Gebruiksaanwijzing /service van het product EXT-DVI-1CAT5-ELR van de fabrikant Gefen
Ga naar pagina of 28
Audio Embedder 3GSDI EXT-DVI-1CAT5-ELR User Manual DVI ELR Extender over one CAT5 *Pr eferred Release A1.
ii 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this product near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer ’s instructions.
iii Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notied within two (2) years from the da.
iv T echnical S upport (818) 772-9100 (800) 545-6900 8:00 AM to 5:00 PM Monday - Friday , Pacic T ime Fa x (818) 772-9120 Email support@gefen.com We b http://www .gefen.com Mailing Addr ess Gefen, LLC c/o Customer Service 20600 Nordhoff St. Chatsworth, CA 9131 1 Pr oduct R egistr ation Register your product here: http://www .
v v Operating Notes • Shielded T wisted-Pair (STP) CA T -5e or CA T -6 cabling is recommended. However , Un-shielded T wisted-Pair (UTP) CA T -5e or CA T -6 cabling is acceptable. Shielded cable is preferred as it provides immunity to Electromagnetic Interference (EMI), cell phones, and A/C motors.
vi Features and Packing List Features • Extends DVI up to 495 feet (150 meters) over one CA T -5e cable • Supports resolutions up to 1080p Full HD and 1920 x 1200 (WUXGA) • EDID management for r.
.
viii Table of Contents 1 Get ting St arted Introduction............................................................................................................ 2 Sender Unit .........................................................................
.
.
DVI ELR Extender over one CAT5 1 Ge t ting St ar t ed Introduction............................................................................................................ 2 Sender Unit ..............................................................
page | 2 Introduction Sender Unit 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-ELRS Gefen 5V DC Link DVI In Power DVI ELR Extender over one CAT5 S Link EXT -DVI-1CAT5-E.
page | 3 Introduction ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Receiver unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product.
page | 4 Introduction Getting S tart ed Getting S tart ed Receiver Unit 5V DC Link DVI Out Power DVI ELR Extender over one CAT5 R Link EXT -DVI-1CAT5-ELRR Gefen 5V DC Link DVI Out Power DVI ELR Extend.
page | 5 Introduction Getting S tart ed ID Name Description 1 Link Connect a CA T -5 cable from this jack to the Link jack on the Sender unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Link (LED) This green LED indicates the current state of the product.
page | 6 Installation Getting S tart ed Connection Instructions 1. Use the included DVI cable to connect the DVI source to the DVI In port on the Sender unit.
.
.
page | 9 DVI ELR Extender over one CAT5 2 Basic Oper ation LED Status .......................................................................................................... 10 DIP Switch Conguration .............................................
page | 10 Adv anced Oper ation LED Status Basic Oper ation The Power and Link LED indicators on the Sender and Receiver unit provide basic information on the current status of the DVI ELR Extender over one CA T5. The information, in the table below , applies to both the Sender and Receiver unit.
page | 1 1 DIP Switch Conguration Adv anced Oper ation There is a bank of four DIP switches on the bottom of the Sender and Receiver unit. Remove the piece of colored tape to reveal the DIP switch bank. These DIP switches provide control over EDID management, HPD pass-through, power modes, and range selection.
page | 12 Adv anced Oper ation DIP Switch Conguration Each of the following sections describe the DIP switch settings that control each feature. DIP switches that are not related to a specic feature have been grayed-out. Note that DIP switch settings can be used independently or in conjunction with other features, as desired.
page | 13 DIP Switch Conguration Basic Oper ation Power Mode Description Sender unit Receiver unit Power-Save (Green) mode. The Receiver unit is powered only when a video signal is present on the DVI (or HDMI) cable. Sleep Mode consumes less than 1 W att of power .
.
DVI ELR Extender over one CAT5 3 Appendix Specications .............................................................................................
page | 16 Appendix Specications Supported Formats Resolutions (max.) • 1920 x 1200 (WUXGA) • 1080p Full HD Connectors, Indicators, and Controls DVI In (Sender) • 1 x DVI-I, 29-pin, female (di.
.
20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com support@gefen.com Stretch it. Switch it. Split it. Gefen’s got it. ® 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.
Een belangrijk punt na aankoop van elk apparaat Gefen EXT-DVI-1CAT5-ELR (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Gefen EXT-DVI-1CAT5-ELR heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Gefen EXT-DVI-1CAT5-ELR vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Gefen EXT-DVI-1CAT5-ELR leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Gefen EXT-DVI-1CAT5-ELR krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Gefen EXT-DVI-1CAT5-ELR bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Gefen EXT-DVI-1CAT5-ELR kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Gefen EXT-DVI-1CAT5-ELR . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
