Gebruiksaanwijzing /service van het product 1200i van de fabrikant Compatible Systems
Ga naar pagina of 45
MicroRouter 1200i Installation Guide Comp atible Sys tems Corp oratio n 4730 Wal nut Stre et Suite 1 02 Boulde r, Colo rado 80301 303- 444- 9532 800- 356- 0283 http://www.
Micr oRout er 1 200i I nstal lat ion Gu ide , Vers ion 3.0 Copyr ight © 19 99, Compa tibl e S ystem s Cor pora tion All rights reser ved. MicroRouter and Compat iView are trademarks of Compatible Sys tems Corporation. Other trademarks ar e the property of their respective holders.
i Chapte r 1 - Introducti on 1 A BOU T THE M ICRO R OUTER 1200 I 1 AN OTE A BOU T F IREWALLS 1 AN OTE A BOU T O N -D EMAND I NTERNETWORKING 1 M ICRO R OUTER 1200 I I NSTALLATION O VERVIEW 2 Chapter 2 .
ii Chapte r 4 - CompatiView Software Ins tallatio n 13 C OMPATI V IEW FOR W INDOWS 13 System Req uirements 13 Installa tion and Oper ation 13 Transpo rt Protocols and Compa tiView 14 Chapter 5 - Comma.
iii IPX Pro tocol 24 Required for IPX 24 Suggeste d for IPX 24 Frame Rel ay Configur ation 25 Link Co nfigur ation 25 Suggeste d for Dedicate d/Leas ed Line Operatio n 25 Frame Rel ay DLCI Mapping s 2.
iv Appendix B - C onnector and Cable Pin Outs 31 Pin Out s for V.35 Female Con necto r (DTE) 31 Pin Out s for D B-25 Male to DB-2 5 Female RS -232 Dat a & Consol e Cable 32 Appendix C - LED Pa tte.
Chapter 1 - Introducti on 1 Chapter 1 - Introduction About the MicroRouter 1200i Congrat ulations on your pur chase of the MicroRouter 1200i m ultiport wide ar ea router .
2 Chapter 1 - Introducti on BE SURE THA T YOUR ROUTER C ONFIGURA TION IS ALLOWING THE ROUTER TO DROP THE COMMUNICA TIONS LINK WHEN IT I SN’T NEEDED. MicroRo uter 1200i Insta llation Overvi ew This manual wi ll help you ins tall the MicroR outer 1200i to c onnect a local Ethernet to on e or two remote networks and/or remote PPP cli ent computer s.
Chapter 1 - Introducti on 3 Chapter 3 - Network Inst allation Here you will find step-by-step in structions on how to physically instal l the MicroR outer 1200i and connect i t to your local Ether nets and you r wide area net work(s).
..
Chapter 2 - Getting Started 5 Chapter 2 - Getting Started AF e wN o t e s Please Read The Manuals The manuals incl uded with your MicroRout er 1200i contain some very important info rmation about the Mic roRouter 1200i and local an d wide area networki ng in general.
6 Chapter 2 - Getting Started What You Will Need To Get Started Before conn ecting the MicroRouter 120 0i, please check the list below to make sure that yo u have received all of the items that are su pplied with the MicroRouter 1200i package.
Chapter 2 - Getting Started 7 10Base-T Twisted-Pair Ethernet T o connect the router's Ethernet interface to twis ted-pair Ethernet cabling you will need an unshielded twisted-pair station cable that is connected to a 10BaseT -comp atible twisted-pair hub.
8 Chapter 2 - Getting Started RS-232 Interface The MicroRout er 1200i includes on e DB-25 to DB-25 RS-232 sync/as ync cable. This cabl e supports R S-232 asynchr onous modems , synchronous leased an d switched 56K C SU/DSUs, and IS DN T erminal Adapters.
Chapter 3 - Network Installatio n 9 Chapter 3 - Network Installation MicroRou ter 1200i Back P anel This section of the manual describes how to connect the MicroRouter 1200i to your Et hernet network and your wide ar ea communication s device(s). In summ ary , the steps for installation are: 1.
10 Chapter 3 - Network Installatio n Connecting the Router to the Ethernet If your twisted-pair hub is already in place, you can connect the router to an active network without interrupting network activity .
Chapter 3 - Network Installatio n 11 Connecting Device s to the RS-232C Interface This in terface -- W AN 1 -- can be used to conn ect to synch ronous or asynchro nous line communi cations devi ces at rates up to 256Kbps (sync), o r 230.4 Kbp s (async).
12 Chapter 3 - Network Installatio n Powering Up the Router Power up any modem, CSU/DSU, or T A before powering up the router . This allows the router to immediately sense whether its secondary inter- face is connected. The exception to t his rule is when conn ecting an RS232 interface to a CSU/DSU.
Chapter 4 - Comp atiView Software Inst allation 13 Chapter 4 - CompatiView Software Installation All of the routers in Compa tible System s’ internetworki ng and VPN families , including all RISC Rout er and MicroRouter model s, can be managed fro m a single GUI m anagement plat form called Com patiV iew .
14 Chapter 4 - Comp atiView Software Inst allation Run the auto-ins tallation pro gram (CV5x file) by double-cl icking on it. The installation program will ask you to select (or create) a directory in which it shou ld locate CompatiV iew and its a ssociated files an d data- base su bdir ecto ry .
Chapter 5 - Comm and Line Management 15 Chapter 5 - Command Line Management The command lin e interface allows you to configu re and monitor the router in-ban d via telnet or out-of-band with a terminal connected to the MicroRouter 1200i’ s Console interface.
16 Chapter 5 - Comm and Line Management interface. Y ou can then do the following: 1. Se t the host’s IP addre ss to 1 98.41 .12.2 , wit h a Cla ss C s ubnet mask (255.25 5.255.0) and then T elnet to 198.41.12. 1. 2. Enter the default p assword letmein at the p asswor d pro mpt.
Chapter 5 - Comm and Line Management 17 two methods ar e given in Ch apter 4 - C ompatiV iew Software Installation . • W ith CompatiV iew , basic IP parameters can be set using the TCP/IP Ro uting: Ethernet 0 D ialog Box. U se the Save to/Device option under the File men u to save the changes.
..
Chapter 6 - Basic Config uration Guide 19 Chapter 6 - Basic Configuration Guide This chapter briefly explains th e major parameters that must be set in order to use the router .
20 Chapter 6 - Basic Config uration Guide Ethernet Interfac e Configuration Ethernet interfaces are considerably easier to set up than wide area interfaces since t here are fewer choices that need to b e made regarding communi cations protocols and parameters.
Chapter 6 - Basic Config uration Guide 21 IPX Protocol Required for IP X There are general ly no required changes from the shipp ing Ethernet configuration for IPX. The Ethernet interface will autoconfigur e to use the two most common IPX frame types, and will autoadapt to condi- tions on the Ethernet .
22 Chapter 6 - Basic Config uration Guide PPP Configur ation This section covers the settings required for PPP (point-to-point) protocol operation of the W AN interfaces. Link Config uration Required for Dedicate d/Leased Line Operation Dedicated line operation is the simplest to set up.
Chapter 6 - Basic Config uration Guide 23 method and to select a chat s cript (once you have created one). Use the W AN Chat Scripts Di alog Box (under Gl obal/W AN Chat Scripts) to create your chat script. TB: Use config ure and t hen set the Dia lin g , DialOutScript ,a n d Dr opInact keywo rds in the Link Config W AN 1 section.
24 Chapter 6 - Basic Config uration Guide IPX Protocol Required for IP X W AN interfaces which are set for PPP operation do not generally use an IPX address. They are set to act as an “unnumbered interface.” In this mode of operatio n, there are no r equired settings.
Chapter 6 - Basic Config uration Guide 25 Frame Relay Conf iguration This section cov ers the settings required for Fram e Relay operation o f the MicroRouter 1200i W AN int erfaces. In general, the parameters listed here should be set for each W AN interface on which you plan to use Fr ame Re lay .
26 Chapter 6 - Basic Config uration Guide IP Protocol Required for IP There are two ways t o set up Frame R elay . One is to set the W AN inter- face as a “numbered interface.” This means that the interface (and thus the Frame Relay network) will have an IP addr ess, subnet mask, etc.
Chapter 6 - Basic Config uration Guide 27 IPX Protocol Required for IP X Frame Relay operation requires that the W AN interface is set to be a “numbered inter face.” This means that the interface (and thus the Frame Relay network) must have an IPX network number .
28 Chapter 6 - Basic Config uration Guide Link Config uration SMDS is p resently s upported in the MicroRo uter 1250i1 270i2250R 2270R only via dedicated li ne operation . • Set Dedicated connection • Set SMDS connection CV : Use the Lin k Configurat ion: W AN Dialog Bo x.
. Appendix A - Shippin g Defaults 29 . Appendix A - Shipping Defaults Ethernet Interface IP Routing Defaults •O f f IP Bridging Defaults •O n • Address: 1 98.41.12.1 • Subnet Mas k: 255.255.2 55.0 • Broadcast Ad dress: 198. 41.12.255 •I P R I P o f f IPX Routing D efaults • 802.
30 . Appendix A - Shippin g Defaults WAN Interfaces IP Defaults •O n • Unnumbered in terface •R I P o f f • V an Jacobson compres sion off IPX Defaults •O n • Unnumbered in terface V.
Appendix B - Connecto r and Cable Pin Outs 31 Appendix B - Connector and Cable Pin Outs Pin Outs for V.35 Fema le Connec tor (DTE) V .35 ( DTE) Signal A Chassis G round ↔ B Signal Gr ound ↔ C Requ.
32 Appendix B - Connecto r and Cable Pin Outs Pin Outs for DB-25 Male to DB-25 Female RS-232 Data & Console Cable The cable supplied with the MicroRo uter 1200i is twenty-five condu c- tors, straight th rough. Connections o n both the auxiliary interface and the data interface follo w the standard RS-232 pin outs.
Appendix C - LED Patterns and Test Switch Settin gs 33 Appendix C - LED Patterns and Test Switch Settings MicroRouter 1200i L ED Pattern s The MicroRo uter 1200i us es a number of ligh t patterns on its fron t LED bars t o indi ca te ope rati ng co nditi ons.
34 Appendix C - LED Patterns and Test Switch Settin gs MicroRouter 1200i Switch Settin gs Caut ion : Set tings mar ked with an as terisk may era se your Flash ROM. Please do not use these setti ngs without first contacting Compatib le Systems T echnical Support.
Appendix D - Downloading Software F rom Compatible Systems 35 Appendix D - Downloading Software From Compatible Systems W e make the latest ver sions of operat ing software f or all Comp atible Systems produ cts available at our W eb site. The latest version o f CompatiV iew management software is also available.
..
Appendix E - Terms and Conditions 37 Appendix E - Terms and Condition s Compatibl e Systems Corporation ( Compatible S ystems) offers to sell o nly on the c ondition that Cus tomer ’ s acceptance is expressly limited t o Compat- ible Systems’ terms and conditions of sale.
38 Appendix E - Terms and Conditions T o obtain service under th is W arranty , the Customer (or s ubsequent pur- chaser , if applicable) must follow the procedures outlined below , under “Product Return Po licy .” THE W ARRANTIES SET FOR TH IN THESE TERMS AND CONDI- TIONS ARE IN LIEU OF ALL OTHER W ARRANTIES, EXPRESSE D OR IMPLIED.
Appendix E - Terms and Conditions 39 ber of each item b eing returned; (c) original Compatible Systems Sales Agreement numb er; and (d) any special instr uctions. Upon receipt of this information, Com patible Systems will issue a n RMA (“Return Material Authorization”) n umber and any requi red U.
Een belangrijk punt na aankoop van elk apparaat Compatible Systems 1200i (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Compatible Systems 1200i heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Compatible Systems 1200i vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Compatible Systems 1200i leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Compatible Systems 1200i krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Compatible Systems 1200i bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Compatible Systems 1200i kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Compatible Systems 1200i . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
