Gebruiksaanwijzing /service van het product UX-H330 van de fabrikant JVC
Ga naar pagina of 32
LVT1193-003A [B] MICR O COMPONENT SYSTEM UX-H330 UX-H300 –Consists of CA-UXH330 and SP-UXH330 –Consists of CA-UXH300 and SP-UXH300 INSTR UCTIONS UX-H330&H300[B]cover1.
G-1 W arnings, Cautions and Other s CA UTION— (ST ANDBY/ON) button! Disconnect the mains plug to shut the power off completely (all lamps and indications go off). The (ST ANDBY/ON) button in an y position does not disconnect the mains line. • When the unit is on standby , the ST ANDBY lamp lights red.
G-2 SAFETY INSTRUCTIONS “ SOME DOS AND DON ’ TS ON THE SAFE USE OF EQUIPMENT ” This equipment has been designed and manuf actured to meet international safety standards, b ut like an y electr ical equipment, care must be tak en if you are to obtain the best results and saf ety is to be assured.
1 Power sources • When unplugging the unit from the wall outlet, always pull on the plug, not the A C power cord. DO NO T handle the AC po wer cord with wet hands. Moisture condensation Moisture may condense on the lenses inside the unit in the follo wing cases: • After starting to heat the room.
2 Contents Location of the Buttons and Controls ............................. 3 Main Unit .................................................................................. 3 Remote Control .............................................................
3 Location of the Buttons and Controls Become familiar with the b uttons and controls on your unit. Main Unit OPEN COMPACT DIGITAL AUDIO DAIL Y TIMER/SNOOZE 1 3 2 COMPACT DIGITAL AUDIO ST ANDBY CD PHO.
4 Display window Display window 1 D AIL Y 1/2/3 (timer number) indicator 2 (timer) indicator 3 ON/OFF (timer on-time/of f-time) indicators 4 REC (recording timer) indicator 5 (group folder) indicator .
5 Remote Control See pages in parentheses for details. COMPACT DIGITAL AUDIO ST ANDBY CD PHONES DOWN 4 # / 8 7¢ UP AUX T APE FM/AM AUX VOLUME + – REC When using the remote control, point it at the remote sensor on the front panel.
6 Getting Started Unpacking After unpacking, check to be sure that you ha ve all the follo wing items. The number in parentheses indicates the quantity of each piece supplied. • AM (MW) loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consult your dealer immediately .
7 Connecting Other Equipment T o connect an audio equipment Y ou can connect audio equipment — used only as a playback de vice. • DO NO T connect any equipment while the power is on. • DO NO T plug in any equipment until all connections are complete.
8 Common Operations Setting the Clock Before operating the unit any further , first set the unit ’ s clock. When you plug in the po wer cord, “ 0:00 ” starts flashing on the display . Y ou can set the clock when the unit is either turned on or in standby mode.
9 Selecting the Source T o select the source, press CD 6 , T APE 2 3 , FM/AM, or AU X . • When you select CD as the source, playback starts automatically . T o operate the CD player , see pages 10 to 13. T o operate the tape deck, see page 14. T o operate the tuner (FM or AM (MW)), see pages 15 to 18.
10 Playing Back the Entire Disc — Normal Play 1 Press ) OPEN on top of the unit. The disc cov er opens. • Y ou can insert a disc while listening to another source. 2 Place a disc correctly with its label side up. 3 Close the disc cov er gently . 4 Press CD 6 .
11 T o remo ve the disc, press ) OPEN on the unit, then take out the disc by holding it at the edges while pressing the unit ’ s pi vot lightly . • If the disc cannot be read corr ectly (because it is scratched, for example) or an unr eadable CD-R or CD-R W is inserted Playback will not start.
12 Repeating T racks — Repeat Play Y ou can have all the tracks, the program or indi vidual trac k currently playing, repeat as many times as you lik e.
13 RDS MODE REMAIN Displaying the Remaining Time during Playback Y ou can display the remaining time of the current track/disc and the elapsed time of the current track/disc during playing.
14 If no cassette is inserted when you pr ess T APE ¤ ‹ “ NO T APE ” appears on the display . T o stop playing, press 7 . T o fast-wind to the left or to the right, press ¢ or 4 (or UP ¢ or DO WN 4 on the unit). The tape direction indicator ( 3 or 2 ) starts flashing rapidly on the display .
15 T uning in to a Station 1 Press FM/AM to select either “ FM ” or “ AM (MW). ” The unit automatically turns on and tunes in to the previously recei ved station — either FM or AM (MW). • Each time you press the button, the band alternates between FM and AM (MW).
16 123 456 78 0 9 OVER FM/AM PRESET GROUP PRESET GROUP UP DOWN T uning in to a Preset Station On the r emote control ONL Y : 1 Press FM/AM to select either “ FM ” or “ AM (MW). ” The unit automatically turns on and tunes in to the previously recei ved station — either FM or AM (MW).
17 Searching for Programs by PTY Codes (PTY Search) One of the adv antages of RDS is that you can locate a particular kind of program by specifying the PTY codes. • For details on the PTY codes, see “ Descr iption of the PTY codes ” on the right column.
18 Listening to the External Equipment Y ou can listen to the external equipment such as MD recorder , cassette deck, or other auxiliary . • First, make sure that the external equipment is proper ly connected to the unit. (See page 7.) 1 Set the volume le vel to the minimum position.
19 3 Start playing the source — FM, AM (MW), or auxiliary equipment connected to A UX jack. • When the source is FM or AM (MW), tune in to the station you want to record. • When recording from discs, see “ Recording Discs — Disc Synchronized Recording ” on page 20.
20 T o stop recording f or a moment, press REC. Both the CD playback and tape recording are paused. T o resume recording, press T APE ¤ ‹ . T o stop recording, press 7 . The recording stops and the CD playback is paused. T o record on both sides — Reverse Mode On the remote contr ol ONL Y : Press REV .
21 Using the T imers There are four timers a vailable — Daily T imer, Recording T imer , Snooze T imer , and Sleep T imer . • Before using these timers, make sure the b uilt-in clock is set correctly (see page 8). Using Daily T imer and Recording Timer Y ou can set the timer whether the unit is on or off.
22 3 F or the Recording T imer ONL Y : Set the off-time y ou want the unit to turn off . (1) Press UP or DO WN to set the hour , then press SET . (2) Press UP or DO WN to set the minute, then press SET . If you want to change the time setting, press CANCEL.
23 Using Sleep T imer W ith Sleep T imer , you can fall asleep to your fav orite music or radio program. • Y ou can set Sleep T imer only when the unit is turned on. • Y ou can also turn off the unit automatically by using Auto Standby . (See page 8.
24 Maintenance T o get the best performance of the unit, keep your discs, tapes and mechanism clean. General Notes In general, you will hav e the best performance by keeping your discs, tapes and the mechanism clean. • Store discs and tapes in their cases, and keep them in cabinets or on shelves.
25 If you are having a problem with your unit, check this list for a possible solution before calling for service. If you cannot solve the problem from the hints gi ven here, or the unit has been physically damaged , call a qualified person, such as your dealer for service.
26 Amplifier Section Output Po wer: 15 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more than 10% total harmonic distortion. (IEC268-3) Audio input sensiti vity/Impedance (at 1 kHz) A UX: 500 mV/50 k Ω Speakers Impedance: 4 Ω – 16 Ω T uner FM tuning range: 87.
MEMO memo_HX-Z77D&55D[U]fff.p65 04.2.18, 9:30 AM 1.
MEMO memo_HX-Z77D&55D[U]fff.p65 04.2.18, 9:30 AM 2.
EN 0304AIMMDWORI © 2004 VICTOR COMPANY OF JAPAN, LIMITED VICT OR COMP ANY OF JAP AN, LIMITED UX-H330/UX-H300 MICRO COMPONENT SYSTEM UX-H330&H300[B]cover1.
Een belangrijk punt na aankoop van elk apparaat JVC UX-H330 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen JVC UX-H330 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens JVC UX-H330 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding JVC UX-H330 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over JVC UX-H330 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van JVC UX-H330 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de JVC UX-H330 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met JVC UX-H330 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
