Gebruiksaanwijzing /service van het product 3CS2 van de fabrikant Hatco
Ga naar pagina of 20
HYDRO-HEA TER Sanitizing Sink Heaters Food Rethermalizers/Bain-Marie Heaters Installation & Operating Manual I&W #07.05.133.00 This manual contains important safety information concerning the maintenance, use, and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury .
Sanitizing Sink Heaters and Food Rethermalizers/Bain- Marie Heaters. W e recommend all installation, operating and safety instructions appearing in this manual be read prior to installation or operation of your Hatco Hydro- Heater .
CAUTIONS W ater in the unit and holding vessel is very hot. W ear protective gloves and pr oper attir e when operating to avoid injury . Do not use extension pipes on the inlet and outlet connections on heater units. Poor performance or unsafe conditions may occur .
IMPOR T ANT SAFETY INSTRUCTIONS 2 Form No. HHM-1 103 IMPOR T ANT! Read the following important safety instructions to avoid personal injury or death, and to avoid damage to the equipment or pr operty . CAUTIONS Do not overtighten unions or nuts. Overtightening may cause leaks.
Model 208 V olt 240 V olt FR2-3 NEMA 6-20P NEMA 6-20P FR2-4 NEMA 6-30P NEMA 6-30P SPECIFICA TIONS MODEL DESCRIPTIONS 3 ALL MODELS The Hydro-Heater mounts to the underside of a holding vessel, leaving the entire vessel area free. Units are shipped ready to install with all gaskets and fittings.
SPECIFICA TIONS 4 Form No. HHM-1 103 Kilowatts Wir e Sizing Fuse or Model V oltage (kW) Phase Amps A WG*† Circuit Br eaker* Shipping W eight 3CS2-3 208 3 1 14.5 12 20 24 lbs. (1 1 kg) 3CS2-4 208 4 1 19.2 12 30 24 lbs. (1 1 kg) 3CS2-6 208 6 1 28.8 10 40 27 lbs.
Kilowatts Wir e Sizing Fuse or Model V oltage (kW) Phase Amps A WG* † Circuit Br eaker* Shipping W eight FR2-3 208 3 1 14.5 12 20 24 lbs. (1 1 kg) FR2-4 208 4 1 19.2 12 30 24 lbs. (1 1 kg) FR2-6 208 6 1 28.8 10 40 27 lbs. (12 kg) FR2-3 240 3 1 12.5 12 20 24 lbs.
SPECIFICA TIONS 6 Form No. HHM-1 103 SIZING INFORMA TION Hatco recommends the following guidelines be used to ensure proper operation and sanitation. For 3CS2 Series in a Manual W arewashing Application • Minimum 2000 watts (2 kW) per square foot (.
INST ALLA TION 7 PLUMBING An adhesive backed paper template is shipped with the unit and is used to locate the sink strainer holes. Use the following procedure to install the heater unit to the holding vessel. NOTE: The FR2 heater should be positioned with no mor e than 3' (914 mm) on either side when mounted under holding vessel.
INST ALLA TION 8 Form No. HHM-1 103 CAUTION Do not overtighten unions or nuts. Overtightening may cause leaks. NOTE: A 3/4" (19 mm) hose or pipe may be connected to the heater sump drain and run to an open sight drain. The sump drain should not be permanently connected to the sanitary drain system.
NOTE–AUTO-FILL UNITS ONL Y: When the tank water level r eaches the low water pr obe the display will show the curr ent water temperatur e and a small red light will glow in the upper left-hand corner of the display indicating the heating elements ar e ener gized.
10 Form No. HHM-1 103 OPERA TION NOTE: If steps 6-9 ar e interrupted or no changes ar e made for 15 seconds the contr oller will go back to its original setting without accepting the change. NOTE: If unit displays “E1” or “E2” the internal water sensing pr obe is out of temperatur e range.
OPERA TION 11 Form No. HHM-1 103 W ater T emp. At Start-Up T emperature °F (°C) W ater Heated T o: W ater T emp. At Start-Up T emperature °F (°C) W ater Heated T o: MINUTES TO HEA T T ABLE * * Results may vary depending upon wattage/square foot. As wattage per foot increase, the speed of heating will increase.
12 Form No. HHM-1 103 MAINTENANCE GENERAL W ARNING T o avoid any electrical shock hazard, or physical burns turn the power OFF at the fuse disconnect switch/circuit br eaker or unplug the unit from the power sour ce and allow to cool completely before performing any maintenance or cleaning.
13 Form No. HHM-1 103 MAINTENANCE OPTIONAL POWER FLUSH CLEANING NOTE: Power Flush Kit sold separately . 1. Turn power switch to OFF position. 2. Connect one end of a drain hose onto the sump drain outlet and place the open end in a bucket or open site drain in a manner according to local plumbing codes.
Form No. HHM-1 103 14 MAINTENANCE DELIMING INSTRUCTIONS CAUTION Inspect daily for lime and sediment buildup inside unit. Excessive amounts can affect unit performance and reduce the operating life of the unit. NOTE: Pr oduct failur e caused by liming or sediment buildup is not cover ed under warranty .
Form No. HHM-1 103 15 MAINTENANCE W ARNING If service is requir ed on this unit, contact your Authorized Hatco Service Agent, or contact the Hatco Service Department at 800-558-0607 or 414-671-6350; fax 800-690-2966 or international fax 414-671-3976. W ARNING This product has no “user” serviceable parts.
Form No. HHM-1 103 16 HA TCO LIMITED W ARRANTY 1. PRODUCT W ARRANTY Hatco warrants the products that it manufactures (the “Products”) to be free from defects in materials and workmanship, under no.
Form No. HHM-1 103 17 NOTES.
HA TCO CORPORA TION P .O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. (800) 558-0607 (414) 671-6350 Parts & Service Fax (800) 690-2966 Int’l. Fax (414) 671-3976 www .hatcocorp.com HA TCO AUTHORIZED P ARTS DISTRIBUTORS Printed in U.S.A. November 2003 ALABAMA Jones McLeod Appl.
Een belangrijk punt na aankoop van elk apparaat Hatco Hatco 3CS2 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Hatco Hatco 3CS2 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Hatco Hatco 3CS2 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Hatco Hatco 3CS2 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Hatco Hatco 3CS2 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Hatco Hatco 3CS2 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Hatco Hatco 3CS2 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Hatco Hatco 3CS2 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
