Gebruiksaanwijzing /service van het product LT-20A60SU van de fabrikant JVC
Ga naar pagina of 33
INSTRUCTIONS ENGLISH DEUTSCH FRANÇAIS LCD-TV -GERÄT BEDIENUNGSANLEITUNG P ANNEAU LCD TELEVISEUR MANUEL D'INSTRUCTIONS IT ALIANO TV A SCHERMO LCD ISTRUZIONI L T -20A60SU 1004TKH-VT -VT © VIC T .
ENGLISH - 1 - For your safety This equipment has been designed and manufactured to meet international safety stan- dards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. So, please read the points below for y our own sa fety .
ENGLISH - 2 - DO DO read the operating instructions before you attempt to use the equipment. DO ensure that all electrical connections (in- cluding the mains plug, extension leads and inter-connections between pieces of equip- ment) are properly made and in accordance with the manufacturers instructions.
ENGLISH - 3 - W ARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE T O RAIN OR MOISTURE. W ARNING Fingers may be trapped under the TV causing injuries. Hold the TV at the bottom in the middle, and do not allow it to tilt up or down.
ENGLISH - 4 - Import ant Information Please take note EXCLUSION CLAUSE JVC shall under no circumstances be liable for loss and/or damage to the product caused by: fire; earthquake; acciden.
ENGLISH - 5 - Remote Control Buttons / I = ( St and By) button TV / VCR / DVD Switch Number buttons A V button (TV , EXT-1, EXT -2, EXT-2 S, EXT -3, EXT -4, EXT -4 S or PC) BLUE / PICTURE Mode button .
ENGLISH - 6 - Control Panel Buttons With certain combinations of connectors and leads the back cover may not be easily fitted. If the cover is left off, this in no way infringes safety requirements.
ENGLISH - 7 - Using the stand This TV comes with a T able T op St and already att ached. This stand can be used to adjust the direction of the TV screen 5° up, 10° down, and 20° to the left or right.
ENGLISH - 8 - Remove the terminal Cover There are connection terminals behind the covers of the rear of the TV . Remove the cover before connecting an antenna, DVD or VCR. Remove the covers by removing the hooks. When replacing the covers, place the side or bottom of the covers against the TV and insert the hooks.
ENGLISH - 9 - Where to install Locate the TV away from direct sunlight and strong lights, soft, indirect lighting is recommended for comfortable viewing.
ENGLISH - 1 0 - Preparation Install Display on solid horizontal surface such as a table or desk. For ventilation, leave a space of at least 10 cm free all around the set. T o prevent any fault and unsafe situations, please do not place any objects on top of the set.
ENGLISH - 1 1 - the TV out socket located at the devices (VCR, DVB etc.) to this socket as well. How to connect other devices IMPORT A N T : Switch off the TV before connect- ing any external device. Sockets for external connections are at the back of the TV .
ENGLISH - 1 2 - Operating the TV You can operate your TV both using the re- mote control handset and onset buttons. First A.P.S. (Automatic Programming System) APS, searches and sorts all channels and stores them automatically on your TV , accord- ing to the transmission of programme sys- tems in your area.
ENGLISH - 1 3 - If FEA TURE NOT A V AILABLE is displayed, download was not performed correctly . Before trying to download again, check that: The VCR power is turned on. The VCR is T -V LINK compatible. The VCR is connected to the Ext-2.
ENGLISH - 1 4 - Programme Selection (Previous or next programme) Press button to select the previous programme. Press button to select the next programme. Programme Selection (direct access): Press digit buttons on the remote control hand- set to select programmes between 0 and 9.
ENGLISH - 1 5 - By pressing or button you may choose one of these options: Soft, S t andard and Bright. Setting Contrast Using or button select Contrast. Press button to increase contrast level. Press button to decrease contrast level.
ENGLISH - 1 6 - Press or button to select Noise Reduction level Off or Minimum or Me- dium or Maximum Note 1: At low signal level, the changings on the Noise Reduction function are not effective when there is menu on the screen.
ENGLISH - 1 7 - Use this settings to adjust volume for audio out terminal which is located at the right side of the TV . Using or button select Audio Out. Press or button or directly press OK button on Audio Out , to enter the Audio Out menu.
ENGLISH - 1 8 - Install Menu Press " MENU " button, now you are in main menu. In the main menu, select Install using or button. Then enter the In- stall menu pressing / or OK but- ton. In EXT mode, Install menu appears like this: Y ou can change only Colour system and VCR.
ENGLISH - 1 9 - T o Store Settings Press / or OK button on Store option to store Install menu settings. After stored, T-V LINK menu will appear . If you do not need to do T -V LINK, press MENU button to exit the menu. Program Menu Press " MENU " button, now you are in main menu.
ENGLISH - 2 0 - Autostore: T o enter Autostore menu, press the BLUE but- ton. T o learn the features of this function see " Autostore " below . Autostore, searches and stores all channels automatically on your TV , according to the transmission of programme systems in your area.
ENGLISH - 2 1 - In stereo transmission it yields a phase differ- ence between left and right channels. Hyper Sound selection will be displayed on the screen when the TV S t atus button is pressed or programme is changed. Picture Mode Picture mode OSD is displayed when BLUE button is pressed.
ENGLISH - 2 2 - In order to quit the EXT mode press any digit buttons or or Zoom Modes Zoom mode can be changed by pressing Red button. Y o u can change the screen size ac- cording to the picture aspect ratio. Select the optimum one from the following ZOOM modes.
ENGLISH - 2 3 - PC Mode Installation Power off both Computer and Display before making any connections. Set your PCs resolution correctly before con- necting to the TV . See the table in page 30 for supported modes. Use a D-SUB cable to connect the TV's PC input to the computer's RGB output terminal.
ENGLISH - 2 4 - PC Picture Menu In the Main menu, select PC Picture using or button, then enter the PC Picture menu pressing / or OK buttons. Contrast, Bright-1 and Colour T emperature adjustments in this menu are identical to ad- justments defined in TV picture menu.
ENGLISH - 2 5 - T eletext T eletext is an information system that displays text on your TV screen. Using the T eletext in- formation system you can view a page of in- formation on a subject that is available in the list of contents (index). On screen display is not available in text mode.
ENGLISH - 2 6 - the upper left corner of the screen when the selected page is found. Press button to display the selected T eletext page. To exit Teletext Press button. The screen will switch to TV mode. Fastext and Toptext Y our TV supports the 7 page T eletext system.
ENGLISH - 2 7 - signal, connect it to the EXT -3 terminal with a component video cable. Via the ANT (aerial) socket If your equipment does not have an Eurocon- nector or RCA jacks, connect it to the TV with an aerial cable. For details, see the manual provided with the equipment.
ENGLISH - 2 8 - Peripheral Equipment Connections LT_20A60_SU.p65 31.08.2005, 08:17 28.
ENGLISH - 2 9 - Peripheral Equipment Connections DECODER FOR SA TELLITE RECEIVER VIDEO HEADPHONE AUDIO Antenna Connections LT_20A60_SU.p65 31.08.2005, 08:17 29.
ENGLISH - 3 0 - PC Input T ypical Display Modes The display has a maximum resolution of 1360x768 , vertical sync. frequency range of 50-75 Hz and a horizontal sync. frequency range of 30-69 KHz. The following table is an illustration of some of the typical video display modes.
ENGLISH - 3 1 - Tips Care of the Screen Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the TV screen coating layer Colors of image on screen are abn.
ENGLISH - 3 2 - Specifications Broadcasting Systems P AL SECAM BG , DK, I, L,Lp Channels and VHF (VL) 46,25 MHz - 168,25 MHz Frequencies VH F (V H) 175,25 MHz - 463,25 MHz U H F 471,25 MHz - 863,25 MHz Cable TV (S1-S20/ S21-S41) Input Signal Video: Analog 0,7 Vp-p 75 ohm positive Sync: TTL Level positive or negative, Seperate sync.
Een belangrijk punt na aankoop van elk apparaat JVC LT-20A60SU (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen JVC LT-20A60SU heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens JVC LT-20A60SU vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding JVC LT-20A60SU leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over JVC LT-20A60SU krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van JVC LT-20A60SU bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de JVC LT-20A60SU kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met JVC LT-20A60SU . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
