Gebruiksaanwijzing /service van het product AIRCAP3502EAK9 van de fabrikant Cisco Systems
Ga naar pagina of 30
G ETTING S TARTED G UIDE Cisco Aironet 3502P Li ghtweight Access Point 1 About this Guide 2 Safety In structions 3 Unpac k ing 4 Overview 5 Configuring the Access P oint 6 Mounting the Access P oint 7.
2 1 About this Guide This Guide provides in structions on how to inst all and configure your Cisco Aironet 3502P Access Point. This guide also provides mounting instru ctions and limited troublesh ooting procedures.
3 War n in g This product relies on the building’ s installation for short-circuit (overcurrent) protection. Ensure tha t the protective device is rated not greater than: 20A.
4 Step 3 V erify that you hav e received the items listed below . If any item is missing or damaged, contact your Cisco representative or reseller for instructions.
5 Figur e 2 Access P oint Por ts and Connecti ons (bot tom) 1 2.4-GHz antenna connector B (labelled with black text) 4 5-GHz antenna connector A (labelled with blue text) 2 2.4-GHz antenna connector C (labelled with black text) 5 5-GHz antenna connector C (labelled with blue text) 3 2.
6 5 Configuring the Access Point This section describes how to connect the access point to a wireless LAN controller . Because the configuration process takes plac e on the controller , see the Cisco Wireless LAN Controller Configuration Guide for additional information.
7 Access points must be discovered by a controller before they can become a n active part of the network. The 3502P access point supports these controller discovery processes: • Layer 3 CAPW AP disc.
8 Note Y ou can mount the access point above a suspended cei ling but you must purchase addition al mounti ng hardware : See “Mou nting the Acc ess Point ” section on page 12 for additional information.
9 Pre-Installation Configuration Setup Figure 3 shows the pre-installation configuration setup. Figure 3 Pr e-Inst allation Configuration Setup Follow these steps to perform the pre-installa tion configuration. Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network.
10 e. CAPW AP UDP ports must not be blocked in the network. f. The access point must be able to find the IP address of the controller . This can be accomplished using DHCP , DNS, or IP subnet broadcast. This guide describes the DHCP method to convey the controller IP addres s.
11 c. If the access point shuts down, check the power source. d. After the access point finds the Cisco wireless LAN controller, it attempts to download the new operating system code if the access point code version differs from the Cisco wireless LAN controller code version.
12 6 Mounting the Access Point Cisco Aironet 3502P access points can be mounted in several con figurations, including on a suspended ceiling, on a hard ceiling or wall, on an elecrtical or network box, and above a suspended ceiling.
13 Note A Master Cisco wireless LAN controller shoul d be used only for configuring access points and not in a working network. 8 Troubleshooting If you experience difficulty getti ng your access point installed and running, lo ok for a solution to your problem in this guide or in additional access po int documentation.
14 Checking the Access Point LED Figure 4 sho ws the location of the access point Status LED. Figur e 4 Access P oint LED Location T able 1 shows the access point Status LED indications for various conditio ns.
15 Association status Green Normal operating condition, but no wireless client associated Blue Normal operating condition, at least one wireless client association Operatin g status Blinking blue Soft.
16 Troubleshooting the Ac cess Point Join Process Access points can fail to join a controller for many reasons: a R ADIUS auth orization is pending; self-signed certificat es are not enabled on the cont roller; the access point’ s and controller’ s regulatory domains don’ t match, and so on.
17 • The access point is still connected to the same cont roller , and the global syslog server IP address configuration on the controller has been changed using the config ap syslog host global syslog_server_ IP_address command. In this case, the controller sends the new global syslog server IP address to the access point.
18 Manufacturer: Cisco Systems, Inc. 170 W est T asman Drive San Jose, CA 95134-1706 USA This device complies with Part 15 rules. Operation is subject to the followin g two conditions: 1.
19 Caution The Part 15 radio device operates on a non- interference basis with other devices operating at this frequency when using the integrated antennas. Any changes or modi fication to the product not expressly approved by Cisco could void the user’ s authority to operate this device.
20 Guidelines for Operating Cisco Aironet Access Points in Japan This section provides guidelines for avoiding interf erence when operating Cisc o Aironet access points in Japan.
21 Statement 371—Power Cable and AC Adapter English Translation When installing th e product, please use the provided or d esignated connection cable s/power cables/AC adaptors.
22 Cisco Aironet Access Points are cert ified to the requiremen ts of RSS-210. The use of this device in a system operating either parti ally or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations.
23 Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC.
24 The following standards were applied: EMC—EN 301.489-1 v1.4.1; EN 301.489-17 v1.2.1 Health & Safety—EN60950-1: 2001; EN 50385: 2002 Radio—EN 300 328 v 1.7.1; EN 301.893 v 1.5.1 The conformity assessment procedure ref erred to in Article 10.
25 This device also conforms to the EMC requirem ents of the Medical Devices Directi ve 93/42/EEC. Note This equipment is intended to be used in a ll EU and EF T A countries. Outdoor use may be restricted to certain frequencie s and/or may require a license fo r operation.
26 Australia This system has been evaluated fo r RF exposure for Humans as refe renced in the Australian Radiation Protection standard and has been evaluated to the ICNIRP (International Commission on Non-Ionizing Radiation Protection) limits. The mi nimum separation distance from the antenna to general bystander is 20cm (7.
27 network <IP Network> <Netmask> default-router <Default router> dns-server <DNS Server> Where: <pool name> is the name of the DHCP pool, such as AP3502 <IP Network> is the network IP address where the controller resides, such as 10.
28 Operating temperatures -4 to 131 degrees F (-20 to 55 degrees C) Storage te mperatur e –22 to 185 de grees F (–30 to 85 degrees C) Humidity 10% to 90% (noncondensing) Antennas External Complian.
29.
Americas Headquarters Cisco Systems, I nc. 170 W est T asman Drive San Jose, CA 95134- 1706 USA www .cisc o.com T el: 408 526-4000 800 553-NETS (6387) Fax: 408 527-0883 Asia Pacific Headquarters Cisco Systems (USA) Pte. Ltd. 168 Robinson Road #28-01 Capital T ower Singapore 068912 www .
Een belangrijk punt na aankoop van elk apparaat Cisco Systems AIRCAP3502EAK9 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Cisco Systems AIRCAP3502EAK9 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Cisco Systems AIRCAP3502EAK9 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Cisco Systems AIRCAP3502EAK9 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Cisco Systems AIRCAP3502EAK9 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Cisco Systems AIRCAP3502EAK9 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Cisco Systems AIRCAP3502EAK9 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Cisco Systems AIRCAP3502EAK9 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
