on magnetic eect. When you put your cookware on an induction zone and switch it on, the electronic boards in the hob produce induced currents in the base of the cookware and instantly raise its temperature.
9 Using Y our Hob Fig. 1 On / O Zones: 1. Front left 2. 0kW 175mm 2. Back left 1.4kW 175mm 3. Back right 3. 0kW 215mm 4. Front right 1.4kW 175mm 1 2 3 4 Pause Booster Special programmes Slider cont.
10 The table below oers guidance as to what each power level is for . Using Y our Hob T o switch the hob on T o switch the power on, touch the “On/O ” key for appro ximately two seconds. The hob will beep and all four zone displays will show zero.
11 T o change the power level after it has been set • T o increase the power level for a zone: A fter touching the “Power key” for that zone, slide your nger along the slider toward the right. • T o reduce the power level for a zone: A fter touching the “Power key” for that zone, slide your nger along the slider toward the left.
12 The heating level of the bridged zone is controlled just by using the front left “Power key” followed by the slider . T o cancel the bridge function T ouch the “Power keys ” for the front and rear left zones at the same time again. The zone displays will show either “0” or “H” (residual heat indicator).
13 Programmes” k ey instead of using the slider to set the power level, after touching the zone “Power key” . This function may be set on all four zones independently .
14 preset period of time. When auto-heating has nished the power will reduce to the level set. • If no nal power level is set, the auto-heat is switched o and the zone will remain on power level “9” .
15 • Use the slider to reduce the units of the time to zero . • T ouch the “Timer” display again to conrm the units setting. • Use the slider to reduce the tens of units of the time to zero . • T ouch the “Timer” display again to conrm the tens of units setting.
16 T o cancel the beeper: touch the “Timer” display once. T o cancel the minute minder • T ouch the “Timer” display to select the timer . • Use the slider to reduce the units of the time to zero . • T ouch the “Timer” display again to conrm the units setting.
17 R ecall function Even after switching the hob o with the On/O key , it is still possible to recall and re-use the settings that were last used.
18 Fig.2 switches o • T ouch the “On/O ” key for appro ximately two second to switch the hob on. Ecient Use of Y our Hob The hob is equipped with zones of dierent sizes, designed to accommodate most shapes and sizes of pan.
19 Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. Important: • S team cleaners must not be used when cleaning this appliance. • Y ou should use a non-abrasive cleaner to clean the hob top.
20 In the event of a fault with the hob, please advise CD A Customer Care of any fault code shown on the display Contact CD A Customer Care A: Customer Care Department, The CD A Group L td, Harby R oad, Langar , Nottinghamshire, NG13 9HY T: 01949 862 012 F : 01949 862 003 E : service@cda.
21 IMPORT ANT - PLEASE NOTE: In the event of any breakage , crack or cracking – even minimal – of the vitroceramic glass, immediately disconnect your appliance to prevent a risk of electric shock and contact CD A Customer Care. In use Y ou observe that Possible Causes What should you do ? One or all of the zones cuts out.
22 Fitting the Hob Unpacking the hob: T ake care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 180mm away from any adjacent vertical surfaces, e.
23 the hood above the hob must be at least 600mm (650mm is recommended) (Fig. 4). If the instructions supplied with the hood dictate that the hood must be installed at a height greater than 600mm, then that height is the minimum required. W all furniture requirements: The minimum height of any cabinet immediately above the hob is 900mm.
24 How to Install the Hob: Overall dimensions of the hob: Width: 590 mm Depth: 520 mm W orktop cut-out dimensions: Width: 560 mm Depth: 490 mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance.
25 Mains Electricity Connection W arning! this appliance must be earthed W e recommend that the appliance is connected by a qualied electrician, who is a member of the N.
26 connection bo x. • As the appliance is not tted with an accessible plug, a means of disconnection from the power supply must be must be included in the fix ed insatllation, in accordance with the installation regulations. • The inlet cable must be positioned so that it does not touch any of the hot parts of the hob or oven.
27 Appliance electrical rating: 7100W Any service call arising from incorrect installation may result in a charge. CD A and its representatives cannot be held responsible for any matters resulting from incorrect connection, or related to either the absense of an earth connection or a faulty earth connection.
Please contact our Customer Care Department for Service on the details below Customer Care Department • The Group Ltd. • Harby R oad • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.
Een belangrijk punt na aankoop van elk apparaat CDA HN6730 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen CDA HN6730 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens CDA HN6730 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding CDA HN6730 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over CDA HN6730 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van CDA HN6730 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de CDA HN6730 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met CDA HN6730 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
