Gebruiksaanwijzing /service van het product 115 van de fabrikant Konica Minolta
Ga naar pagina of 33
E INSTRUCTION MANUAL.
3 2 ADV ANCED OPERA TION Selecting Functions in the Flash Mode 36 Flash Range .................................. 38 Autoflash ...................................... 39 Autoflash with Red-eye Reduction 40 Fill flash ....................................
5 4 FOR PROPER AND SAFE USE • T ape over lithium battery contacts to avoid short-circuiting during disposal; always follow local regulations for battery disposal. • Do not disassemble this product. Electric shock may cause injury if a high voltage circuit inside the product is touched.
7 FOR PROPER AND SAFE USE 6 CAUTION • Do not use or store the product in a hot or humid environment such as the glove compartment or trunk of a car . It may damage the product and batteries which may result in burns or injuries caused by heat, fire, explosion, or leaking battery fluid.
Thank you for purchasing this Minolta camera. Y our new camera is with functions which will suit your every photographic need. Before using your new camera, please take the time to read through this instruction manual for important information on the use and care of your camera.
11 10 Continued on next page. Shutter-release button ( 27 ) Data panel ( 12 ) Viewfinder* ( 13 ) Date button ( 50 ) (Quartz-date model only) Flash-mode/ Select button ( 36/50 ) Main switch ( 25 ) Film.
13 12 Focus frame ( 27 ) Ready lamp (green) ( 27 ) With the shutter-release button pressed partway down - On: Focus locked Off: Flash charging Blinks quickly: Subject is too close Blinks slowly: Camer.
15 2. Insert the battery matching the positive terminal mark inside the battery chamber- door , then click the door closed. • Quartz-date model: The date and time must be reset (p.50). • When changing batteries, make sure the main switch is of f. 14 INSERTING THE BA TTER Y Y our camera uses one 3-volt CR123A or DL123A lithium battery .
17 16 1. Slide the back-cover release down to open the back cover . LOADING THE FILM • If the back cover does not open, turn the main switch of f and on to release the film chamber lock. • Use only 35mm, DX-coded film rated between ISO 25 and 3200.
19 18 2. Place the film cartridge into the film chamber . Extend the film leader to the "FILM TIP" mark, making sure it lays flat. • If the film tip extends beyond the index mark, push the excess film back into the cartridge. LOADING THE FILM 3.
21 Y our camera automatically rewinds the film after the last exposure is taken. • If the rewind motor stops before the film has been completely rewound, all the indicators will blink. Remove and insert the battery or press the manual-rewind button.
23 22 This camera has a silent-rewind function to minimize the noise of film rewinding. Use the silent-rewind mode when the rewinding noise would be distracting such as during a wedding ceremony . Press the manual-rewind button while the film is rewinding.
25 1. Press the main switch to turn the camera on. • Auto Power Of f: T o conserve power , the camera automatically turns off if it is not operated for more than 8 minutes. 2. Hold the camera steady , making sure your fingers do not cover the flash, lens, or AF windows.
27 26 FULL-AUTO OPERA TION 4. Place the focus frame on the subject and press the shutter-release button partway down. Ready Lamp The ready lamp will light to indicate the status of the camera. On: Focus locked Off: Flash charging Blinks quickly: Subject is too close Blinks slowly: Camera shake warning 3.
29 28 Subjects outside the focus frame may not be in focus. Use focus lock to ensure accurate focusing. 1. Place the focus frame on your subject. FOCUS LOCK 5. When the green ready lamp glows, press the shutter-release button all the way down to take the picture.
31 30 When taking a picture with the subject closer than 1.5m (4.9ft.), the viewfinder image and the actual film image will be different. The difference increases as the subject becomes closer , or especially when using the telephoto setting.
33 32 If the subject is closer than 1.5m(4.9ft.), take the following steps: 1. Place the focus frame on the subject and press the shutter-release button partway down. 2. While pressing the shutter-release button partway down, aim the camera upward to recompose the subject under the close-framing guide and take the picture.
34 ADV ANCED OPERA TION Some scenes or subjects are difficult for the autofocus system to lock on to. When the focus will not lock, focus lock (p. 29) on another object the same distance from you as the main subject, recompose, then take the picture. SPECIAL FOCUSING SITUA TIONS • Bright light sources such as the sun or neon lights.
37 36 Auto-depth (p. 44) Night portrait (p. 46) Landscape/Night View (p. 47) Flash cancel (p. 43) • The autoflash and the autoflash with red-eye reduction will remain selected after you turn the camera off.
39 38 AUTOFLASH The flash will fire automatically in low-light. Press the flash-mode button until appears on the data panel, then take the picture. • The flash will not fire in back-lit situations. Use of the fill flash is recommended. • When the green ready lamp is of f, the flash is charging.
41 40 • W arn your subject not to move while the lamp is blinking just before the picture is taken. Press the flash-mode button until appears on the data panel, then take the picture. Use the reduction mode to reduce the red-eye effect when photographing people or animals in low-light situations.
43 42 The flash will not fire in this mode. Use the flash cancel when you want to photograph subjects that are beyond the flash range or to capture the ambiance of the existing light. FLASH CANCEL • Shutter speed may be slow and the use of a tripod is recommended.
45 44 • The flash will fire automatically in low-light. • If the autoflash with red-eye reduction was chosen previously , the auto- depth mode will also use the red-eye reduction. • Sharpness of the background depends on brightness and focal length.
47 46 LANDSCAPE/NIGHT VIEW The flash will not fire in this mode and the focus is set to infinity . It can be used to photograph landscapes, night scenery and other distant subjects. • Shutter speed will be slow . Use of the tripod is recommended. Press the flash-mode button until appears on the data panel, then take the picture.
49 48 3. Press the shutter-release button all the way down; the self-timer delays release for 10 seconds. • will blink on the data panel. The self-timer lamp on the front of the camera will blink slowly during the countdown, then rapidly just before the shutter is released.
51 50 T urn the camera on, then press the date button to choose the data imprinting format. DA Y / TIME • When the date-time display is blinking or -- -- -- is displayed on the data panel, date/time information will not be imprinted. The date/time information needs to be reset (p.
53 3. Press the adjust button to change the blinking item. • Data continues changing as long as the button is held down. • The date and time must be reset each time the batteries are replaced . 5. Press the select button until all items stop blinking to set the updated information.
55 54 4. Press the adjust button to change the display format. 5. Press the select button until all items stop blinking to set the updated information. • The set date appears on the data panel and disappears after 5 seconds. The format sequences as follows: D M`Y `Y M D M D`Y 2.
56 APPENDIX Attach the strap as shown. • The button key is included on the strap. Use the key to push the manual-rewind button (p.22). A TT ACHING THE CAMERA STRAP BUTTON KEY.
59 58 • When photographing in cold weather , it is recommend that you keep the camera and spare batteries inside your coat to keep them warm when you are not shooting. Cold batteries will regain some of their charge when they warm up. • This camera is not waterproof, dustproof, or sand-proof.
61 60 BEFORE IMPORT ANT EVENTS • Check camera operation carefully or take test photographs. • Minolta is not responsible for any loss which may occur due to an equipment malfunction.
63 62 Battery: One 3-volt CR123A lithium battery Battery-condition indication: 3-stage indication Battery performance: approx. 12 rolls based on Minolta's standard test method using 24 exposure rolls with flash for 50% of the exposures. Viewfinder: Magnification: 0.
© 2001 Minolta Co., Ltd. under the Berne Convention and Universal Copyright Convention 9222-2470-21 MM-A101 Minolta Co., Ltd. 3-13, 2-Chome, Azuchi-Machi, Chuo-Ku, Osaka 541-8556, Japan Minolta Europe GmbH Minoltaring 1 1, D-30855 Langenhagen, Germany Reparatur/Repair Senator-Helmken-Strasse 1, D-28197 Bremen, Germany Minolta France S.
Een belangrijk punt na aankoop van elk apparaat Konica Minolta 115 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Konica Minolta 115 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Konica Minolta 115 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Konica Minolta 115 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Konica Minolta 115 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Konica Minolta 115 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Konica Minolta 115 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Konica Minolta 115 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
