Gebruiksaanwijzing /service van het product Built-In All-Refrigerator/Freezer van de fabrikant GE Monogram
Ga naar pagina of 24
Installation Instructions 31-46148 224D2601P001 06-08 JR 36" Built-In All-Refrigerator s and All-Freezers monogram.com.
Safety Information Skill Level - Installation of this product r equires basic mechanical, carpentr y and plumbing skills. Proper installation is the r esponsibility of the installer . Product failure due to improper installation is not covered under the GE Appliance Warranty.
Design Guide 3 36" Frame to Frame Width *84" From Floor to Top Frame 35" Case Width *83-1/2" at Rear 25-3/8" Framed Models 25-3/4" Stainless Steel Models Case Depth Depth.
Design Guide 4 These units are equipped with a 2-position door stop. The factor y set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted. Order WX14X99 door stop for precise settings between 90° and 130°.
Design Guide 5 T op View 130° DOOR SWING (factory setting) Scale 1:1 Frameless Cabinets: The case trim overlaps cabinets at the top and sides. Therefor e, frameless cabinets may require filler strips to prevent inter fer ence with cabinet door swing.
Design Guide 6 1/4" 1/2" 3/4" 1" 1-1/4" 1/4" 1/2" 3/4" 1" 1-1/4" 1-1/2" 23-7/8" From Rear of Unit Cabinet Front 3/4" Overlay Panel (Nom.
Design Guide 7 CUST OMIZA TION BASICS: Framed Or Overlay Panels, Custom Handles and Accessory Kits Overlay panels Y ou may also choose to install custom overlay panels from your cabinet manufacturer . This design provides a seamless appearance which integrates smoothly with surrounding cabinetry.
Design Guide 8 1/4" FRAMED P ANEL DIMENSIONS If you choose to install framed panels, they must be cut to the dimensions shown. The panels will slide into the frame on the door and grille.
*84" 2-9/16" 24" *3" to 4" 3/16" 1-7/8" Design Guide 9 SIDE P ANELS Side panels must be used whenever the sides of the unit will be exposed. The 1/4" side panels will slip into the side case trim. Secure the panels to the unit with stick-on hook and loop fastener strips.
Installation Instructions 10 DO NOT , UNDER ANY CIRCUMST ANCES, CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE P OWER CORD . DO NOT USE AN AD APTER PLUG T O CONNECT THE UNIT TO A 2-PRONG OUTLET .
Installation Instructions 11 STEP 3 INST ALL SIDE P ANELS Skip this step when not using side panels If you are using 1/4" side panels, they should be inser ted into the case trim. STEP 1 REMOVE P ACKAGING CA UTION: Product is much heavier at the top than at the bottom – be careful when moving.
Installation Instructions 12 T wo Additional Hole Locations at Ends of Brackets Center Wall Bracket Line On Wall Wall Studs STEP 4 INST ALL ANTI-TIP BRACKET W ARNING: ANTI-TIP PRECAUTIONS The unit is top-heavy and must be secured to pr event the possibility of tipping for war d.
Install Screws and Bolts: • Have someone hold the wall bracket centered in place with each of the holes aligned with the correct opening in the bracket and level with the horizontal line. • Insert the lag screws through the bracket and into the stud.
Installation Instructions 14 STEP 4 INST ALL ANTI-TIP BRA CKE T (cont .) Remove Grilles for Access to Power Cord and Anti-tip Locking Hooks Fresh Food Unit • Open the access door . • Using a 1/4" hex driver , remove the 2 screws at the bottom of the grille.
15 Installation Instructions STEP 5 LE VEL UNIT All models have 4-point leveling. The front is supported by leveling legs; the rear is supported by adjustable wheels. Both are accessible from the fr ont of the unit . • To level the back of the unit , turn the 7/16" hex nut located above the fr ont wheels.
Installation Instructions 16 STEP 6 SECURE UNIT T O W ALL • The “L” rods can be found in the upper left and right corners of the unit in the access compartment . Look through the access compartment to make sure the rods line up with the anti-tip bracket .
STEP 7 AD JUST DOOR SWING NOTE: This refrigerator has a 2-position door stop. When space does not allow the door to swing open fully to 130°, you may change the door swing to a 90° opening. Skip this step if door opening is satisfactory for your installation situation.
18 Installation Instructions STEP 9 INST ALL FRAMED P ANELS (TRIMMED MODELS ONL Y) • There are two sets of holes in the handle side trim. Replace the handle side trim by installing the original screws in the FR ONT screw holes. • Secure the handle to the door using the REAR screw holes.
STEP 9A INST ALL OVERL A Y P ANELS • There are two sets of holes in the handle side trim. Replace the handle side trim by installing the original screws in the RE AR screw holes.
Installation Instructions 20 STEP 10 CONNECT W A TER SUPPL Y (FREEZER MODELS ONL Y) • Locate and bring the tubing to the front of the cabinet . • Turn the water on to flush debris from the line. Run about a quart of water through the tubing into a bucket , then shut off the water .
21 Notes.
22 Notes.
23 Notes.
GE Consumer & Industrial Appliances General Electric Company Louisville, KY 40225 ge.com Printed in the United States NOTE: While per forming installations described in this book, safety glasses or goggles should be worn. For Monogram ® local service in your area, call 1.
Een belangrijk punt na aankoop van elk apparaat GE Monogram Built-In All-Refrigerator/Freezer (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen GE Monogram Built-In All-Refrigerator/Freezer heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens GE Monogram Built-In All-Refrigerator/Freezer vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding GE Monogram Built-In All-Refrigerator/Freezer leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over GE Monogram Built-In All-Refrigerator/Freezer krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van GE Monogram Built-In All-Refrigerator/Freezer bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de GE Monogram Built-In All-Refrigerator/Freezer kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met GE Monogram Built-In All-Refrigerator/Freezer . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
