Gebruiksaanwijzing /service van het product JiMS-125 van de fabrikant Jensen
Ga naar pagina of 18
® DOCKING DIGIT AL MUSIC SYSTEM FOR iPod OWNER'S MANUAL JiMS-125 ® (iPod Not Included) PLEASE READ THIS OPERA TING MANUAL COMPLETEL Y BEFORE OPERA TING THIS UNIT A ND RET AIN THIS BOOKLET FOR F.
® DEAR JENSEN CUSTOMER IMPORTANT SAFETY INSTRUCTIONS COMPLIANCE WITH FCC REGULATIONS PRODUCT FEA TURES INSTALLA TION LOCATION OF CONTROLS CLOCK SETTING ALARM OPERA TIONS RADIO OPERA TIONS iPod DOCKIN.
2 Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers.
3 IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However , improper use can result in potential electrical shock or fire hazards.
4 10.Overloading Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire of electric shock. 11.Damage Requiring Service This unit should be serviced by qualified service personnel when: A.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
6 PRODUCT FEA TURES JiMS-125 is an iPod Docking Music System which incorporates the • iPod , iPod mini, iPod classic, iPod touch and iPod nano Player / Re-charger • AM / FM Stereo receiver with di.
7 INSTALLA TION Clock setting battery back-up The battery back-up compartment is located on the back of the unit. (1) Remove the battery compartment door . (2) Follow the polarity diagram shown inside the compartment and install 2 x AAA batteries (not included) .
8 Main Unit Front view T op view 1 2 3 5 4 6 8 9 12 7 11 10 14 14 13 1. iPod docking station 2. iPod docking connector 3. Function switch : Power Off ; select RADIO / iPOD / AUX modes. 4. Band switch : 5. VOLUME knob : 6. TUNING knob : 7. SNOOZE button : Activate the snooze function.
18. DC-in jack : For the connection of external DC power supply 19. FM Antenna wire 20. Battery Compartment 21. RESET button : Reset the unit. 9 LOCATION OF CONTROLS Remote Control (for iPod only) 1. Infra-red T ransmitter 2. iPod PLAY / P AUSE button 3.
ALARM OPERATIONS Setting Alarm Time 1. With the unit powered of f, press & hold the ALARM SET button to display Alarm time, the alarm indicator flashes on LCD; then press the (HOUR) / (MINUTE) buttons to set the alarm time. 2. After the alarm time is set, release the ALARM SET button.
Wake to Radio Snooze Funtion - Y ou can activate the Snooze function manually after the alarm sounds by pressing the SNOOZE button once. Alarm will sound again in 5 minutes and snooze can be manually activated again within 1 hour - After the alarm sounds you can also press the ALARM ON / OFF button to stop it immediately .
12 RADIO OPERA TIONS Radio Operation extend the FM Antenna wire for the best reception. 1. Slide the FUNCTION switch to RADIO mode. 2. Slide the BAND switch to select FM Stereo / FM or AM band. 3. Rotate the TUNING knob and tune to a desired station. 4.
13 iPod DOCKING If the docking port will not be used for an extended period of time, it is recommended to cover the docking port by using the “Dock Cover” insert (included). 1. Use the iPod adaptor included in your iPod and insert it into the docking area.
The unit provides the auxiliary audio signal input for the connection of an external audio device. You may connect an audio cable with 3.5 mm stereo plug (not included) to the AUX IN Jack located at rear of the unit.
CARE AND MAINTENANCE • Do not subject the unit to excessive force, shock, dust or extreme temperature. • Do not tamper with the unit's internal components. • Clean your unit with a damp (never wet) cloth. Solvents or detergents should never be used.
Symptom Possible Problem Solution The unit does not respond (no power) AC A daptor is not plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. Plug the A C adaptor into a wall outlet and plug the connector into the supply jack on the unit.
Printed in China SPECIFICATIONS Power Requirement Main unit DC input: DC10V , 1000mA Battery back up for clock: 2 X DC1.5V 'AAA' (UM-4) Batteries Remote Control 1 X CR2032 Lithium Battery Fr.
Een belangrijk punt na aankoop van elk apparaat Jensen JiMS-125 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Jensen JiMS-125 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Jensen JiMS-125 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Jensen JiMS-125 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Jensen JiMS-125 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Jensen JiMS-125 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Jensen JiMS-125 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Jensen JiMS-125 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
