Gebruiksaanwijzing /service van het product HGFR ML-132055 van de fabrikant Hobart
Ga naar pagina of 24
701 S. RIDGE AVENUE TROY, OHIO 45374-0001 937 332-3000 www.hobartcorp.com FORM 34763 (May 2002) GAS-FLAMED R O TISSERIE O VEN MODEL HGFR M L-132055 MODEL HGFR.
– 2 – © HOBART CORPORATION, 2002 IMPOR T ANT FOR Y OUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL.
– 3 – CONTENTS GENERAL ............................................................................................................................................. 4 INSTALLATION ...................................................................
– 4 – Installation, Operation and Care of HGFR GAS-FLAMED R O TISSERIE O VEN SA VE THESE INSTRUCTIONS GENERAL The model HGFR Series Gas-Flamed Rotisserie Oven features stainless steel interior and exterior for ease of cleaning. Infrared ceramic gas burners efficiently roast the product.
– 5 – INST ALLA TION Prior to installation, verify that the electrical service and gas supply (natural) agree with the specifications on the machine data plate located on the right side of the rotisserie oven. LOCATION WARNING: THE ROTISSERIE OVEN SHOULD NOT BE ACCESSIBLE TO THE CUSTOMER; HOT GLASS AND PARTS CAN CAUSE BURNS.
– 6 – ASSEMBLY Carefully remove and inspect all loose parts packed with the rotisserie oven, including the following: Overflow Tube (1) Skim Tube (1) Ceramic Logs (4) Removable Rear Panel (1) Door Handle Knobs (2) Wire Rack (1) Unwrap foot pedal switch and place on floor.
– 7 – Fig. 6 Remove the wire rack and install the overflow and skim tubes, wide side down, in the drains at the bottom of the rotisserie (Fig. 4); placement is interchangeable. Replace the wire rack. Remove the drain handle from its shipping location on the drain valve and install it properly on the drain valve stem (Fig.
– 8 – PLUMBING CONNECTION WARNING: PLUMBING CONNECTIONS MUST COMPLY WITH APPLICABLE SANITARY, SAFETY AND PLUMBING CODES. Water Supply Connection (Fig. 7) The rotisserie oven is equipped with a water bath system in the bottom of the rotisserie oven.
– 9 – GAS CONNECTION All gas supply connections and any pipe joint compound must be resistant to the action of propane gas. Codes require that a gas shutoff valve be installed in the gas line ahead of the rotisserie oven; use the valve provided. A gas pressure regulator is supplied with the rotisserie oven.
– 10 – OPERA TION WARNING: HOT GLASS, GREASE AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING AND SERVICING THE ROTISSERIE. CONTROLS (FIG. 10) PL-41692-1 CONTROL P ANEL FOOT PEDAL SWITCH Fig. 10 Foot switch - Press/release to stop/start rotor when Motor switch is on.
– 11 – Control Panel (Fig. 11) Motor Lights T emperature Burners Show T op Front T op Rear A F 200 122 572 300 400 500 O THERMOST A T TIMER COOK END COOK DECREASE BELL INCREASE PL-56352 Fig. 11 Motor switch - Starts the rotisserie turning. Lights switch - Turns the lights on or off.
– 12 – SET UP ROTISSERIE OVEN • Cover center shaft in the rotisserie oven with aluminum foil. CAUTION: Do not spray gas burners, ignitors or lights with nonstick product. • Spray noncooking components such as the interior walls, drum surfaces and wire rack with a nonstick product (Fig.
– 13 – NOTE: If power to rotisserie oven has been interrupted, the time of day must be set, or the rotisserie oven will not operate. • To set the time of day, press and hold Cook and Cook End while using the – and + buttons. • The beeper has three volumes and can be set by pushing and releasing the – and + buttons at the same time.
– 14 – • Bring tie to front, holding the wings to the side of the chicken (Fig. 18). • Skewer chicken from the neck to the tail with the angle V-spit (Fig. 19). PL-41696 PL-41697 Fig. 18 Fig. 19 • Ensure that the legs and breasts are on the same flat side of the angle V-spit (Fig.
– 15 – LOADING • Insert pointed end of the angle V-spits into left side of rotor, facing the unit (Fig. 23). CAUTION: Do not jam angle V-spit into the square hub. • Insert square end of the angle V-spit in the square hub on the right side of the rotor (Fig.
– 16 – COOKING NOTE: When cooking partial loads or when using special glazes, cook with one burner on or turn the thermostat to a lower setting. Continuous Cooking - Using the Minute Minder (Fig.
– 17 – Automatic Mode - Set the Timer (Fig. 29) Motor Lights T emperature Burners Show T op Front T op Rear A F 200 122 572 300 400 500 O THERMOST A T TIMER COOK END COOK DECREASE BELL INCREASE PL-56352 Fig. 29 In automatic mode, top burners turn off after programmed cook time expires.
– 18 – UNLOADING WARNING: PRODUCT WILL BE HOT WHEN UNLOADING ACCESSORIES. USE CARE WHEN UNLOADING THE ROTISSERIE OVEN. • When beeper sounds, press Bell to turn beeper off. • Open door. • Step on and hold down the foot switch to stop rotor. • Use a thermometer to check product for doneness (popper can also be an indicator of doneness).
– 19 – • Add water to the drip pan until the grease has flowed into the skim tube and down through the drain connection. – For systems plumbed to water line, turn water valve knob on until grease is removed from the drip pan, then turn water valve knob off (Fig.
– 20 – • Clean the exterior of the rotisserie oven with warm, soapy water and a soft cloth or sponge. Rinse thoroughly and wipe dry with a soft, clean cloth. NOTE: The bucket may have to be emptied several times. Do not let the bucket overflow, close drain valve when bucket is half full and discard water.
– 21 – MAINTENANCE WARNING: DISCONNECT ELECTRICAL POWER SUPPLY BEFORE PERFORMING ANY MAINTENANCE. WARNING: HOT GLASS, GREASE AND PARTS CAN CAUSE BURNS. USE CARE WHEN OPERATING, CLEANING AND SERVICING THE ROTISSERIE OVEN. Light bulbs require replacement periodically.
– 22 – TR OUBLESHOO TING Problem Possible Cause Display not illuminated. Rotisserie oven not plugged in. Top burner(s) will not 1 . Time of day not set. ignite. 2 . Temperature and burner switch(es) not on. 3 . Thermostat not set to 572 ° F (max.
NO TES – 23 –.
NO TES – 24 – FORM 34763 (May 2002) PRINTED IN U.S.A..
Een belangrijk punt na aankoop van elk apparaat Hobart HGFR ML-132055 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Hobart HGFR ML-132055 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Hobart HGFR ML-132055 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Hobart HGFR ML-132055 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Hobart HGFR ML-132055 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Hobart HGFR ML-132055 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Hobart HGFR ML-132055 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Hobart HGFR ML-132055 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
