Gebruiksaanwijzing /service van het product GD50S1 van de fabrikant Fisher & Paykel
Ga naar pagina of 16
F ood waste disposer Installation instructions and user guide NZ GD50S1 ELBA_Wastedisposal_UG.indd 1 10/22/08 6:22:36 PM.
ELBA_Wastedisposal_UG.indd 2 10/22/08 6:22:36 PM.
1 Safety and warnings 2 Installation instruc tions 3 Operating instruc tions 8 Cleaning and maintenance 9 T r oubleshooting 10 Manufacturer ’ s warranty 11 Customer care 12 Con tents Impor tant! SA VE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time.
2 Use this appliance only for its intended purpose as describe d in this User Guide. Impor tant sa fety precautions ! When using this appliance, always use basic safet y precautions, including the following: Danger! This appliance is not intended for the use by children or infirmed persons without super vision.
3 Before you begin Please read these installation instructions completely and carefully . The following installation instructions are intended as a general guide. Please ensure that the waste disposal unit is installed according to local building codes for your area.
4 1 2 3 4 5 6 7 8 10 9 11 14 13 12 16 17 15 1 2 3 4 5 6 7 8 10 9 11 14 13 12 16 17 15 Installation instruc tions Fig 1. Three Bolt Mount System Fig 1.2. Elbow Unpacking your waste disposer 1 Remove the waste disposer from the packaging. 2 Identify and check that all components are included in the car ton before beginning the installation (fig.
5 Installation instruc tions Installation 1 Loosen the clamp screw to allow the mounting system to be removed (fig.2). 2 T urn the mounting assembly over and remove the flange r ing from the track on the sink flange. Undo the three screws holding it together .
6 Installation instruc tions 7 Connect the discharge elbow to the lower outlet on the waste disposer (fig. 7). 8 Prior to connec ting the waste disposer to the mounting assembly , press firmly down on the rubber splash guard to check that is firmly fitted onto the neck of the hopper .
7 Contr olling the waste disposer All elec trical connections MUST be done by a registered electrician. The waste disposer must be connec ted to the power supply by an ear thed 3-pin outlet socket, mounted adjacent to the waste disposer under the sink .
8 Operating instruc tions Operating instruc tions 1 Remove the sink stopper and turn on a medium flow of cold water . Note: Do not use hot water . Only cold water should be run through the waste disposer. 2 Press the wall mounted control switch, or an air switch if fitted, to activate the waste disposer .
9 Y our waste disposer is self-cleaning and scours itself with each use. Under normal usage, your waste disposer will not require any special care. Note: Always run cold water into the chamber before, during and after using the waste disposer . Do not use hot water .
10 T r oubleshooting tips Problem Possible causes What to do W aste disposer is not star ting No elec tricity at the power outlet Check that the plug is correctly connected and power is turned on Chec.
11 Manufac turer’ s warranty Fisher & Paykel under takes to Repair or , at its option, replace without cost to the owner either for material or labour any par t of the Product, the serial number of which appears on the Product, which is found to be defective within TWO YEARS from the date of purchase.
12 Check the things you can do yourself . Refer to your User Guide and check: 1 your appliance is correctly installed 2 you are familiar with its normal operation If after checking these points you still need assistance, please refer to your nearest Authorised Ser vice Centre , or contact us through our local website listed on the back cover .
13 ELBA_Wastedisposal_UG.indd 13 10/22/08 6:22:48 PM.
Copyright © Fisher & Paykel 2008. All rights reser ved. The product specifications in this book let apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement , these specifications may change at any time.
Een belangrijk punt na aankoop van elk apparaat Fisher & Paykel GD50S1 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Fisher & Paykel GD50S1 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Fisher & Paykel GD50S1 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Fisher & Paykel GD50S1 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Fisher & Paykel GD50S1 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Fisher & Paykel GD50S1 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Fisher & Paykel GD50S1 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Fisher & Paykel GD50S1 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
