Gebruiksaanwijzing /service van het product C-101BAH-DS van de fabrikant Hoshizaki
Ga naar pagina of 40
Hoshizaki “A Superior Deg re e of Reliability” www .hoshizaki.com Models C-101BAH C-101BAH-DS C-101BAH-AD C-101BAH-ADDS Self-Contained Cubelet Hoshizaki America, Inc.
2 W ARNING Only quali ed ser vice t echnicians should install and service the appliance. T o obtain the name and phone number of y our local Hoshizaki Cer ti ed Ser vice Repr esentativ e, visit www .hoshizaki.com. No installation or service should be under tak en until the technician has thoroughl y read this Instruction Manual.
3 IMPOR T ANT This manual should be r ead car efull y bef or e the appliance is installed and oper ated. Read the w ar nings and guidelines contained in this manual car efully as the y pro vide essential information for the contin ued saf e use and maintenance of the appliance.
4 Impor tant Saf ety Inf or mation Throughout this man ual, notices appear t o bring your at tention t o situations which could result in death, serious injur y , damage to the appliance, or damage t o proper ty . W ARNING Indicates a hazar dous situation which could r esult in death or serious injury .
5 W ARNING, continued • The appliance is not intended f or use by per sons (including children) with r educed ph y sical, sensor y , or mental capabilities, or lac k of e xper ience and kno wledge, unless they ha ve been giv en super vision or instruction concer ning use of the appliance by a person r esponsible f or their safety .
6 I. Specications A. Construction T op P anel Ice Discharge Opening Scoop Holder F ront P anel Contr ol S witch Louv er Bin Contr ol Ther mostat Bulb Slope Magnet C atch Door P ower C ord B. Electrical and R efrigerant Data The nameplate pr ovides electrical and refrigerant data.
7 C. Dimensions/Connections 1 . C-1 0 1BAH Units: mm [in.].
8 2. C-1 0 1B AH-DS Units: mm [in.].
9 Units: mm [in.] 3. C-1 0 1B AH-AD.
10 4. C-1 0 1B AH-ADDS Units: mm [in.].
11 II. Installation Instructions W ARNING • The appliance must be installed in accor dance with applicable national, stat e, and local codes and regulations . • CHOKING HAZARD: Ensure all components , fast eners, and thumbscr ews are secur ely in place af ter inst allation.
12 2. Built-In Installation Site NO TICE • Do not let the weight of the count er r est on the appliance. • Do not install the appliance in a corner where the door will int erf er e with other equipment or where the appliance cannot be pulled out f or ser vice.
13 C. Door 1 . C-1 0 1BAH, C-1 0 1BAH-AD a) Door Rev er sal If you w ould lik e t o re ver se the door swing , follo w the st eps below . Otherwise, skip to section "II.D . Setup ." 1) W hile maintaining a hold on the door , remo v e the hinge stop pin fr om hinge (B).
14 4) Remo ve hinge (B) fr om the right side of the appliance and the 2 ller scr ews fr om the lef t side. At tach the 2 ller scre ws to the right side and at tach hinge (B) to the lef t side. See F ig . 4. 5) Rot at e the t op panel 1 80° from its pr e vious position.
15 1 2 3 4 6 5 2. C-1 0 1B AH-DS, C-1 0 1B AH-ADDS a) Over lay P anel F abr ication and Attac hment IMPOR T ANT The ov er la y panel must be craf ted b y a prof essional cabinet maker t o ensure quality results. (1) P arts Ensure that all parts required f or the ov er la y panel assembl y are contained in the accessories bag.
16 (2) Over lay P anel Specication Use the specication that applies to y our appliance (C-1 0 1BAH -DS or C-1 0 1BAH -ADDS ) and the directions that f ollow t o prepare y our ov erlay panel.
17 C-1 0 1BAH-ADDS O verla y Panel Specication Ov erlay P anel Height 27 9/1 6" (700 mm) Ov erlay P anel Width 1 4 1 3/1 6" (37 6 mm) Ov erlay P anel Thic kness 5/8" (1 6 mm) minimum; 3/4" (1 9 mm) maximum Ov erlay P anel and Door W eight (tot al) 20 lb .
18 3) Scre w the 6 threaded wood inser ts into the 1/4" holes drilled in the pr e vious st ep . Make sure that the inserts are threaded str aight and that the t ops of the inser ts are ush t o the ov er la y panel surf ace. Otherwise, the ov er lay panel cannot be pr oper ly f astened t o the door .
19 f) Remo ve hinge (C1) fr om the t op right par t of the door , ip it and reat tach to the bot tom lef t. R emov e hinge (C2) from the bot tom right par t of the door , ip it and reat tach to the t op left. See Fig . 1 5. P roceed t o step 7 .
20 9) T emporarily f ast en the ov er la y panel t o the door using 2 of the M4×25 pan head scre ws pro vided. NOTICE! Ensur e that the bac k surface of o ver lay panel is at bef ore at taching. See F ig . 1 8. 1 0) Mark the center point of the hinge (C1) and hinge (C2) holes that e xt end ov er the ov er la y panel.
21 Snug the scr ews , but do not tight en. Sheet Metal Brac ket Ov erlay P anel Tight en the screws . 5) F asten the o verlay panel t o the door using the four M4×25 pan head scr ews pr ovided. Snug the screws , but do not tighten. See Fig . 24. 6) F asten the sheet met al brac ket t o the bot tom of the door with the thr ee T2 scre ws pro vided.
22 7) Tight en the four M4×25 pan head scr ews installed in st ep 5. See Fig . 26. 8) Replace the door g asket in its pr oper orientation. Reinser t the bushings int o hinge (C1) and hinge (C2) (the hinges at tached to the door). See F ig. 27 . C anoe Clips F ig.
23 D . Set up 1) P osition the appliance in the selected permanent location. 2) Le v el the appliance fr om side-t o-side and front-t o-rear b y adjusting the f eet. E. Electrical Connection W ARNING • Electrical connection must meet national, stat e, and local electrical code requir ements.
24 F . W ater Suppl y and Dr ain Connections W ARNING W ater suppl y and drain connections m ust be installed in accor dance with applicable national, stat e , and local regulations . NO TICE • Nor mal operating w ater t emperature m ust be within 45°F to 90°F (7°C t o 32°C).
25 F ig. 30 Piping to appr oved dr ain. Leav e a 2-inch (5-cm) ver tical air gap between the end of the pipe and the drain. 2-inch (5-cm) air gap Floor Drain Shut-Of f V alv e Drain V alv e W ater Supply Inlet 1/2" FPT Drain Outlet 1/2" FPT V ented T ee Connection Extend the v ent at least 12" (30 cm) abov e the drain outlet.
26 G. F inal Chec klist W ARNING CHOKING HAZARD: Ensure all components , fast eners, and thumbscr ews ar e securel y in place af t er installation. Make sur e that none hav e f allen int o the st orage bin.
27 III. Operating Instr uctions A. Impor tant Notes About Usage W ARNING • Only quali ed ser vice technicians should install and service the appliance. • F ailure t o install, operat e, and maint ain the equipment in accor dance with this manual will adv ersel y af fect saf et y , perf or mance, component lif e, and warr anty cov erage.
28 NO TICE • P r otect the oor when moving the appliance t o pre v ent damage t o the oor . • If using the optional drain pump (HS-5061), t est its operation e very time the appliance is cleaned and sanitized. See "IV .E. Optional Drain P ump HS-5061" f or details .
29 B. Star t up W ARNING All par ts are f act or y -adjusted. Improper adjustments ma y adver sel y af fect saf et y , perf ormance, component lif e, and w arrant y cov erage . NO TICE • If the appliance is tur ned of f, w ait f or at least 3 minutes bef ore r estar ting the appliance to pr ev ent damage to the compr essor .
30 IV . Maintenance The appliance must be maintained in accor dance with the instr uction manual and labels pro vided with the appliance. Consult with your local Hoshizaki C er tied Service Repr esentativ e about maintenance service. T o obtain the name and phone n umber of your local Hoshizaki C er tied Service Repr esentativ e, visit www .
31 A. Maintenance Sc hedule The maintenance schedule belo w is a guideline. More frequent maint enance may be requir ed depending on wat er qualit y , the appliance's envir onment, and local sanitation regulations . Maintenance Sc hedule F requency Ar ea T ask W eekly Scoop Clean the scoop using a neutral cleaner .
32 B. Cleaning and Sanitizing Instructions The appliance must be cleaned and sanitiz ed at least t wice a year . More fr equent cleaning and sanitizing ma y be r equir ed insome conditions. W ARNING • T o pre vent injur y to individuals and damage t o the appliance, do not use ammonia type cleaners.
33 7) Make sur e at least 1 0 minutes ha ve elapsed since y ou poured the cleaning solution ov er the extruding head, then mov e the control s witch to the "ICE" position. 8) Allow the appliance t o make ice f or 20 minut es, then mov e the control s witch to the "DRAIN" position.
34 5. Sanitizing Pr ocedur e - F inal 1) Using a clean funnel and hose, pour 1 qt (1 l) of sanitizing solution o v er the e xtr uding head. Allow the appliance to sit f or 1 0 minut es bef or e operation. 2) Mov e the control s witch to the "ICE" position.
35 D . Condenser Check the condenser once a y ear , and clean if requir ed b y f ollowing the st eps below . More fr equent cleaning may be r equired depending on location.
36 E. Optional Drain P ump HS-5061 If the optional drain pump (HS-5061) is installed, t est its operation at least t wice a year as outlined below . Not e that the pump has pow er e ven when the contr ol s witch is in the "OFF" position.
37 V . P r eparing the Appliance f or P eriods of Non-Use During e xt ended periods of non-use, e xtended absences, or in sub-fr eezing temper atur es, f ollow the instructions below . When the appliance is not used f or t wo or three da ys under normal conditions, it is suf ficient t o mo v e the control s witch to the "OFF" position.
38 1 4) Plug the appliance back in, then mo v e the control s witch to the "DRAIN" position. 1 5) Blow out the r eser voir outlet hose using the compr essed air or carbon dioxide suppl y . 1 6) Mov e the contr ol s witch t o the "OFF" position, then unplug the appliance fr om the electrical outlet.
39 VI. Disposal The appliance contains r efrigerant and must be disposed of in accor dance with applicable national, st at e, and local codes and r egulations.
40 HOSHIZAKI AMERICA, INC. 618 Hwy . 74 S., Peachtree Cit y, GA 30269 USA TEL (770) 487-2331 F AX (770) 487-3360 www .hoshizaki.com 1A3094-010.
Een belangrijk punt na aankoop van elk apparaat Hoshizaki C-101BAH-DS (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Hoshizaki C-101BAH-DS heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Hoshizaki C-101BAH-DS vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Hoshizaki C-101BAH-DS leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Hoshizaki C-101BAH-DS krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Hoshizaki C-101BAH-DS bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Hoshizaki C-101BAH-DS kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Hoshizaki C-101BAH-DS . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
