Gebruiksaanwijzing /service van het product DYF48BNDI van de fabrikant Dacor
Ga naar pagina of 22
Part No. 107310 Rev . A/W10565752 Discover y ™ Built-In Refrigerator 42 and 48 Inch Models: DYF42BNDI and DYF48BNDI Installation Instructions.
© 2013 Dacor , all rights reserved. All specifications subject to change without notice. Dacor assumes no liability for changes to specifications. T able of Contents Customer Ser vice Infor mation If you have questions or problems with installation, contact your Dacor ® dealer or the Dacor Customer Service T eam.
1 Refrigerator Safety You can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don't follow All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
2 Location Requirements Y our Dacor refrigerator can be recessed in an opening between cabinets or installed at the end of a cabinet run using a side panel to enclose the refrigerator .
3 Electrical Requirements Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection. Recommended Grounding Method A 1 15 V olt, 60 Hz., AC only 15 or 20 Amp. fused, grounded electrical supply is required.
4 Installation Requirements If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa): Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary . Allow the storage tank on the reverse osmosis system to refill after heavy usage.
5 Product Dimensions Side View: The depth from the front of the top grille to the back of the refrigerator cabinet is 25 ³⁄ 8 ” (64.5 cm). The power cord is 84” (213.3 cm) long. Height dimensions are shown with leveling legs extended ¹⁄ 8 ” (3.
6 130 ˚ 130 ˚ 90 ˚ 90 ˚ 110 ˚ 110 ˚ 51 3 ⁄ 8 " (130.5 cm) 44 " (111.8 cm) 19 1 ⁄ 4 " (48.9 cm) 14 3 ⁄ 8 " (36.5 cm) 39" (99.1 cm) 43 7 ⁄ 8 " (111.4 cm) Door Swing Dimensions The location must permit both doors to open to a minimum of 90°.
7 Installation Requirements Spacer P anel ¼" (6.35 mm) ¾" (1.9 cm) 1" (2.5 cm) ½" (1.3 cm) 1" 1 ¼" 1 ½" 1 " (2.5 cm ) 1 ¼ ( 3. 2 cm ) " 1½ (3. 8 c m ) " Refrigerator Side T rim Door Hinge Backer P anel Overlay P anel ( 2.
8 Installation Requirements Refrigerator Side T rim Door Backer P anel Overlay P anel Hinge Spacer P anel Cabinetry 90˚ Door Stop P osition ¼" (6.35 mm) ¾" (1.9 cm) ¾" (1.9 cm) 1" (2.5 cm) ½" (1.3 cm) ½" (1.3 cm) 1" ( 2.
9 Installation Requirements The custom overlay panels allow you to blend the exterior of your refrigerator into the overall kitchen décor , and to use custom handles for additional design flexibility . The custom panels must have backer panels attached in order to mount them to the refrigerator .
10 Handles • Before installing a custom panel assembly , you must install the custom handle hardware. The handle and handle mounting hardware are not provided with the refrigerator . • Dacor recommends handles with larger D-style pulls. Any handle designed for use with an appliance should produce satisfactory results.
11 Unpack Refrigerator IMPORT ANT : If you receive a damaged product, immediately contact your dealer or builder . Do not install or use a damaged appliance. Do not remove the film on the outside until the refrigerator is in its operating position.
12 Install Anti-T ip Boards IMPORT ANT : T o avoid tipping during use, the solid soffit must be within 1” (2.5 cm) maximum above the refrigerator . If the solid soffit is higher than 1” (2.5 cm) or one is not available, then the refrigerator must be braced.
13 Installation Instructions Connect W ater Supply (cont.) Connecting to Refrigerator Parts Supplied: ¼” to ¼” (6.4 mm to 6.4 mm) male to male coupling. NOTE: The flexible codes approved water supply line can connect to the supply valve through the floor or through the side cabinets, as indicated by the gray boxes above.
14 W ARNING Tip Over Hazard Refrigerator is top heavy and tips easily when not completely installed. Keep doors taped closed until refrigerator is completely installed. Use two or more people to move and install refrigerator. Failure to do so can result in death or serious injury.
15 Installation Instructions IMPORT ANT : Install the custom handles prior to installing the panels on the refrigerator . Create custom door overlay panels according to the specifications in the Custom Panels and Handles section.
16 5. After adjusting, check the doors to make sure they are even at the top and bottom. If the doors are not even, continue to turn the bushing to adjust the door height. 6. Replace the locking plate. 7. T urn the bushing slightly to align the hinge and locking plate screw holes.
17 5. Using the two screws, attach the base grille assembly to the refrigerator as shown. NOTE: Drive in the right side screw first. 4. T rim the skirt by scoring the proper “V” groove with a utility knife. Break the skirt at the score line. 3. Snap the skirt onto the base grille.
18 Complete Installation 1. T urn the water supply line valve to the “Open” position. 2. T urn the refrigerator switch to the ON position. See Power On/ Off Switch in the use and care manual for instructions. W ait a few minutes. Check the water line connections for leaks.
.
Dacor ● 14425 Clark Avenue, City of Industry , CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www .dacor .com.
Een belangrijk punt na aankoop van elk apparaat Dacor DYF48BNDI (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Dacor DYF48BNDI heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Dacor DYF48BNDI vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Dacor DYF48BNDI leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Dacor DYF48BNDI krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Dacor DYF48BNDI bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Dacor DYF48BNDI kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Dacor DYF48BNDI . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
