Gebruiksaanwijzing /service van het product S 2131 van de fabrikant Miele
Ga naar pagina of 24
Operating instructions Vacuum cleaners S 2111 / S 2121 / S 2131 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time.
Caring for the environment ..........................................3 Description of the vacuum cleaner ...................................4 Warning and safety instructions .....................................6 Preparing for use ....................
Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of babies and young children.
Description of the vacuum cleaner 4.
a Handle XXL * b Handle * c Air inlet valve d Release button e Connection piece for storage * f Telescopic tube * g Connection socket h EasyLock tube * i Slide controls for the telescopic tube * j Dus.
This appliance conforms to current safety requirements. Improper use of the appliance can, however, present a risk of both personal injury and material damage. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before installation and before using it for the first time.
~ There is a metal inlay underneath the handle which is designed to avoid the unpleasant effects of electrostatic discharges. Please make sure that you keep your hand in constant contact with this metal strip during vacuuming.
~ Do not vacuum up any inflammable or combustible liquids or gases and do not vacuum in areas where such substances are stored. The cleaner might explode. ~ Do not vacuum up items which are heavy, hard or have sharp edges. They could cause a blockage and damage the appliance.
Attaching the suction hose a ^ Insert the hose connector into the suction socket until it clicks into position. To remove the suction hose b ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket.
Adjusting the telescopic tube One part of this telescopic tube is packed inside the other and can be adjusted to suit your height for comfortable vacuum cleaning. ^ Press the telescopic tube release button to release the tubes and adjust to the required height.
The following accessories are supplied: a Dusting brush b Upholstery nozzle c Crevice nozzle d VarioClip for the above accessories Symbols on the holder show where to attach the different accessories. VarioClip ^ Attach the VarioClip either on-hand at waist level or on-board at the connector.
Pull out the mains cable a ^ Pull out the mains cable to the required length (max. cable length approx. 5.5 m). , If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating.
Adjusting the suction power The suction power can be regulated to suit the type of flooring. Reducing the suction power reduces the amount of effort required to manoeuvre the floor- head. Some models also have symbols on the controls. The symbols indicate the type of use the settings are suitable for.
ParkSystem A parking system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner.
, Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug. The Miele filter system consists of three filters which must be replaced from time to time to ensure that your vacuum cleaner performs efficiently.
When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display red, or sooner if it is no longer effective. Miele dustbags are disposable, and designed for single use only. Do not attempt to re-use them as suction would be reduced.
Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust escaping. Replacing the dustbag a ^ Pull the dustbag out by the grip next to the self-closing flap on the collar.
When to change the dust compartment filter (for motor protection) Replace this filter every time you start a new packet of dustbags. An exhaust filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid.
Replacing one type of exhaust filter with another Your Miele vacuum cleaner can be fitted with optional Active Air Clean / Active HEPA filter. This filter can be used instead of the Air Clean filter, which is supplied as standard.
When to change the thread lifters The thread lifters on the suction inlet to the floorhead can be replaced. Check them from time to time and replace them if the pile has worn down. To replace the thread lifters Floor head SBD 350-3 ^ Use a suitable tool to remove them from the slots a .
The vacuum cleaner switches off automatically. A temperature limiter switch switches the vacuum cleaner off automatically if it gets too hot. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust.
In the event of a fault that you cannot easily remedy, please contact – your Miele Vacuum Cleaner Specialist or – Miele (see back cover for address). Warranty The appliance is guaranteed for a period of 2 years. For information on the appliance warranty specific to your country please contact Miele.
All work should be carried out by a suitably qualified and competent person in strict accordance with national and local safety regulations. The voltage connected load are given on the data plate located underneath the vacuum cleaner. Please ensure that these match the household mains supply.
Alteration rights reserved (S 2111 - S 2131) - 4810 M.-Nr. 09 037 420 / 00.
Een belangrijk punt na aankoop van elk apparaat Miele S 2131 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Miele S 2131 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Miele S 2131 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Miele S 2131 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Miele S 2131 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Miele S 2131 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Miele S 2131 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Miele S 2131 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
