Gebruiksaanwijzing /service van het product GVT0052-008A van de fabrikant JVC
Ga naar pagina of 36
For Customer Use: Enter below the Model No. and Serial No. which are located either on the rear , bottom or side of the cabinet. Retain this information for future reference.
IMPORT ANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appro- priate safety approved extension lead or consult your dealer .
– G-2 – SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured.
– 1 – Introduction About This Manual This manual is org anized as follows: • The manual mainly explains operations using the b uttons and controls on the unit. Y ou can also use the b uttons on the remote control if they ha ve the same or similar names (or marks) as those on the unit.
– 2 – Contents Location of the Buttons and Controls ....................... 3 Front Panel ................................................................. 3 Remote Control .......................................................... 5 Getting Started .
– 3 – Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Front Panel Front Panel PLA Y & EXCHANGE ST ANDBY/ON CD-R / RW PL A YBA CK ST ANDBY 1 2 5 6 7 8 9 p q w e r t y u i 3 4 z / l h k f s o ; a d g j EN01-14.
– 4 – See pages in the parentheses for details. Front Panel 1 Disc trays 2 ST ANDBY/ON b utton and ST ANDBY lamp (9, 24, 25) 3 Remote sensor 4 ECO b utton (9) 5 PRESET + / – control (12) 4 / ¢ .
– 5 – When using the remote control, point it at the remote sensor on the front panel. Remote Control Remote Control 1 Disc number buttons (CD1, CD2, and CD3) (16, 17) Pr essing one of these buttons also turns on the unit.
– 6 – Getting Started Supplied Accessories Make sure that you ha ve all the follo wing items. The number in the parentheses indicates the quantity of the pieces supplied. • AM (MW/L W) loop antenna (1) • FM antenna (1) • Remote control (1) • Batteries (2) If anything is missing, consult your dealer immediately .
– 7 – 1 Connect the AM (MW/L W) loop antenna to the AM LOOP terminals as illustrated. • If the AM (MW/L W) loop antenna wire is cover ed with vinyl, remov e the vinyl by twisting it as shown in the dia gram. 2 T urn the AM (MW/L W) loop antenna until you ha ve the best reception.
– 8 – Connecting Other Equipment Y ou can connect both analog and digital equipment. • DO NOT connect any equipment while the power is on. • DO NOT plug in any equipment until all connections are complete.
– 9 – Common Operations T urning On or Off the Power T o turn on the unit, press ST ANDBY/ON so that the ST ANDBY lamp goes off. T o turn off the unit (on standby), press ST ANDBY/ON again so that the ST ANDBY lamp lights up. • The clock appears on the display (if Ecology Mode is not activated).
– 10 – Continued D.CLUB (Dance CLUB) OFF (Canceled) HALL STADIUM ROCK POP CLASSIC MANUAL 1 MANUAL 2 MANUAL 3 * The SOUND MODE indicator also lights up on the display . Reinforcing the Bass Sound Y ou can select one of the 4 subwoofer lev els. This function only affects the pla yback sound, but does not af fect your recording.
– 11 – Surround modes ** : D.CLUB : Increases resonance and bass. HALL : Adds depth and brilliance to the sound. ST ADIUM : Adds clarity and spreads the sound, like in an outdoor stadium. SEA (Sound Effect Amplifier) modes: R OCK : Boosts lo w and high frequency .
– 12 – Listening to FM and AM (MW/L W) Broadcasts T uning in a Station 1 Pr ess FM/AM. The unit automatically turns on and tunes in the pre viously tuned station (either FM or AM — MW/L W). • Each time you press the button, the band alternates between FM and AM (MW/L W).
– 13 – Receiving FM Stations with RDS RDS (Radio Data System) allo ws FM stations to send an additional signal along with their regular pr ogram signals. For e xample, the stations send their station names, as well as information about what type of program the y broadcast, such as sports or music, etc.
– 14 – Switching to a Program T ype of Y our Choice T emporarily By recei ving EON (Enhanced Other Networks) data sent by FM RDS stations, the EON function allo ws the unit to switch temporarily to a broadcast program of your choice (T A, NEWS, or INFO) from a dif ferent station.
– 15 – Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the follo wing CDs: • CD (Audio CD) • CD-R (CD-Recordable) • CD-R W (CD-ReWritable) Continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the System.
– 16 – Playing Back the Entire Discs — Continuous Play 1 Load CDs. 2 Pr ess one of the disc number b uttons (CD1, CD2, and CD3) f or the disc you want to play . CD play starts from the f ir st track of the selected disc and the disc number lamp starts flashing.
– 17 – Programming the Playing Order of the T racks — Program Play Y ou can arrange the order in which tracks play before y ou start playing. Y ou can program up to 32 tracks. • T o use Repeat play (see page 18) for Program play , press REPEA T after starting Program play .
– 18 – Playing at Random — Random Play The tracks of all loaded CDs will play at random. • T o use Repeat play for Random play , press REPEA T after starting Random play . 1 Load CDs. • If the current playing source is not the CD player , pr ess CD 3¥8 , then 7 before going to the next step.
– 19 – Y ou can play back type I, type II, and type IV tapes without changing any settings. Playing Back a T ape 1 Pr ess EJECT ( 0 ) for the deck y ou want to use. 2 Put a cassette in with the exposed part of the tape down. 3 Close the cassette holder gently .
– 20 – Recording Recording a T ape on Deck B 1 Press EJECT 0 f or the deck B. 2 Put a recorda ble cassette into deck B. 3 Close the cassette holder gently . 4 Check the tape direction of deck B. • If the tape direction is not correct, press T APE 2 3 twice then 7 to change the tape direction.
– 21 – CD Direct Recording Everything on the CD goes onto the tape in the order it is on the CD, or according to the order you hav e made for Program play . On the unit ONL Y : 1 Put a recorda ble cassette into deck B. 2 Load CDs. 3 Press one of the disc number buttons (CD1, CD2, and CD3) to select the disc, then 7 .
– 22 – Auto Edit Recording By using Auto Edit Recording, you can record the CD tracks to f it the tape. Auto Edit Recording makes a program by selecting the CD tracks in numerical order . Howe ver , to prev ent the end of the last track on the front side from being cut off , the last track is selected so as to fit on the remaining tape length.
– 23 – Using the T imers There are three timers a vailable — Daily Timer , Recording T imer , and Sleep T imer . Before using the timers, you need to set the clock built in the unit. (See page 9.) Using Daily Timer W ith Daily T imer , you can wake to your fa vorite music or radio program.
– 24 – 5 Tu r n 4 / ¢ to select the sour ce to play , then press SET/DISPLA Y . • The source changes as follows: TUNER FM : tunes into a specified preset FM station. = Go to step 6. TUNER AM : tunes into a specified preset AM (MW/L W) station. = Go to step 6.
– 25 – 4 Set the on-time y ou want the unit to turn on at. 1) Tu r n 4 / ¢ to set the hour , then press SET/DISPLA Y . 2) Tu r n 4 / ¢ to set the minute, then press SET/DISPLA Y . “OFF TIME” appears for 2 seconds, then the unit enters of f- time setting mode.
– 26 – T imer Priority Since each timer can be set separately , you may wonder what happens if the setting for these timers ov erlaps. Here are examples. Recording Timer has priority over Daily Timer and Sleep Timer . • If Daily T imer is set to come on while Recording T imer is operating, Daily T imer will not come on at all.
– 27 – Classification of the PTY codes for some FM stations may be different from the above list. Description of the PTY codes: NEWS : News. AFF AIRS : T opical program expanding or enlarging upon the news — debate, or analysis. INFO : Program the purpose of which is to impart advice in the widest sense.
– 28 – If you are ha ving a pr oblem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been physically damaged, call a qualif ied person, such as your dealer , for service.
– 29 – Maintenance T o get the best perfor mance of the unit, keep your discs, tapes, and mechanism c lean. Handling cassette tapes • If the ta pe is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotating.
– 30 – Specifications CA-MXGT91R Amplifier section Output Po w er (IEC 268-3/DIN) SUBWOOFERS: 86 W per channel, min. RMS, both channels dri ven into 6 Ω at 63 Hz with no more than 0.9% total harmonic distortion. MAIN SPEAKERS: 21 W per channel, min.
MEMO MEMO 01.1.18, 8:40 PM 2.
MEMO MEMO 01.1.18, 8:40 PM 2.
0201MWMMDWJEM EN VICT OR COMP ANY OF JAP AN, LIMITED CA-MXGT91R&G71R[B]Coverf 2/15/01, 12:03 PM 2.
Een belangrijk punt na aankoop van elk apparaat JVC GVT0052-008A (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen JVC GVT0052-008A heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens JVC GVT0052-008A vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding JVC GVT0052-008A leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over JVC GVT0052-008A krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van JVC GVT0052-008A bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de JVC GVT0052-008A kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met JVC GVT0052-008A . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
