Gebruiksaanwijzing /service van het product FirePro R5000 van de fabrikant AMD
Ga naar pagina of 36
AMD FirePro™ R5000 Graphics Accelerator User Guide Part Number: 52948_enu_1.0.
© 2013 Advanced Micro Devices Inc. All rights reserved. The contents of this document are provided in connection with Advanced Micro Devices, Inc. (“AMD”) products.
Important Safety Instructions Note: This product is for use only with compatible UL-listed personal computers that have installation instructions detailing user installation of this class of product. Read all instructions before beginning installation.
iv AMD FirePro™ R5000 Graphics Accelerator © 2013 Advanced Micro Devices Inc..
Contents Chapter 1 Getting Started . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.2.4 The screen image is off-center or there are odd colors. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 6.2.5 The operating system warns that the graphics card isn't properly configured.
Chapter 1 Getting Started Before you begin installing your new AMD FirePro™ R5000 graphics card (P/N: 102- C41902 -xx), please make sure you have the proper system requirements and have completed the required preinstallation tasks as outlined in this chapter.
1.2 System Requirements Table 1–1 AMD FirePro Workstation Graphics System Requirements Hardware • AMD Opteron™, AMD Phenom™, AMD Athlon™, Intel Xeon, or Intel Core™ CPU. • 2 GB of system memory. • Motherboard with available ×16 PCI Express® bus connection slot.
Figure 1–1 Typical Serial Number and 102 Part Number Arrangement 1 Serial number (S/N) 2 102 part number (P/N) Getting Started 3 © 2013 Advanced Micro Devices Inc.
4 Getting Started AMD FirePro™ R5000 Graphics Accelerator © 2013 Advanced Micro Devices Inc..
Chapter 2 Hardware and Software Installation This chapter details how to install your graphics accelerator in your system as well as where to download associated software and drivers.
2. Unplug the computer's power cord, and then disconnect all cables from the back of the computer. Caution: Wait approximately 20 seconds after unplugging the power cord before disconnecting a peripheral cable or removing a component from the motherboard to avoid possible damage to the motherboard.
8. If your card requires supplementary power and must be connected directly to the power supply, locate the appropriate power connector cable (or cables) from the power supply and connect it (or them) to the graphics card's supplementary power connector(s), which are usually located in the upper corner of the card.
2.3.2 AMD Automatic Application Detection and Configuration AMD FirePro drivers offer automatic application detection and configuration, which enables the graphics driver to automatically detect an application when it starts and configure the graphics driver settings for optimal performance.
Chapter 3 Display Configuration This chapter describes how to configure displays. It also lists available display connections for your graphics accelerator. 3.1 Baseplate Connections The following figure shows the display connections available on your AMD FirePro™ R5000 workstation graphics card.
3.3 Setting up Remote Graphics Remote graphics with the AMD FirePro™ R5000 workstation graphics card requires a PCoIP certified thin client receiver box. Note: You must already have installed your AMD FirePro™ R5000 workstation graphics card in the host machine, with an appropriate driver installed.
The two local displays are now clones of the two remote displays. Display Configuration 11 © 2013 Advanced Micro Devices Inc. AMD FirePro™ R5000 Graphics Accelerator.
12 Display Configuration AMD FirePro™ R5000 Graphics Accelerator © 2013 Advanced Micro Devices Inc..
Chapter 4 Using the Control Center Software 4.1 Control Center Overview The Control Center software application contains settings for configuring and fine- tuning your AMD product.
Table 4–1 Control Center Access Routes in Windows® Access Route Instructions Windows Desktop 1. Right-click anywhere on the desktop. 2. From the shortcut menu that appears, click the Control Center option. Windows Start Menu 1. Click Start on the Windows task bar.
Chapter 5 Remote Graphics This section provides a brief overview of remote graphics—specifically PC-over-IP® (PCoIP®), a technology developed by Teradici® for remotely connecting a thin client to a PC/workstation/blade PC containing an AMD FirePro™ R5000 workstation graphics card.
Figure 5–1 Typical Remote Graphics Setup Note: AMD FirePro™ R5000 workstation graphics is not in itself a virtualized system; the users are connected to dedicated desktop PC or blade PC systems on a 1:1 basis and retain full discrete workstation graphics (and CPU) performance.
5.2 Wake-on-LAN (WOL) Configuration There are two ways to configure WOL: 1. If your motherboard supports PCI_WAKE# signal (check with your motherboard supplier to see if this is supported): • If required, configure the system BIOS to enable “power on by PCIe devices.
Figure 5–4 Full Reset Using JU3200 5.4 Network Considerations PCoIP does not require special network equipment or graphics drivers. Some form of network connection brokering software is required, however. The amount of network bandwidth required for remote graphics is entirely dependent on the type of user and the software applications required.
Chapter 6 Reference This chapter provides notices, troubleshooting tips, and customer care, warranty, and standards-compliance information. 6.1 Product Features This chapter describes some of the special features that are associated with the AMD FirePro™ R5000 product and are available through the Control Center software application.
6.1.1.3 Multi Desktop Using the Multi Desktop component of HydraVision, you can create and manage up to nine virtual desktops, each with their own display settings and background image. One desktop can be made visible at a time, while others can run in the background.
If necessary, disable any built-in graphics capabilities on your motherboard. For more information, consult your computer’s manual or manufacturer. Note: • Some manufacturers do not allow the built-in graphics to be disabled or to become the secondary display.
6.2.5 The operating system warns that the graphics card isn't properly configured. Make sure that the display resolution and refresh rate settings you have selected are supported by the monitor you have connected.
the difficulty you are experiencing is the result of the product, whether your product contains a defect, and whether your product should be returned to AMD for warranty service. AMD Customer Care is unable to assist with refunds, returns, or exchange-specific inquiries.
no other representations or warranties as to fitness for a particular purpose, merchantability or otherwise in respect of the product. No other representations, warranties or conditions, shall be implied by statute or otherwise.
This product complies with FCC Rules Part 15. Operation is subject to the following conditions: • This device may not cause harmful interference. • This device must accept any interference received, including interference that may cause undesired operation.
6.5.3 CE Compliance Information (European Union) Class A Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
6.5.5 VCCI ITE Compliance Information (Japan) Class A Translation: This is a Class A product based on the standard of the VCCI Council. If this equipment is used in a domestic environment, radio interference may occur, in which case, the user may be required to take corrective actions.
Translation: "Class A" Equipment (Business purpose info/telecommunications equipment) As this equipment has undergone EMC registration for business purpose, the seller and/or buyer is asked to beware of this point and in case a wrongful sale or purchase has been made, it is asked that a change to household use be made.
CNS13438 Class B CNS13438 6.5.8 C-Tick (Australia and New Zealand) ACMA — Australian Communications and Media Authority • Radiocommunications Act 1992 (Australia)—per notices of section 182 • AS/ NZS CISPR 22 6.
6.5.10 Waste Electrical and Electronic Equipment (WEEE) Directive Compliance (European Union) This product was manufactured by Advanced Micro Devices, Inc. 30 Reference AMD FirePro™ R5000 Graphics Accelerator © 2013 Advanced Micro Devices Inc.
Een belangrijk punt na aankoop van elk apparaat AMD FirePro R5000 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen AMD FirePro R5000 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens AMD FirePro R5000 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding AMD FirePro R5000 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over AMD FirePro R5000 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van AMD FirePro R5000 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de AMD FirePro R5000 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met AMD FirePro R5000 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
